Avoid common mistakes on your manuscript.
Correction to: Acta Metallurgica Sinica (English Letters) (2019) 32:253–262 https://doi.org/10.1007/s40195-018-0838-x
Error in Table
In the original publication [1], there was an error in the contents of Mn element and Cr element in Table 1. The corrected Table 1 appears below.
Text Correction
In the original publication [1], there was an error in the sentence of “The as-extrusion rods were kept in muffle furnace at 400 °C for 2 h to complete solid solution of Al 7075; the billets and die were preheated at 430 °C and then immediately extruded at 320 °C with an extrusion ratio 25:1 and an extrusion speed of 0.3, 0.7, 1.2 and 2.1 mm/s, respectively.”
A correction has been made to the “2.1 Fabrication of Mg/Al Composite Rod”, “Paragraph 1”:
“The billets were preheated at 400 °C for 2 h and then immediately extruded at 320 °C with an extrusion ratio 25:1 and an extrusion speed of 0.3, 0.7, 1.2 and 2.1 mm/s, respectively.”
The authors would like to apologize for any inconvenience caused.
Reference
Y. Chen, R. Zhang, T. Zhou, L. Hu, J. Tu, L.X. Shi, Y. Zhi, L.W. Lu, Q. Chen, B.H. Liao, L. Liu, Influence of extrusion speed on the microstructure evolution, interface bonding and mechanical response of Mg MB26/Al 7075 composite rod. Acta Metall. Sin. (Engl. Lett.) 32, 253–262 (2019)
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Chen, Y., Zhang, R., Zhou, T. et al. Correction to: Influence of Extrusion Speed on the Microstructure Evolution, Interface Bonding and Mechanical Response of Mg MB26/Al 7075 Composite Rod. Acta Metall. Sin. (Engl. Lett.) (2024). https://doi.org/10.1007/s40195-023-01646-0
Published:
DOI: https://doi.org/10.1007/s40195-023-01646-0