Abstract
Many overview papers have been published with recommended nuclear data for use in the k 0 method of NAA and made available in scientific journals or in the form of a downloadable database. In September 2009, the k 0-International Scientific Committee formed the k 0-Nuclear Data Committee (k 0-NDC) whose first task was to collect all these data at a single place to facilitate updating and to correct any evident errors. This task of the k 0-NDC was successfully completed in March 2012 when the 2012 recommended k 0 database was published in the form of an Excel file.
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Introduction
As is well-known, the k 0 standardisation method of neutron activation analysis (k 0-NAA) was introduced by Simonits et al. [1], whereby absolute nuclear data were replaced by k 0 factors, which were experimentally determined. Compared to the relative method, the k 0 method greatly reduces the need for the preparation of standards. It uses gold as the standard and composite nuclear constants for analytically interesting nuclides are normalised to gold nuclear data. During the last 30 years the k 0 method has been introduced in many laboratories around the world for multi-element NAA and the method is continuously improving, along with its nuclear data [2–7]. In 2003, these data were made available by the International Union of Pure and Applied Chemistry (IUPAC) in the form of the Access database (http://www.iupac.org/home/projects/project-db/project-details.html?tx_wfqbe_pi1%5Bproject_nr%5D=2001-075-1-500) created by Kolotov and De Corte [8, 9]. In the process of validation of the consistency of the nuclear data inside the k0_IAEA software with the IUPAC k 0 database, several inconsistencies were investigated by Blaauw and De Corte [10] in 2009 and published in 2010.
During the 5th International k 0 Users’ Workshop in September 2009, Belo Horizonte, Brazil, the k 0-Nuclear Data Committee (k 0-NDC) was formed by the k 0-International Scientific Committee (k 0-ISC). The k 0-NDC is responsible for reviewing all new developments in the nuclear data used with the k 0 method of NAA, which includes ensuring the consistency in the k 0 database. The latter task was successfully fulfilled in March 2012 when the 2012 recommended k 0 database was published in the form of an Excel file (see weblink: http://www.kayzero.com/k0naa/k0naa/News/News.html) dated 2012-03-14.
Results and discussion
The 2012 recommended k 0 database is based on the data published in Refs. [2–10]. The values, references and comments have been verified carefully and corrected where typographical errors, data-handling (e.g. rounding) errors, inconsistencies, or other mistakes were found. All questionable data were discussed one by one, and were modified after a common agreement. All modifications to the data and the rationale behind the modification are traceable in the above mentioned Excel-sheet.
In this work, the Access version of the IUPAC database [9] has been converted into an Excel file. The obvious rounding errors (smaller than 0.1 %) were corrected and the all k 0 factors are written in the scientific format. Thus the values listed in the tables contain the proper number of significant digits. The present k 0 database can be opened in the 2003 version of Excel, and it contains the following worksheets:
k 0
This sheet summarizes the k 0 values. It lists the elements, their isotopes and the gamma-ray energies together with the k 0 values and their uncertainties. In further columns it is also indicated if the value is affected by true coincidence summing or is derived from summing a multiplet. The revision dates and the relevant references are also shown (see Table 1).
Capture
This sheet lists the neutron capture cross-sections, the resonance integrals (RI) and the ratios of the two (Q 0), as well as the effective resonance energies (E r) for the nuclides appearing in the k 0 table (see Table 2).
Decay
Here, the decay modes of the radioactive nuclides formed during the activation can be found: either β decays or isomeric transitions. The branching ratios between β decays and isomeric transitions also appear in this sheet (see “Decay” sheet in the Excel file).
Nuclides
The properties of the target and product nuclides can be seen in this sheet. The target nuclides are stable and their isotopic abundances are given, while the products are radioactive and their half-lives are shown in the traditional units (see Table 3).
Decay codes
Most decays are type I, where the radioactive state decays directly to the very-short-lived gamma-emitting state. Decays through several steps have the codes from II to VII, which can be seen here (see “decay code (ng)” and “decay code (nf)” in the Excel file).
There are two sheets, which contain the most important k 0 and decay code data for nuclides produced by the neutron-induced fission of uranium (see Table 4).
The last three sheets resolve abbreviations and codes used in the database (see “S”, “RA Decay” and “Reac” sheets in the Excel file).
In this work, changes were made to the “k 0” (Table 1), “Capture” (Table 2), “Nuclides” (Table 3) and “k 0 (nf)” (Table 4) sheets. All changes are relative to the IUPAC k 0 database dated 2002-10-01, version 4 [9]. The changes were approved by the k 0-NDC on 2012-03-14 and the resulting Excel file was published (see weblink: http://www.kayzero.com/k0naa/k0naa/News/News.html). It should be noted that in many cases the only change in the Excel file relative to the previous the IUPAC k 0 database is that the revision information is now said to be found in Ref. [7] rather than in the original publication of the data. If this was the only change for a given case, the change is not explicitly mentioned in Tables 1–4.
The k 0-NDC recommends the use of this Excel file of 2012-03-14 as the official k 0 database. Users that modify data in this Excel file for their own use break the link to this recommended k 0-NAA database and therefore lose traceability to the k 0 factors therein. This database is a compilation of the best data available up to 2003. Since then, many papers have been published containing new measurements of k 0 and Q 0 values and even new E r values and half-lives. Undoubtedly, some of the new values will one day be accepted as being more accurate than the corresponding values in the recommended database. It is now the priority of the k 0-NDC to evaluate these new values, as well as others which will be published soon, and to update the recommended database.
Conclusion
The different versions of the k 0 database Refs. [2–10] have been carefully checked for consistency and correctness. The different types of mistakes and typos were identified and corrected. The database is established in the form of an easily accessible Excel file freely downloadable at http://www.kayzero.com/k0naa/k0naa/News/News.html. The k 0-Nuclear Data Committee is now working to review all the recently measured nuclear data in order to update this database.
References
Simonits A, De Corte F, Hoste J (1975) Single-comparator methods in reactor neutron-activation analysis. J Radioanal Chem 24:31–46
Jovanović S, De Corte F, Simonits A, Moens L, Vukotić P, Hoste J (1987) The effective resonance energy as a parameter in (n,γ) activation-analysis with reactor neutrons. J Radioanal Nucl Chem 113:177–185
De Corte F, Simonits A (1989) k 0-measurements and related nuclear-data compilation for (n,γ) reactor neutron-activation analysis. J Radioanal Nucl Chem 133:43–130
De Corte F, Simonits A, Bellemans F, Freitas MC, Jovanović S, Smodiš B, Erdtmann G, Petri H, De Wispelaere A (1993) Recent advances in the k 0-standardization of neutron-activation analysis—extensions, applications, prospects. J Radioanal Nucl Chem 169:125–158
De Corte F, Van Lierde S, Simonits A, Bossus D, Van Sluijs R, Pomme S (1999) A re-evaluation of k 0 and related nuclear data for the 555.8 keV gamma-line emitted by the Rh-104m-Rh-104 mother-daughter pair for use in NAA. Appl Radiat Isot 51:701–706
De Corte F, Van Lierde S (2001) Determination and evaluation of fission k 0-factors for correction of the U-235(n,f) interference in k 0-NAA. J Radioanal Nucl Chem 248:97–101
De Corte F, Simonits A (2003) Recommended nuclear data for use in the k 0 standardization of neutron activation analysis. At Data Nucl Data Tables 85:47–67
Kolotov VP, De Corte F (2003) An electronic database with a compilation of k 0 and related data for NAA. J Radioanal Nucl Chem 257:501–508
Kolotov VP, De Corte F (2002) Compilation of k 0 and related data for NAA in the form of an electronic database. Version 4, 2002-10-01, IUPAC Project 2001-075-1-500
Blaauw M, De Corte F (2010) Consistency of the nuclear data in the fundamental databases for use in the k 0-method. Nucl Insrtum Methods Phys Res A 622:377–380
Acknowledgments
The authors are grateful to Dr. Vladimir P. Kolotov from the Vernadsky Institute of Geochemistry and Analytical Chemistry of Russian Academy of Sciences, Moscow, Russia, for providing the original Excel file with recommended nuclear data for use in the k 0 method of NAA.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Jaćimović, R., De Corte, F., Kennedy, G. et al. The 2012 recommended k 0 database. J Radioanal Nucl Chem 300, 589–592 (2014). https://doi.org/10.1007/s10967-014-3085-2
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10967-014-3085-2