Use our pre-submission checklist
Avoid common mistakes on your manuscript.
1 Correction to: Progress in Additive Manufacturing https://doi.org/10.1007/s40964-020-00146-2
The publication of this article unfortunately contained a mistake. The name of the second author was wrong, correct it should be L. Expinosa Leal instead of E.L. Leonardo.
The original article has been corrected.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Gebrehiwot, S.Z., Espinosa-Leal, L., Eickhof, J.N. et al. Correction to: The influence of stiffener geometry on flexural properties of 3D-printed polylactic acid (PLA) beams. Prog Addit Manuf 5, 421 (2020). https://doi.org/10.1007/s40964-020-00149-z
Published:
Issue Date:
DOI: https://doi.org/10.1007/s40964-020-00149-z