Abstract
The effect of cold rolling condition on magnetic properties of non-oriented electrical steel was investigated. For evaluation of cold roiling condition, utilizing rolling shape factor (RSF) was proposed. In the case of small RSF, magnetic induction was improved. Development of ND ∥ <111< components was suppressed in the recrystallized texture near the surface, and the vicinity of the {100}<001> component was developed after grain growth. The relation between RSF and cold-rolling condition was examined by computer simulation; such results were attributed to the increment of shear strain in the surface texture. Magnetic properties would be improved by adequate control of cold-rolling condition.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
K. Honda and S. Kaya, sci. Rep. Tohoku Univ., Vol 15, 1926, p 721
H.J. Williams, Phys. Rev., Vol 52, 1937, p 747
T. Senuma, H. Yada, G. Matsumura, and K. Yamada, Tetsu-to-Hagané, Vol 73, 1987, p 1598–1605
P.J. Regenet and H.P. Stuwe, Z. Metallkd., Vol 54, 1963, p 273
I.L. Dillamore and W.T. Roberts, J. Inst. Met., Vol 92, 1963/64, p193
H. Murakami, Y. Huruno, and T. Kawano, CAMP-ISIJ, Vol 5, 1992, p 902
M. Matsuo, S. Hayami, and S. Nagashima, Proc. Int. Conf. on the Science and Technology of Iron and Steel, Trans. ISIJ, Part II, 1971, p 867
M. Abe, Y. Kokabu, Y. Hayshi, and S. Hayami, J. Jpn. Inst. Met., Vol 44, 1980, p 84–94
K. Ueno, I. Tachino, and T. Kubota, Metallurgy of Vacuum-De-gassed Steel Products, R. Pradhan, Ed., The Minerals, Metals and Materials Society, PA, 1990
H.J. Bunge, Texture Analysis in Materials Science, Butterworths, London, 1982
I. Tachino, Tetsu-to-Hagané, Vol 81,1990, p 81–88
N. Okumura, T. Kubota, M. Nagumo, J. Hada, and A. Saito, Proc. Int. Conf. on Steel Rolling, Part I, Iron and Steel Institute of Japan, Tokyo, 1980, p 217–228
K. Yamada, S. Ogawa, and M. Ataka, Proc. Fourth Int. Conf. on Numerical Methods in Industrial Forming Processes, Balkema, Rotterdam, 1992, p 755
H.J. Bunge, Z. Metallkd., Vol 56, 1965, p 378, 872
T. Urabe and J.J. Jonas, ISIJ Int., Vol 34, 1994, p 435–442
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Kawamata, R., Kubota, T. & Yamada, K. The effect of cold rolling parameters on the recrystallization texture of non-oriented electrical steel. J. of Materi Eng and Perform 6, 701–709 (1997). https://doi.org/10.1007/s11665-997-0069-1
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11665-997-0069-1