Abstract
In this paper, we develop a physiologic wall stress analysis procedure by incorporating experimentally measured, non-uniform pressure loading in a patient-based finite element simulation. First, the distribution of wall pressure is measured in a patient-based lumen cast at a series of physiologically relevant steady flow rates. Then, using published equi-biaxial stress-deformation data from aneurysmal tissue samples, a nonlinear hyperelastic constitutive equation is used to describe the mechanical behavior of the aneurysm wall. The model accounts of the characteristic exponential stiffening due to the rapid engagement of nearly inextensible collagen fibers and assumes, as a first approximation, an isotropic behavior of the arterial wall. The results show a complex wall stress distribution with a localized maximum principal stress value of 660 kPa on the inner surface of the posterior surface of the aneurysm bulge, a considerably larger value than has generally been reported in calculations of wall stress under the assumption of uniform loading. This is potentially significant since the posterior wall has been suggested as a common site of rupture, and the aneurysmal tensile strength reported by other authors is of the same order of magnitude as the maximum stress value found here.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
ABAQUS V6.7 (2007) Dassault Systèmes Simulia. ABAQUS, Providence
Asbury CL, Ruberti JW, Bluth EI, Peattie RA (1995) Experimental investigation of steady flow in rigid models of abdominal aorticaneurysms. Ann Biomed Eng 23: 29–39
Ashton HA, Buxton MJ, Day NE, Kim LG, Marteau TM, Scott RA, Thompson SG, Walker NM (2002) The multicentre aneurysm screening study (MASS) into the effect of abdominal aortic aneurysm screening on mortality in men: a randomized control trial. Lancet 360: 1531–1539
Basciano CA, Kleinstreuer C (2009) Invariant-based anisotropic constitutive models of the healthy and aneurysmal abdominal aortic wall. ASME J Biomech Eng 131: 021009
Bluestein D, Dumont K, De Beule M, Ricotta J, Impellizzeri P, Verhegghe B, Verdonck P (2009) Intraluminal thrombus and risk of rupture in patient specific abdominal aortic aneurysms—FSI modeling. Comput Methods Biomech Biomed Eng 12: 73–81
Bluth EI, Murphey SM, Hollier LH, Sullivan MA (1990) Color flow doppler in the evaluation of aortic aneurysms. Int Angiol 9: 8–10
Bose K, Dorfmann A (2009) Computational aspects of a pseudo-elastic constitutive model for muscle properties in a soft-bodied arthropod. Int J Nonlinear Mech 44: 42–50
Chuong CJ, Fung YC (1984) Compressibility and constitutive equation of arterial-wall in radial compression experiments. J Biomech 17: 35–40
Darling RC, Messina CR, Brewster DC, Ottinger LW (1977) Autopsystudy of unoperated abdominal aortic aneurysms. Circulation 56: 161–164
Demiray H (1972) Elasticity of soft biological tissues. J Biomech 5: 309–311
Edgar ES (2008) Computational and experimental investigation of steady flow fields, turbulence and hemodynamic wall stresses in patient-specific abdominal aortic aneurysm models. M.S. Thesis, Oregon State University
Elger DF, Blackketter DM, Budwig RS, Johansen KH (1996) The influence of shape on the stresses in model abdominal aorticaneurysms. ASME J Biomech Eng 118: 326–332
Fillinger M (2006) The long-term relationship of wall stress to the natural history of abdominal aortic aneurysms (finite element analysis and other methods). Ann N Y Acad Sci 1085: 22–28
Fung YC (1981) Biomechanics: mechanical properties of living tissue. Springer, New York
Holzapfel GA (2001) Nonlinear solid mechanics: a continuum approach for engineering. Wiley, Chichester
Holzapfel GA, Gasser TC, Ogden RW (2000) A new constitutive framework for arterial wall mechanics and a comparative study of material models. J Elast 61: 1–48
Holzapfel GA, Ogden RW (2009) On planar biaxial tests for anisotropic nonlinearly elastic solids. A continuum mechanical framework. Math Mech Solids 14: 474–489
Hua J, Mower WR (2001) Simple geometric characteristics fail to reliably predict abdominal aortic aneurysm wall stresses. J Vasc Surg 34: 308–315
Humphrey JD (2001) Cardiovascular solid mechanics cells tissues and organs. Springer, New York
Humphrey JD, Taylor CA (2008) Intracranial and abdominal aorticaneurysms: similarities, differences, and need for a new class of computational models. Annu Rev Biomed Eng 10: 221–246
Humphrey JD, Yin FCP (1987) A new constitutive formulation for characterizing the mechanical behavior of soft tissues. Biophys J 52: 563–570
Johansson G, Swedenborg J (1986) Ruptured abdominal aortic aneurysms: a study of incidence and mortality. Br J Surg 73: 101–103
Li Z, Kleinstreuer C (2006) Effects of blood flow and vessel geometry on wall stress and rupture risk of abdominal aorticaneurysms. J Med Eng Technol 30: 283–297
Li ZY, U-Ying-Im J, Tang TY, Soh E, See TC, Gillard JH (2008) Impact of calcification and intraluminal thrombus on the computed wall stresses of an abdominal aortic aneurysm. J Vasc Surg 47: 928– 935
Lin HT, Dorfmann AL, Trimmer BA (2009) Soft cuticle biomechanics: a constitutive model of anisotropy for caterpillar integument. J Theor Biol 256: 447–457
Mower WR, Baraff LJ, Sneyd J (1993) Stress distributions in vascular aneurysms—factors affecting risk of aneurysm rupture. J Surg Res 55: 155–161
Nevitt MP, Ballard DJ, Hallett JW (1989) Prognosis of abdominal aortic aneurysms: a population based study. New Engl J Med 321: 1009–1014
Newman AB, Arnold AM, Burke GL, O’Leary DH, Manolio TA (2001) Cardiovascular disease and mortality in older adults with small abdominal aortic aneurysms detected by ultrasonography: the cardiovascular health study. Ann Intern Med 134: 182–190
Ogden RW (1997) Nonlinear elastic deformations. Dover, New York
Ogden RW, Schulze-Bauer CAJ (2000) Phenomenological and structural aspects of the mechanical response of arteries (with C. A. J. Schulze-Bauer). In: Casey J, Bao G (eds) Mechanics in biology. ASME AMD-Vol. 242/BED-Vol. 46:125–140
O’Rourke MJ, McCullough JP (2008) A comparison of the measured and predicted flowfield in a patient-specific model of an abdominal aortic aneurysm. Proc Inst Mech Eng Part H J Eng Med 222: 737–750
Papaharilaou Y, Ekaterinaris JA, Manousaki E, Katsamouris AN (2007) A decoupled fluid structure approach for estimating wall stress in abdominal aortic aneurysms. J Biomech 40: 367–377
Peattie RA, Asbury CL, Bluth EI, Ruberti JW (1996a) Steady flow in models of abdominal aortic aneurysms. Part I: investigation of the velocity patterns. J Ultrasound Med 15: 679–688
Peattie RA, Asbury CL, Bluth EI, Riehle TJ (1996b) Steady flow in models of abdominal aortic aneurysms. Part II: wall stresses and their implications for in vivo thrombosis and rupture. J Ultrasound Med 15: 689–696
Peattie RA, Riehle TJ, Bluth EI (2004) Pulsatile flow in fusiform models of abdominal aortic aneurysms: flow fields, velocity patterns and wall stresses. ASME J Biomech Eng 126: 438–446
Raghavan ML, Vorp DA (2000) Toward a biomechanical tool to evaluate rupture potential of abdominal aortic aneurysms: identification of a finite strain constitutive model and evaluation of its applicability. J Biomech 33: 475–482
Raghavan ML, Vorp DA, Federle MP, Makaroun MS, Webster MW (2000) Wall stress distribution on three-dimensionally reconstructed models of human abdominal aortic aneurysm. J Vasc Surg 31: 760–769
Rissland P, Alemu Y, Einav S, Ricotta J, Bluestein D (2009) Abdominal aortic aneurysm risk of rupture-patient specific FSI simulations using anisotropic model. J Biomech Eng 131: 031001–031010
Rodríguez JF, Ruiz C, Doblare M, Holzapfel GA (2008) Mechanical stresses in abdominal aortic aneurysms: influence of diameter, asymmetry, and material anisotropy. ASME J Biomech Eng 130: 021023
Scotti CM, Jimenez J, Muluk SC, Finol EA (2008) Wall stress and flow dynamics in abdominal aortic aneurysms: finite element analysis vs fluid-structure interaction. Comput Methods Biomech Biomed Eng 11: 301–322
Singh K, Bønaa KH, Jacobsen BK, Bjørk L, Solberg S (2001) Prevalence of and risk factors for abdominal aortic aneurysms in a population-based study: the Tromsø study. Am J Epidemiol 154: 236–244
Speelman L, Bohra A, Bosboom EMH, Schurink GW, Van de Vosse FN, Makaroun MS, Vorp DA (2007) Effects of wall calcifications in patient-specific wall stress analyzes of abdominal aortic aneurysms. ASME J Biomech Eng 129: 105–109
Stringfellow MM, Lawrence PF, Stringfellow RG (1987) The influence of aorta aneurysm geometry upon stress in the aneurysm wall. J Surg Res 42: 425–433
Truijers M, Pol JA, Schultzekool LJ, van Sterkenburg SM, Fillinger MF, Blankensteijn JD (2007) Wall stress analysis in small asymptomatic, symptomatic and ruptured abdominal aortic aneurysms. Eur J Vasc Endovasc 33: 401–407
Vande Geest JP (2005) Towards an improved rupture potential index for abdominal aortic aneurysms: anisotropic constitutive modeling and noninvasive wall strength estimation. PhD Thesis, University of Pittsburgh
Vande Geest JP, Bohra A, Sun W, Di Martino E, Sacks MS, Vorp DA (2004) Development and 3D finite element implementation of a multiaxial constitutive relation for abdominal aortic aneurysms. In: Proceedings of the international mechanical engineering conference
Vande Geest JP, Sacks MS, Vorp DA (2006a) The effects of aneurysm on the biaxial mechanical behavior of human abdominal aorta. J Biomech 39: 1324–1334
Vande Geest JP, Wang DH, Wisniewski SR, Makaroun MS, Vorp DA (2006b) Towards a noninvasive method for determination of patient-specific wall strength distribution in abdominal aorticaneurysms. Ann Biomed Eng 34: 1098–1106
Vande Geest JP, Schmidt DE, Sacks MS, Vorp DA (2008) The effects of anisotropy on the stress analyzes of patient-specific abdominal aortic aneurysms. Ann Biomed Eng 36: 921–932
Vorp DA (2007) Review: biomechanics of abdominal aortic aneurysm. J Biomech 40: 1887–1902
Vorp DA, Raghavan ML, Webster MW (1998) Mechanical wall stress in abdominal aortic aneurysm: influence of diameter and asymmetry. J Vasc Surg 27: 632–639
Wang DHJ, Makaroun MS, Webster MW, Vorp DA (2002) Effect of intraluminal thrombus on wall stress in patient-specific models of abdominal aortic aneurysm. J Vasc Surg 36: 598–604
Watton PN, Hill NA (2009) Evolving mechanical properties of a model of abdominal aortic aneurysm. Biomech Model Mechanobiol 8: 25–42
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Dorfmann, A., Wilson, C., Edgar, E.S. et al. Evaluating patient-specific abdominal aortic aneurysm wall stress based on flow-induced loading. Biomech Model Mechanobiol 9, 127–139 (2010). https://doi.org/10.1007/s10237-009-0163-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s10237-009-0163-4