Abstract
The causes for the saturation of both the continuous-wave and the pulsed output power of broad-area laser diodes driven at very high currents are investigated experimentally and theoretically. The decrease of the gain due to self-heating under continuous-wave operation and spectral holeburning under pulsed operation as well as hetero-barrier carrier leakage and longitudinal spatial holeburning are the dominant mechanisms limiting the maximum achievable output power.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Adachi S.: Gaas, AlAs, AlGaAs: material parameters for use in research and device applications. J. Appl. Phys. 58(3), R1–R29 (1985)
Adachi, S. (eds): Properties of Aluminium Gallium Arsenide. IET, Exeter (1993)
Bandelow U., Gajewski H., Hünlich R.: Fabry-Perot lasers: thermodynamics-based modeling. In: Piprek, J. (eds) Optoelectronic Devices—Advanced Simulation and Analysis, pp. 63–85. Springer, New York (2005)
Bhattacharya, P. (eds): Properties of Lattice-Matched and Strained Indium Gallium Arsenide. IET, Exeter (1993)
Bugge F., Zeimer U., Staske R., Sumpf B., Erbert G., Weyers M.: MOVPE growth optimization for laser diodes with highly strained InGaAs MQWs. J. Cryst. Growth 298, 652–657 (2007)
Crump P., Blume G., Paschke K., Staske R., Pietrzak A., Zeimer U., Einfeldt S., Ginolas A., Bugge F., Häusler K., Ressel P., Wenzel H., Erbert G.: 20W continuous wave reliable operation of 980nm broad-area single emitter diode lasers with an aperture of 96μm. Proc. SPIE 7198, 719,814 (2009)
Erbert G., Bugge F., Eppich B., Fricke J., Hasler K.H., Paschke K., Pietrzak A., Wenzel H., Tränkle G.: High brightness diode lasers with very narrow vertical divergence. Proc. SPIE 6909, 69,090P (2008)
Guden M., Piprek J.: Material parameters of quaternary III–V semiconductors for multilayer mirrors at 1.55 μm wavelength. Modelling Simul. Mater. Sci. Eng. 4, 349–357 (1996)
Madelung, O. (eds): Semiconductors-Basic Data. Springer, Berlin (1996)
Pietrzak A., Crump P., Wenzel H., Staske R., Erbert G., Tränkle G.: 55 W peak power from 1,100 nm wavelength 60 μm broad-area laser diodes enabled by reduced carrier accumulation in the waveguide. Semicond. Sci. Technol. 24, 035,020 (2009)
Ressel P., Erbert G., Zeimer U., Häusler K., Beister G., Sumpf B., Klehr A., Tränkle G.: Novel passivation process for the mirror facets of Al-free active-region high-power semiconductor diode lasers. IEEE Photon Techn. Lett. 17, 962–964 (2005)
Slipchenko S.O., Sokolova Z.N., Pikhtin N.A., Borschev K.S., Vinokurov D.A., Tarasov I.S.: Finite time of carrier energy relaxation as a cause of optical-power limitation in semiconductor lasers. Semiconductors 40, 990 (2006)
van de Walle C.G.: Band lineups and deformation potentials in the model-solid theory. Phys. Rev. B 39(3), 1871–1883 (1989)
Wang J., Schweizer H.: A quantitative comparison of the classical rate-equation model with the carrier heating model on dynamics of the quantum-well laser. IEEE J. Quantum Electron 33, 1350–1358 (1997)
Wenzel H., Erbert G.: Simulation of single-mode high-power semiconductor lasers. Proc. SPIE 2693, 418 (1996)
Wünsche H., Bandelow U., Wenzel H.: Calculation of combined lateral and longitudinal spatial hole burning in λ/4 shifted DFB lasers. IEEE J. Quantum Electron 17, 1751–1760 (1993)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Wenzel, H., Crump, P., Pietrzak, A. et al. The analysis of factors limiting the maximum output power of broad-area laser diodes. Opt Quant Electron 41, 645–652 (2009). https://doi.org/10.1007/s11082-010-9372-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11082-010-9372-4