Abstract
The efficiency of an evacuated tube solar collector was experimentally measured and analyzed according to the size of CuO nanoparticle and the concentration of the CuO nanofluid. In addition, the efficiency of the evacuated tube solar collector using CuO nanofluid as a working fluid was compared with that when water was used. As a result, the efficiency of the evacuated tube solar collector improved as the concentration of the CuO nanofluid increased at low concentration. Further, the efficiency of the evacuated tube solar collector was higher at a mass flux rate of 598 kg/s·m2 than at 420 kg/s·m2. The highest efficiency of the solar collector with 40 nm-CuO nanofluid was 69.1 %, an improvement of 2.0 % compared to 80 nm-CuO nanofluid. The most optimal concentration of the 40 nm-CuO nanofluid was 0.5 vol% and an improvement of thermal efficiency was 7.2 % compared to water. In addition, at this concentration, the efficiency improved by 4.4 %, 2.3 % and 0.3 % compared to that at concentrations of 0.1 vol%, 0.3 vol% and 0.7 vol%, respectively. The use of CuO nanofluid in the evacuated tube solar collector can improve the efficiency and can maintain the high efficiency for wide operating conditions compared to water.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
T. O. Ahmadu, C. O. Folayan and F. O. Anafi, Modeling, simulation and optimization of a solar absorption air conditioning system for an office block in Zaria, Nigeria, International Journal of Air-Conditioning and Refrigeration, 24 (2016).
S. Khaldi, A. I. N. Korti and S. Abboudi, Improving the airflow distribution within an indirect solar dryer by modifications based on computational fluid dynamics, International Journal of Air-Conditioning and Refrigeration, 25 (2017).
H. W. Chiam, W. H. Azmi, N. A. Usri, R. Mamat and N. M. Adam, Thermal conductivity and viscosity of Al2O3 nanofluids for different based ratio of water and ethylene glycol mixture, Experimental Thermal and Fluid Science, 81 (2017) 420–429
L. S. Sundar, M. H. Farooky, S. N. Sarada and M. K. Singh, Experimental thermal conductivity of ethylene glycol and water mixture based low volume concentration of Al2O3 and CuO nanofluids, International Communications in Heat and Mass Transfer, 41 (2013) 41–46
A. A. Charab, S. Movahedirad and R. Norouzbeigi, Thermal conductivity of Al2O3+TiO2/water nanofluid: Model development and experimental validation, Applied Thermal Engineering, 119 (2017) 42–51
M. I. Pryazhnikov, A. V. Minakov, V. Y. Rudyak and D. V. Guzei, Thermal conductivity measurements of nanofluids, International Journal of Heat and Mass Transfer, 104 (2017) 1275–1282
H. G. P. M. B. Kim and C. Y. Park, Change of thermal conductivity and cooling performance for water based Al2O3-surfactant nanofluid with time lapse, International Journal of Air-Conditioning and Refrigeration, 26 (2018).
A. Noghrehabadi, E. Hajidavaloo and M. Moravej, Experimental investigation of efficiency of square flat-plate solar collector using SiO2/water nanofluid, Case Studies in Thermal Engineering, 8 (2016) 378–386
Q. He, S. Zeng and S. Wang, Experimental investigation on the efficiency of flat-plate solar collectors with nanofluids, Applied Thermal Engineering, 88 (2015) 165–171
S. K. Verma, A. K. Tiwari and D. S. Chauhan, Experimental evaluation of flat plate solar collector using nanofluids, Energy Conversion and Management, 134 (2017) 103–115
A. J. Moghadam, M. Farzane-Gord, M. Sajadi and M. Hoseyn-Zadeh, Effects of CuO/water nanofluid on the efficiency of a flat-plate solar collector, Experimental Thermal and Fluid Science, 58 (2014) 9–14
Z. Said, M. A. Sabiha, R. Saidur, A. Hepbasli, N. A. Rahim, S. Mekhilef and T. A. Ward, Performance enhancement of a flat plate solar collector using Titanium dioxide nanofluid and Polyethylene Glycol dispersant, Journal of Cleaner Production, 92 (2015) 343–353
Z. Said, R. Saidur and N. A. Rahim, Energy and exergy analysis of a flat plate solar collector using different sizes of aluminium oxide based nanofluid, Journal of Cleaner Production, 133 (2016) 518–530
T. Yousefi, E. Shojaeizadeh, F. Veysi and S. Zinadini, An experimental investigation on the effect of pH variation of MWCNT–H2O nanofluid on the efficiency of a flat-plate solar collector, Solar Energy, 86 (2012) 771–779
M. Faizal, R. Saidur, S. Mekhilef and M. A. Alim, Energy, economic and environmental analysis of metal oxides nanofluid for flat-plate solar collector, Energy Conversion and Management, 76 (2013) 162–168
L. Lu, Z.-H. Liu and H.-S. Xiao, Thermal performance of an open thermosyphon using nanofluids for hightemperature evacuated tubular solar collectors, Solar Energy, 85 (2011) 379–387
Z.-H. Liu, R.-L. Hu, L. Lu, F. Zhao and H.-s. Xiao, Thermal performance of an open thermosyphon using nanofluid for evacuated tubular high temperature air solar collector, Energy Conversion and Management, 73 (2013) 135–143
R. Rybár, M. Beer and M. Cehlár, Thermal power measurement of the novel evacuated tube solar collector and conventional solar collector during simultaneous operation, Measurement, 88 (2016) 153–164
J. Ghaderian and N. A. C. Sidik, An experimental investigation on the effect of Al2O3/distilled water nanofluid on the energy efficiency of evacuated tube solar collector, International Journal of Heat and Mass Transfer, 108 (2017) 972–987
M. Mahendran, G. C. Lee, K. V. Sharma and A. Shahrani, Performance of evacuated tube solar collector using waterbased titanium oxide nanofluid, Journal of Mechanical Engineering and Sciences, 3 (2012) 301–310
M. A. Sabiha, R. Saidur, S. Hassani, Z. Said and S. Mekhilef, Energy performance of an evacuated tube solar collector using single walled carbon nanotubes nanofluids, Energy Conversion and Management, 105 (2015) 1377–1388
H. Kim, J. Ham, C. Park and H. Cho, Theoretical investigation of the efficiency of a U-tube solar collector using various nanofluids, Energy, 94 (2016) 497–507
H. Kim, J. Kim and H. Cho, Experimental study on performance improvement of U-tube solar collector depending on nanoparticle size and concentration of Al2O3 nanofluid, Energy, 118 (2017) 1304–1312
H. Kim, J. Kim and H. Cho, Review of thermal performance and efficiency in evacuated tube solar collector with various nanofluids, International Journal of Air-Conditioning and Refrigeration, 25 (2017).
M. A. Ersöz, Effects of different working fluid use on the energy and exergy performance for evacuated tube solar collector with thermosyphon heat pipe, Renewable Energy, 96 (2016) 244–256
Q. J. Hashim, A. Hussain and K. F. Sultan, Experimental analysis on thermal efficiency of evacuated tube solar collector by using nanofluids, International Journal of Sustainable and Green Energy, 4 (2015) 19–28
Moffat, Using uncertainty analysis in the planning of an experiment, Fluids Engineering, 107 (1985) 173–182
J. Ghaderian, N. A. C. Sidik, A. Kasaeian, S. Ghaderian, A. Okhovat, A. Pakzadeh, S. Samion and W. J. Yahya, Performance of copper oxide/distilled water nanofluid in evacuated tube solar collector (ETSC) water heater with internal coil under thermosyphon system circulations, Applied Thermal Engineering, 121 (2017) 520–536
Author information
Authors and Affiliations
Corresponding author
Additional information
Recommended by Associate Editor Chang Yong Park
Woobin Kang is M.S. student of mechanical engineering, Chosun University. His research interest includes the improvement of solar collector performance using nanofluids, and its applications in heat transfer area.
Yunchan Shin is a Ph.D. candidate of mechanical engineering, Chosun University. His research interest includes the performance improvement of solar collector, thermal comfort in automobile air-conditioning system, and the performance improvement in the HVAC system et al.
Honghyun Cho is a Professor in School of Mechanical Engineering, Chosun University. He received Ph.D. from Korea University in 2005. His research interest includes the heat pump system with renewable energy, alternative refrigerant HVAC system, heat and mass transfer in the heat exchanger, pool boiling using nanofluids, etc.
Rights and permissions
About this article
Cite this article
Kang, W., Shin, Y. & Cho, H. Experimental investigation on the heat transfer performance of evacuated tube solar collector using CuO nanofluid and water. J Mech Sci Technol 33, 1477–1485 (2019). https://doi.org/10.1007/s12206-019-0249-6
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-019-0249-6