Abstract
In this paper, we aimed to study the feasibility of using a piezoelectric harvester as a potential energy source to power microsystems, such as MicroElectroMechanical Systems (MEMSs) in wireless sensor networks (WSNs). An off-the-shelf piezoelectric bimorph was first tested to determine the power output under various resonant frequencies in the range of 42 to 103 Hz. The results showed that the piezoelectric bimorph generated greater power output at lower frequencies and higher accelerations, achieving an output of 3.072 mW from a vibrational source of 53 Hz and 1 g acceleration. The same system was also examined in response to low-level vibration source found in common environments, such as areas of residence, transportation and machinery to investigate the viability of its use in an environment with inconsistent vibrational frequency. Finally, a discussion is provided regarding the use of piezoelectric harvesters for WSNs and potential approaches to increase power output.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Abbreviations
- MEMS:
-
MicroElectroMechanical Systems
- VLSI:
-
Very Large-Scale Integration
- WSN:
-
Wireless Sensor Networks
- PZT:
-
Lead Zirconate Titanate
References
Chilugodu, N., Yoon, Y. J., Chua, K. S., Datta, D., Baek, J. D., Park, T., and Park, W. T., “Simulation of Train Induced Forced Wind Draft for Generating Electrical Power From Vertical Axis Wind Turbine (VAWT),” Int. J. Precis. Eng. Manuf., Vol. 13, No. 7, pp. 1177–1181, 2012.
Roundy, S., Wright, P. K., and Rabaey, J., “A study of low level vibrations as a power source for wireless sensor nodes,” Computer Communications, Vol. 26, No. 11, pp. 1131–1144, 2003.
Yick, J., Mukherjee, B., and Ghosal, D., “Wireless sensor network survey,” Computer Networks, Vol. 52, No. 12, pp. 2292–2330, 2008.
Chen, D., Nixon, M., Aneweer, T., Shepard, R., Burr, K., and Mok, A. K., “Wireless process control products from ISA 2004, International Workshop on Wireless and Industrial Automation, 2005.
Antoniou, M., Boon, M. C., Green, P. N., Green, P. R., and York, T. A., “Wireless sensor networks for industrial processes,” IEEE Sensors Applications Symposium, pp. 13–18, 2009.
Song, J., Mok, A. K., Chen, D., and Nixon, M., “Challenges of wireless control in process industry,” Workshop on Research Directions for Security and Networking in Critical Real-Time and Embedded Systems, 2006.
IEEE 1451, “A Standard Smart Transducer Interface,” Sensors Expo, 2001.
Correal, N. and Patwari, N., “Wireless Sensor Networks: Challenges and Opportunities,” MPRG/Virgina Tech Wireless Symposium on Wireless Personal Communication, 2001.
Nechibvute, A., Chawanda, A., and Luhanga, P., “Piezoelectric Energy Harvesting Devices: An Alternative Energy Source for Wireless Sensors,” Smart Materials Research, Vol. 2012.
Jiang, X., Polastre, J., and Culler, D., “Perpetual environmentally powered sensor networks,” Proc. of the 4th International Symposium on Information Processing in Sensor Networks, pp. 463–468, 2005.
Stephen, N. G., “On energy harvesting from ambient vibration, Journal of Sound and Vibration,” Vol. 293, No. 1–2, pp. 409–425, 2006.
Williams, C. B. and Yates R. B., “Analysis of a micro-electric generator for microsystems,” Senors and Actuators A: Physical, Vol. 52, No. 1–3, pp. 8–11, 1996.
Gilbert, J. M. and Balouchi, F., “Comparison of Energy Harvesting Systems for Wireless Sensor Networks,” International Journal of Automation and Computing, Vol. 5, No. 4, pp. 334–347, 2008.
Anton, S. R. and Sodano, H. A., “A review of power harvesting using piezoelectric materials (2003–2006),” Smart Materials and Structures, Vol. 16, No. 3, 2007.
Kong, N. A., Ha, D. S., Etrurk, A., and Inman, D. J., “Resistive Impedance Matching Circuit for Piezoelectric Energy Harvesting,” J. Intelligent Material Systems and Structures, Vol. 21, No. 13, pp. 1293–1302, 2010.
Liang, J. and Liao, W. H., “Impedance Matching for Improving Piezoelectric Energy Harvesting Systems,” Proc. of Active and Passive Smart Structures and Intelligent Systems, 2010.
Wu, W. J., Chen, Y. Y., Lee, B. S., He, J. J., and Pen, Y. T., “Tunable Resonant Frequency Power Harvesting Devices,” Proc. of Smart Structures and Materials: Damping and Isolation, 2006.
Badel, A., Guyomar, D., Lefeuvre, E., and Richard, C., “Piezoelectric Energy Harvesting using a Synchronized Switch Technique,” J. Intelligent Material Systems and Structures, Vol. 17, No. 8–9, pp. 831–839, 2006.
Kari, H. and Willing, A., “Wireless Sensor Networks,” Proc. of First European Workshop, 2004.
Liu, Y. M., Tian, G., Wang, Y., Lin, J. H., Zhang, Q. M., and Hofmann, H. F., “Active Piezoelectric Energy Harvesting: General Principle ad Experimental Demonstration,” Journal of Intelligent Material Systems and Structures, Vol. 20, No. 5, pp. 575–585, 2009.
Heidari, A., Yoon, Y. J., Son H. S., and Choi, H. J., “Simulation Based Design of Disk Resonator Based Biosensors under Fabrication Uncertainty,” Journal of Mechanical Design, Vol. 134, No. 4, Paper No. 041005, 2012.
Heidari, A., Yoon, Y. J., Lee, M. I., Khine, L., Park, M. K., and Tsai, J. M. L., “A novel checker-patterned AlN MEMS resonator as gravimetric sensor,” Sensor and Actuator A; Physical, Vol. 189, pp. 298–306, 2013.
Heidari, A., Yoon, Y. J., Park, M. K., Park, W. T., and Tsai, J. M. L., “High Sensitive Dielectric Filled Lame Mode Mass Sensor,” Sensor and Actuator A: Physical, Vol. 188, pp. 82–88, 2012.
Heidari, A., Yoon, Y. J., Park, W. T., and Tsai, J. M. L., “Developing High Sensitivity Biomass Sensor Using Lam Mode Square Resonator,” Advanced Materials Research, Vol. 254, pp. 46–49, 2011.
Heidari, A., Yoon, Y. J., and Choi, H. J., “Analysis and design of a high performance and low cost bio-mass sensor based on the radial contour mode disk resonator,” Microelectronic Engineering, Vol. 88, No. 8, pp. 1730–1732, 2011.
Abedinnasab, M. H., Yoon, Y. J., and Saeedi-Hosseiny, M. S., “High Performance Fuzzy-Pad Controllers: Introduction and Comparison to Fuzzy Controllers,” Nonlinear Dynamics, Vol. 71, No. 1–2, pp. 141–157, 2013.
Author information
Authors and Affiliations
Corresponding author
Additional information
Equal Contribution as first author
Rights and permissions
About this article
Cite this article
Yoon, YJ., Park, WT., Li, K.H.H. et al. A study of piezoelectric harvesters for low-level vibrations in wireless sensor networks. Int. J. Precis. Eng. Manuf. 14, 1257–1262 (2013). https://doi.org/10.1007/s12541-013-0171-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12541-013-0171-2