Abstract
In this numerical study, the variation of wake patterns and force coefficients of the flow past four square bodies aligned inline are investigated. A two-dimensional numerical code is developed using the Lattice Boltzmann method (LBM) for this study. The code is first validated for the flow past a single and two tandem square cylinders. The results are compared to those available in literature and found to be in good agreement. After validation the calculations are further performed to investigate the effect of gap spacing (g) for the flow past four inline square cylinders at two different Reynolds numbers (Re) 100 and 200. The gap spacing is chosen in the range 0.25 ≤ g ≤ 7. Six different flow patterns: Single slender body, alternate reattachment, quasi steady reattachment, intermittent shedding, chaotic flow and periodic flow are found in this study with successive increment in spacing. It is found that some flow patterns existing at Re = 100 do not exist at Re = 200. The generated vortices at Re = 200 are much stronger as compared to those at Re = 100. The spacing value g = 3 is found to be critical at Re = 100 while at Re = 200 the spacing value g = 2 is critical due to abrupt changes in flow characteristics. At some spacing values the downstream cylinders have higher values of average drag coefficients as compared to upstream ones. In general the upstream cylinder (c1) have higher drag forces at Re = 200 than at Re = 100. The root mean square values of lift coefficient are found to be greater than the corresponding root mean square values of drag coefficient.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
M. M. Zdravkovich, The effects of interference between circular cylinders in cross flow, Journal of Fluids and Structures, 1 (1987) 239–261.
W. C. L. Shih, C. Wang, D. Coles and A. Roshko, Experiments on flow past rough circular cylinders at large Reynolds numbers, Journal of Wind Engineering and Industrial Aerodynamics, 49 (1993) 351–368.
H. J. Niemann and N. Holscher, A review of recent experiments on the flow past circular cylinders, Journal of Wind Engineering and Industrial Aerodynamics, 33 (1990) 197–209.
S. Manzoor, J. Khawar and N. A. Sheikh, Vortex-induced vibrations of a square cylinder with damped free-end conditions, Advances in Mechanical Engineering (2013) 1–12.
R. Franke, W. Rodi and B. Schonung, Numerical calculation of laminar vortex-shedding flow past cylinders, Journal of Wind Engineering and Industrial Aerodynamics, 35 (1990) 237–257.
A. k. Saha, k. Muralidhar and G. Biswas, Transition and chaos in two-dimensional flow past a square cylinder, Journal of Engineering Mechanics, 126 (2000) 523–532.
M. Cheng, D. S. Whyte and J. Lou, Numerical simulation of flow around a square cylinder in uniform-shear flow, Journal of Fluids and Structures, 23 (2007) 207–226.
S. Dutta, P. K. Panigrahi and K. Muralidhar, Experimental investigation of flow past a Square cylinder at an angle of incidence, Journal of Engineering Mechanics, 134 (2008) 788–803.
A. Sohankar, L. Davidson and C. Norberg, Numerical simulation of unsteady flow around a square two-dimensional cylinder, Twelfth Australian Fluid Mechanics Conference, The University of Sydney, Australia (1995) 517–520.
N. Mahir, Three-dimensional flow around a square cylinder near a wall, Ocean Engineering, 36 (2009) 357–367.
G. Xu and Y. Zhou, Strouhal numbers in the wake of two inline cylinders, Experiments in Fluids, 37 (2004) 248–256.
M. K. Kim, D. K. Kim, S. H. Yoon and D. H. Lee, Measurements of the flow fields around two square cylinders in a tandem arrangement, Journal of Mechanical Science and Technology, 22 (2008) 397–407.
A. Lankadasu and S. Vengadesan, Interference effect of two equal-sized square cylinders in tandem arrangement: With planar shear flow, International Journal for Numerical Methods in Fluids, 57 (2007) 1005–1021.
A. Sohankar, A numerical investigation of the flow over a pair of identical square cylinders in a tandem arrangement, International Journal for Numerical Methods in Fluids, 70 (2011) 1244–1257.
P. P. Patil and S. Tiwari, Numerical investigation of laminar unsteady wakes behind two inline square cylinders confined in a channel, Engineering Applications of Computational Fluid Mechanics, 3 (2009) 369–385.
J. R. Meneghini, F. Saltara, C. L. R. Siqueira and J. A. Ferrari, Numerical simulation of flow interference between two circular cylinders in tandem and side-by-side arrangements, Journal of Fluids and Structures, 15 (2001) 327–350.
D. B. Ghadiri, M. H. Sarvghad and J. H. Houri, Numerical simulation of flow over two circular cylinders in tandem arrangement, Journal of Hydrodynamics, 23 (2011) 114–126.
A. Sohankar, A LES study of the flow interference between tandem square cylinder pairs, Theoratical and Computational Fluid Dynamics, 28 (2014) 531–548.
O. Inoue, M. Mori and N. Hatakeyama, Aeolian tones radiated from flow past two square cylinders in tandem, Physics of Fluids, 18 (2006) 1–15.
C. K. Vikram, Y. T. Krishne, H. V. Ravindra and C. J. Gangadara, Manu, Numerical simulation of two dimensional unsteady flow past two square cylinders, International Journal of Technology And Engineering System, 2 (2011) 355–360.
T. Igarashi and K. Suzuki, Characteristics of the flow around three circular cylinders arranged in line, Bulletin of JSME, 27 (1984) 2397–2404.
A. B. Harichandan and A. Roy, Numerical investigation of low Reynolds number flow past two and three circular cylinders using unstructured grid CFR scheme, International Journal of Heat and Fluid Flow, 31 (2010) 154–171.
A. R. Vasel-Be-Hagh, D. Ting and R. Carriveau, Correlating flow pattern with force coefficients in air flow past a tandem unit of three circular cylinders, International Journal of Fluid Mechanics Research, 40 (2013) 235–253.
S. U. Islam, W. S. Abbasi, H. Rahman and R. Naheed, Numerical investigation of wake modes for flow past three tandem cylinders using the multi-relaxation-time lattice Boltzmann method for different gap spacings, Journal of the Brazilian Society of Mechanical Sciences and Engineering, DOI 10.1007/s40430-014-0282-4.
Y. Bao, Q. Wu and D. Zhou, Numerical investigation of flow around an inline square cylinder array with different spacing ratios, Computers & Fluids, 55 (2012) 118–131.
C. M. Sewatkar, R. Patel, A. Sharma and A. Agrawal, Flow around six in-line square cylinders, Journal of Fluid Mechanics, 710 (2012) 195–233.
S. Chen and G. Doolen, Lattice Boltzmann method for fluid flows, Annual Review of Fluid Mechanics, 30 (1998) 329-364.
P. Lallemand and L. S. Luo, Theory of the lattice Boltzmann method: Acoustic and thermal properties in two and three dimensions, Physical Review E, 68 3 (2003) 036706.
G. M. Kremer, An introduction to the Boltzmann equation and transport processes in gases, Springer (2010).
Z. Guo, H. Liu, L. Luo and K. Xu, Comparative study of the LBE and GKS methods for 2D near incompressible laminar flows, Journal of Computational Physics, 227 (2008) 4955–4976.
D. Yu, M. Renwei, L. S. Luo and S. Wei, Viscous flow computations with the method of lattice Boltzmann equation, Progress in Aerospace Sciences, 39 (2003) 329–367.
A. Okajima, Strouhal numbers of rectangular cylinders, Journal of Fluid Mechanics, 123 (1982) 379–398.
C. Norberg, Flow around rectangular cylinders: Pressure forces and wake frequencies, Journal of Wind Engineering and Industrial Aerodynamics, 49 (1993) 187–196.
A. S. Abograis and A. E. Alshayji, Reduction of fluid forces on a square cylinder in a laminar flow using passive control methods, COMSOL Conference, Boston, USA (2013).
W. S. Abbasi, S. Ul. Islam, S. C. Saha, Y. T. Gu and C. Y. Zhou, Effect of Reynolds numbers on flow past four square cylinders in an in-line square configuration for different gap spacings, Journal of Mechanical Science and Technology, 28 2 (2014) 539–552.
H. R. Kim, M. Ha, H. S. Yoon and S. W. Son, Dynamic behavior of a droplet on a moving wall, Journal of Mechanical Science and Technology, 28 5 (2014) 1709–1720.
J. Bang and W. Yoon, Stochastic analysis of a collection process of submission particles on a single fiber accounting for the changes in flow field due to particle collection, Journal of Mechanical Science and Technology, 28 9 (2014) 3719–3732.
N. Jeong, Rarefied gas flow simulation with TMAC in the slip and the transition flow regime using the lattice Boltzmann method, Journal of Mechanical Science and Technology, 28 11 (2014) 4705–4715.
S. Ul. Islam, H. Rahman, W. S. Abbasi, U. Noreen and A. Khan, Suppression of fluid force on flow past a square cylinder with a detached flat plate at low Reynolds number for various spacing ratios, Journal of Mechanical Science and Technology, 28 12 (2014) 4969–4978.
M. Jourabian and M. Farhadi, Melting of nanoparticlesenhanced phase change material (NEPCM) in vertical semicircle enclosure: numerical study, Journal of Mechanical Science and Technology, 29 9 (2015) 3819–3830.
S. Ul. Islam, C. Y. Zhou, A. Shah and P. Xie, Numerical simulation of flow past rectangular cylinders with different aspect ratios using the incompressible lattice Boltzmann method, Journal of Mechanical Science and Technology, 26 4 (2012) 1027–1041.
Author information
Authors and Affiliations
Corresponding author
Additional information
Shams-ul-Islam is currently a assistant professor in Mathematics Department COMSATS Institute of Information, Technology, Islamabad. He received his Ph.D. in 2010. His research interests include, fluid structure interaction, drag reduction of bluff body and heat and mass transfer.
Rights and permissions
About this article
Cite this article
Manzoor, R., Shams-ul-Islam, Abbasi, W. et al. Variation of wake patterns and force coefficients of the flow past square bodies aligned inline. J Mech Sci Technol 30, 1691–1704 (2016). https://doi.org/10.1007/s12206-016-0325-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-016-0325-0