Abstract
The hole-drilling method is one technique for measuring residual stresses. All the existing equations for the calculation of residual stresses are based on the assumption that the hole is located at the rosette center. In this paper, the stress-strain relationship for the eccentric hole case has been derived and expressed in terms of the off-center distance and the polar angle. The alignment error is studied and demonstrated by two examples, namely, a uniaxial-stress field and a hydrostatic-stress field. The error analysis yielded the following typical result: ten percent of hole radius off-center will yield about five-percent measurement error for the standard rosette (EA-09-062-RE-120).
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Mathar, J., “Determination of Initial Stresses by Measuring the Deformation Around Drilled Holes,”Trans. ASME,56,245–254 (1934).
Soete, W. andVancrombrugge, R., “An Industrial Method for the Determination of Residual Stresses,”Proc. SESA,VIII (1),17–28 (1950).
Riparbelli, C., “A Method for the Determination of Initial Stresses,”Proc. SESA,VIII (1),173–196 (1950).
Kelsey, R.A., “Measuring Non-uniform Residual Stresses by the Hole Drilling Method,”Proc. SESA,XIV (1),181–194 (1956).
Rendler, N.J. andVigness, I., “Hole-drilling Strain-gage Method for Measuring Residual Stresses,”Experimental Mechanics,6 (12),577–586 (Dec.1966).
Bush, A.J. andKromer, J.F., “Simplification of the Hole-Drilling Method of Residual Stresses Measurement,”Trans. ISA,12 (3),249–259 (1973).
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Wang, HP. The alignment error of the hole-drilling method. Experimental Mechanics 19, 23–27 (1979). https://doi.org/10.1007/BF02327766
Received:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF02327766