Abstract
In this paper dynamic load carrying capacity (DLCC) of a cable robot equipped with a closed loop control system based on feedback linearization, is calculated for both rigid and flexible joint systems. This parameter is the most important character of a cable robot since the main application of this kind of robots is their high load carrying capacity. First of all the dynamic equations required for control approach are represented and then the formulation of control approach is driven based on feedback linearization method which is the most suitable control algorithm for nonlinear dynamic systems like robots. This method provides a perfect accuracy and also satisfies the Lyapunov stability since any desired pole placement can be achieved by using suitable gain for controller. Flexible joint cable robot is also analyzed in this paper and its stability is ensured by implementing robust control for the designed control system. DLCC of the robot is calculated considering motor torque constrain and accuracy constrain. Finally a simulation study is done for two samples of rigid cable robot, a planar complete constrained sample with three cables and 2 degrees of freedom and a spatial unconstrained case with six cables and 6 degrees of freedom. Simulation studies continue with the same spatial robot but flexible joint characteristics. Not only the DLCC of the mentioned robots are calculated but also required motors torque and desired angular velocity of the motors are calculated in the closed loop condition for a predefined trajectory. The effectiveness of the designed controller is shown by the aid of simulation results as well as comparison between rigid and flexible systems.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
Albus, J.S., Bostelman, R., Dagalakis, N.G.: The NIST Robocrane. J. Robot. Syst. 10(5), 709–724 (1993)
Williams ll R.L., Gallina, P., Rossi, A.: Planar cable direct driven robots; Part 1: kinematics and statics. In: ASME Design Technical Conferences, 27th Design Automation Conference, vol. 2, pp. 1233–1240 (2001)
Korayem, M.H., Bamdad, M.: Dynamic load carrying capacity of cable-suspended parallel manipulators. Int. J. AMT. 44(7–8), 1133–1143 (2009)
Alp, A.B., Agrawal, S.K.: Cable Suspended Robots: Design, Planning and Control. Department of Mechanical Engineering, University of Delaware (2001)
Korayem, M.H., Davarpanah, F., Gariblu, H.: Load carrying capacity of flexible joint manipulator with feedback linearization. Int. J. AMT. 29(3–4), 389–397 (2006)
Korayem, M.H., Firouzi, S.: Dynamic load carrying capacity of mobile-base flexible-link manipulators: feedback linearization control approach. Proc. IEEE Int. Conf. Robot. Biomimetics. 2172–2177 (2007)
Dolorez, F.J., Russ, H.: Planar Direct Driven Robot. College of Engineering and Technology of Ohio University (2003)
Yamamoto, M., Yanai, N., Mohri, A.: Trajectory control of incompletely restrained parallel-wire-suspended mechanism based on inverse dynamics. IEEE Trans. Robot. 20(5), 840–850 (2004)
Spong, M.W.: Modeling and Control of Elastic Joint Robots. Coordinate Science Lab., University of Illinois at Urbana Champaign (1987)
Chen, G.: Exact Closed-form Optimal Solution for Constrained Trajectory Control of Single-link Flexible Joint Manipulator. Department of Electrical Engineering, University of Houston, Texas (1990)
Zhang, Y., Agrawal, S.K., Piovoso, M.J.: Coupled dynamics of flexible cables and rigid end-effector for a cable suspended robot. American Control Conference (2006)
Shiang, W.J., Cannon, D., Gorman, J.: Dynamic analysis of the cable array robotic crane. In: IEEE International Conference on Robotics & Automation, Detroit, vol. 4, 2495–2500 (1999)
Korayem, M.H., Bamdad, M.: Workspace analysis of cable-suspended robots with elastic cable. In: Proc. of the IEEE International Conference on Robotics and Biomimetics, ROBIO, Sanya, China, vol. 5, pp. 1942–1947 (2007)
Baicu, C.F., Rahn, C.D., Nibali, B.D.: Active Boundary Control of Elastic Cables. Theory and Experiment. Department of Mechanical Engineering, Clemson University, ScienceDirect (2002)
Williams, R.L.: Planner cable suspended haptic interface: design for wrench exertion. ASME Des. Tech. Conf. 35, 203–219 (1999)
So-Ryeok Oh: Cable Suspended Robots: Control Approaches and Applications. Ph.D. Thesis, University of Delaware (2006)
Korayem, M.H., Bamdad, M., Bayat, S.: Optimal trajectory planning with dynamic load carrying capacity of cable-suspended manipulator. In: IEEE International Symposium Mechatronics and its Applications, ISMA, pp. 1–6 (2009)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Korayem, M.H., Tourajizadeh, H. & Bamdad, M. Dynamic Load Carrying Capacity of Flexible Cable Suspended Robot: Robust Feedback Linearization Control Approach. J Intell Robot Syst 60, 341–363 (2010). https://doi.org/10.1007/s10846-010-9423-x
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10846-010-9423-x