Abstract
Resins were prepared from resoles andPinus pinaster bark tannins by copolymerization at room temperature. Reducing the moisture content of the tannins to below 60% increased their stability, so allowing preparation of the resin before its application. Various formulations were tested, all of them substituting 50% of phenols by tannins. The resins obtained were used to manufacture 5-ply eucalyptus boards which met BS 1455: 1963 WBP quality standards.
Zusammenfassung
Durch Copolymerisation von Resolen und Rinden-Tannin ausPinus pinaster wurden verschiedene Harze hergestellt. Erniedrigung des Wassergehaltes auf unter 60% erhöht ihre Stabilität, so daß die Harze schon einige Zeit vor der Anwendung hergestellt werden konnten. Verschiedene Zusammensetzungen, wobei jeweils 50% des Phenols durch Tannin ersetzt war, wurden getestet. Mit den so erhaltenen Harzen wurden fünfschichtige Sperrholzplatten aus Eucalyptus verleimt. Die Platten genügten den Anforderungen des Standards BS 1455: 1963 WBP
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Harlam, E.: The Flavonoids. Recent Advances in Research. Harbone, J. B.; Mabry, J. J. Eds. Chapman and Hall. (1980) 417
Hemingway, R. W.; McGraw, G. W.: Southern pine bark polyflavonoids: Structure, reactivity, use in wood adhesives. Tappi for Biol. Wood Chem. Conf. (1977) 261–269
Hemingway, R. W.: Bark: Its chemistry and prospects for chemical utilization. In: Organic Chemicals from Biomass. Goldstein, I. S. Ed. CRC Press. (1981) 189–248
Hse, C-Y.; Kwo, M.-L.: Influence of extractives on wood gluing and finishing—a review. Forest Prod. J. 38 (1) (1988) 52–56
von Leyser, E.; Pizzi, A.: The formulation and commercialization of glulam pine tannin adhesives in Chile. Holz Roh-Werkstoff 48 (1990) 25–29
Marutzky, R.; Dix, B.: Formaldehyde release of tannin-bonded particleboards. Journal of Applied Polymer Science. Applied Polymer Symposium 40 (1984) 49–57
Pizzi, A.: Wood Adhesives. Chemistry and Technology. Marcel Dekker 1983
Suomi-Lindberg, L.: Bark extracts and their use in plywood bonding. Research Report. Technical Research Center of Finland. (1984) 307
Vázquez, G.; Antorrena, G.; Parajo, J. C.: Selection of operational conditions in alkaline lixiviation of Pinus pinaster bark. Holz Roh- Werkstoff 44 (1986) 415–418
Váquez, G.; Antorrena, G.; Parajo, J. C.: Studies on utilization of Pinus pinaster bark. Part 2: Kinetics and yields of alkaline extractions. Wood Sci. Technol. 44 (1987) 155–166
Vázquez, G.; Antorrena, G.; Parajo, J. C.; Francisco, J. L.: Preparation of wood adhesives by polycondensation of phenolic acids from Pinus pinaster bark with resoles. Holz Roh- Werkstoff 47 (1989) 491–494
Vázquez, G.; Antorrena, G.; Parajo, J. C.; Francisco, J. L.: Plywood adhesives with Pinus pinaster bark extracts. In: Biomass for Energy and Industry. Vol 2: Conversion and utilization of Biomass. 5th E.C. Conference. Grassi, G., Gosse, G., dos Santos, G., Elsevier Applied Science. (1990) 2.935–2.939
Voulgaridis, E.; Grigoriu, A.; Passialis, C.: Investigations on bark extracts of Pinus halepensis Mill. Holz Roh-Werkstoff 43 (1985) 269–272
Author information
Authors and Affiliations
Additional information
This study was subsidised by the Xunta de Galicia. The authors wish to express their gratitude to FORESA for technical assistance.
Rights and permissions
About this article
Cite this article
Vázquez, G., Antorrena, G., Francisco, J.L. et al. Properties of phenolic-tannin adhesives from pinus pinaster bark extracts as related to bond quality in eucalyptus plywoods. Holz als Roh-und Werkstoff 50, 253–256 (1992). https://doi.org/10.1007/BF02650319
Issue Date:
DOI: https://doi.org/10.1007/BF02650319