Abstract
The main reaction products were investigated by analysis of microstructure of alkali-activated ground granulated blast furnace slag (GGBFS) paste. An experimental research was performed on bond performance of alkali-activated GGBFS paste as a construction adhesive after exposure to 20–500 °C. Through XRD analysis, a few calcium silicate hydrate, hydrotalcite and tetracalcium aluminate hydrate were determined as end products, and they were filled and packed each other at room temperature. In addition, akermanite dramatically increased at 800 °C and above. The two key parameters, the ultimate load P u.T and effective bond length L e, were determined using test data of carbon fiber-reinforced polymer (CFRP)-to-concrete bonded joints at elevated temperature. The experimental results indicate that the ultimate load P u.T remains relatively stable initially and then decreases with increasing temperature. The effective bond length L e increases with increasing temperature except at 300 °C. The proposed temperature-dependent effective bond length formula is shown to closely represent the test data.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Shi CJ, Krivenko PV, Roy DM. Alkali-activated Cements and Concretes[M]. London; Taylor & Francis, 2006
Luo X, Xu JY, Bai EL, et al. Systematic Study on the Basic Characteristics of Alkali-activated Slag-fly Ash Cementitious Material System[J]. Construction and Building Materials, 2012, 29: 482–486
Roy DM, Jiang WM, Silsbee MR. Chloride Diffusion in Ordinary, Blended, and Alkali-activated Cement Pastes and Its Relation to Other Properties[J]. Cement and Concrete Research, 2000, 30(12): 1 879–1 884
Guo WY, Wu GL, Wang JD, et al. Preparation and Performance of Geopolymers[J]. Journal of Wuhan University of Technology-Mater. Sci. Ed., 2008, 23(3): 326–330
Bobrowski A, Gawlicki M, Malolepszy J. Analytical Evaluation of Immobilization of Heavy Metals in Cement Matrices[J]. Environmental Science & Technology, 1997, 31(3): 745–749
Shi CJ, Fernandez-Jimenez A. Stabilization/Solidification of Hazardous and Radioactive Wastes with Alkali Activated Cements[J]. Journal of Hazardous Materials B, 2006, 137(3): 1 656–1 663
Barbosa VFF, MacKenzie KJD. Thermal Behaviour of Inorganic Geopolymers and Composites Derived from Sodium Polysialate[J]. Materials Research Bulletin, 2003, 38(2): 319–331
Roy DM. Alkali-Activated Cements Opportunities and Challenges[J]. Cement and Concrete Research, 1999, 29(2): 249–254
Bakharev T. Durability of Geopolymer Materials in Sodium and Magnesium Sulfate Solutions[J]. Cement and Concrete Research, 2005, 35(6): 1 233–1 246
Richardson IG, Brough AR, Groves GW, et al. The Characterization of Hardened Alkali-activated Blast-furnace Slag Pastes and Nature of the Calcium Silicate Hydrate (C-S-H) Phase[J]. Cement and Concrete Research, 1994, 24(5): 813–829
Davidovits J. Geopolymers Inorganic Polymeric New Materials[J]. Journal of Thermal Analysis and Calorimetry, 1991, 37(8): 1 633–1 656
Muniz-Villarreal MS, Manzano-Ramirez A, Sampieri-Bulbarela S, et al. The Effect of Temperature on the Geopolymerization Process of a Metakaolin-based Geopolymer[J]. Materials Letters, 2011, 65(6): 995–998
Zuda L, Rovnanik P, Bayer P, et al. Thermal Properties of Alkali-Activated Slag Subjected to High Temperatures[J]. Journal of Building Physics, 2007, 30(4): 337–350
ACI 440.2R-08. Guide for the Design and Construction of Externally Bonded FRP Systems for Strengthening Concrete Structures[S]. Committee 440, USA, 2008
Chen JF, Teng J. Anchorage Strength Models for FRP and Steel Plates Bonded to Concrete[J]. Journal of Structural Engineering, 2001, 127(7): 784–791
Teng JG, Chen JF, Smith ST, et al. FRP-Strengthened RC Structures [M]. Chichester; John Wiley and Sons, 2002
Dai JG, Gao WY, Teng JG. Bond-slip Model for FRP Laminates Externally Bonded to Concrete at Elevated Temperature [EB/OL]. http://dx.doi.org/10.1061/(ASCE)CC.1943-5614.0000337
Author information
Authors and Affiliations
Corresponding author
Additional information
Funded by the National Natural Science Foundation of China(50178026), and the Cheung Kong Scholars Program Foundation of Chinese Ministry of Education(2009-37)
Rights and permissions
About this article
Cite this article
Zheng, W., Zhu, J. The effect of elevated temperature on bond performance of alkali-activated GGBFS paste. J. Wuhan Univ. Technol.-Mat. Sci. Edit. 28, 721–725 (2013). https://doi.org/10.1007/s11595-013-0759-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11595-013-0759-5