Abstract
Finite element models were established to analyze the influence of soft filler on stress concentration for a rectangular plate with an elliptic hole in the center. The influence was quantified by means of stress concentration factor (SCF). Seven shape factors of the elliptic hole and three levels of elasticity modulus of the soft filler were considered. The reduction coefficient and sensitivity index of SCF are the two indicators in evaluating the influence of soft filler. It was found that the reduction coefficient of SCF increases significantly as the shape factor and the elasticity modulus of the filler increase, indicating that soft filler can reduce the concentrated stress effectively, especially when the shape factor is great. Analysis for the sensitivity index of SCF indicates that SCF is more sensitive to materials with small elasticity modulus than to materials with large one.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Dai Longchao, Guo Wanlin, Wang X. Stress concentration at an elliptic hole in transversely isotropic piezoelectric solids [J]. International Journal of Solids and Structures, 2006, 43(6): 1818–1831.
Dumir P C. Stress concentration around elliptical holes in a rectangular plate [J]. Arabian Journal for Science and Engineering, 1988, 13(1): 109–112.
Hanus J B, Burger C P. Stress-concentration factors for elliptical holes near an edge [J]. Experimental Mechanics, 1981, 21(9): 336–340.
Kubair D V, Bhanu-Chandar B. Stress concentration factor due to a circular hole in functionally graded panels under uniaxial tension [J]. International Journal of Mechanical Sciences, 2008, 50(4): 732–742.
Bakhshandeh K, Rajabi I. Orthotropy and geometry effects on stress concentration factors for short rectangular plates with a centred circular opening[J]. Journal of Strain Analysis for Engineering Design, 2007, 42(7): 551–556.
Simha K R Y, Mohapatra S S. Stress concentration around irregular holes using complex variable method [J]. Sadhana, 1998, 23(4): 393–412.
Babu R N, Ramana K V, Rao K M. Determination of stress concentration factors of a steam turbine rotor by FEA [J]. Proceedings of World Academy of Science, Engineering and Technology, 2008, 39: 302–306.
Yang Linhu, Zhu Han, Liu Chunsheng. Two-dimensional analysis of the influence of soft material on stress field around an elliptic hole [J]. Journal of Tianjin University, 2010, 43(7): 601–605 (in Chinese).
Turatsinze A, Garros M. On the modulus of elasticity and strain capacity of self-compacting concrete incorporating rubber aggregates [J]. Resources, Conservation and Recycling, 2008, 52(10): 1209–1215.
Saven Γ H. Stress Concentration Around Holes [M]. Lu Dinghuo trans. Science Press, Beijing, China, 1958 (in Chinese).
Author information
Authors and Affiliations
Corresponding author
Additional information
Supported by National Natural Science Foundation of China (No. 50878142).
YANG Linhu, born in 1981, male, Dr.
Rights and permissions
About this article
Cite this article
Yang, L., Zhu, H. & Tan, D. Influence of soft filler on stress concentration factor of elliptic holes in a rectangular plate. Trans. Tianjin Univ. 18, 117–120 (2012). https://doi.org/10.1007/s12209-012-1614-z
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12209-012-1614-z