Abstract
The wind industry grew in the first decade of the 21st century at rates consistently above 20% a year. For wind turbine, gearbox failure can be extremely costly in terms of repair costs, replacement parts, and in lost power production due to downtime. For the gearbox used in wind turbine, gear transmission error (T.E.) is the excitation that leads the tonal noise known as gear whine, and radiated gear whine is also the dominant source of noise in the whole gearbox. In this paper, gear tooth micro-modification for the high speed stage was used to compensate for the deformation of the teeth due to load and to ensure a proper meshing to achieve an optimized tooth contact pattern. The gearbox was firstly modeled in Romaxdesigner software, and then the various combined tooth modification were presented, and the prediction of transmission under the loaded torque for the helical gear pair was investigated, the transmission error, transmission harmonics, normal load distribution were also obtained and compared before and after tooth modification under one torque. The simulation results showed that the transmission error and normal load distribution under the load can be minimized by the appropriate tooth modification. It is a good approach where the simulated result is used to improve the design before the prototype is available for the test.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
GWEC, “Global Wind 2007 Report,” Global Wind Energy Council, Belgium, 2007.
Germanischer Lloyd, “Guideline for the Certification of Wind Turbines,” Germanischer Lloyd WindEnergie GmbH., 2003.
ANSI/AGMA/AWEA 6006-A03, “Standard for Design and Specification of Gearboxes for Wind Turbines,” 2003.
Pears, J., Curtis, S., Poon, A., Smith, A., Poon, D., and Palmer, D., “Investigation of Methods to Predict Parallel and Epicyclic Gear Transmission Error,” SAE 2005 World Congress & Exhibition, Paper No. 2005-01-1818, 2005.
ISO 21771:2007, “Gears — Cylindrical involute gears and gear pairs-Concepts and geometry,” pp. 44–52.
Zhang, Q., Kang, J. H., Dong, W., and Lyu, S. K., “A Study on Tooth Modification and Radiation Noise of a Manual Transaxle,” Int. J. Precis. Eng. Manuf., Vol. 13, No. 6, pp. 1013–1020, 2012.
Romax Technology Ltd., “Romax Designer User Manual,” Nottingham, UK, 2003.
Cho, M. and Kim, C., “Dynamic Analyses of Fluctuating Bearing Forces on Worm Gears of Speed Reducers,” Int. J. Precis. Eng. Manuf., Vol. 13, No. 2, pp. 193–199, 2012.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Oh, S., Oh, S., Kang, J. et al. A study on modeling and optimization of tooth microgeometry for a helical gear pair. Int. J. Precis. Eng. Manuf. 14, 423–427 (2013). https://doi.org/10.1007/s12541-013-0058-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12541-013-0058-2