Abstract
The complete orthotropic elastic-stiffness matrix of unidirectional, Borsic-filament-reinforced aluminum composites was experimentally evaluated for three different volume fractions by ultrasonic velocity measurements on thin plates. Longitudinal- and shear-velocity measurements were made in appropriate symmetry directions by direct contact or liquid-immersion techniques. The elastic constants determined by this pulsed through-transmission method were in agreement with micromechanical theories based on the properties of the constituent materials. Agreement was also found between engineering constants determined by mechanical testing and those calculated from the ultrasonic data. Finally, measurement of the ultrasonic-wave velocity has also been shown to be a rapid nondestructive-test method for determining filament-volume fraction in a fabricated part.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Huntington, H. B., “The Elastic Constants of Crystals,”Solid State Physics,7,Academic Press,New York,213–351 (1958).
Behrens, E., “Elastic Constants of Filamentary Composites with Rectangular Summetry,”J. Acoust. Soc. Amer.,42,367 (1967).
Kittel, C., Quantum Theory of Solids, John Wiley and Sons, New York, 250–254 (1963).
Heaton, M. D., “A Calculation of the Elastic Constants of a Unidirectional Fibre-Reinforced Composite,”Brit. J. Appl. Phys. (J. Phys. D.),1,1039 (1968).
Whitney, J. M. andRiley, M. B., “Elastic Properties of Fiber-Reinforced Composite Materials,”AIAA J.,4,1537 (1966).
Hashin, Z. andRosen, B. W., “The Elastic Moduli of Fiber-Reinforced Materials,”J. Appl. Mech.,31,223 (1964).
Davies, W. E. A., “The Elastic Constants of a Two-Phase Composite Materials,”J. Phys. D.: Appl. Phys.,4,1176 (1971).
Greszczuk, L. B., “Theoretical and Experimental Studies on Properties and Behavior of Filamentary Composites,” Douglas Paper No. 3550, MDAC-WD, Santa Monica, CA (1966).
Hoover, W. R., Allred, R. E., Moss, M. and Cyrus, W. L., “Metal-Matrix Composite Fabrication by Plasma Spraying and Tape Bonding,” Sandia Laboratories Report SC-TM-710396 (July 1971).
Zimmer, J. E. andCost, J. R., “Determination of the Elastic Constants of a Unidirectional Fiber Composite Using Ultrasonic Velocity Measurements”J. Acoust. Soc. Amer.,47,795 (1970).
Markham, M. F., “Measurement of the Elastic Constants of Fibre-Composites by Ultrasonics,”Composites,1,145 (1970).
Henneke II E. G., “Reflection-Refraction of a Stress Wave at a Plane Boundary between Anisotropic Media,”J. Acoust. Soc. Amer.,51,210 (1972).
Alers, G. A. andNeighbours, J. R., “Crystal Stability and Elastic Constants,”J. Appl. Phys.,28,1514 (1957).
Allred, R. E., “Elastic-Plastic Poisson’s Ratio of Borsic-Reinforced Aluminum Composites,” Sandia Laboratories Rept. SC-RR-720924 (Dec. 1972).
Herring, H. W., “Selected Mechanical and Physical Properties of Boron Filaments,” NASA-TND-3202, NASA, Langley Research Center (1966).
Author information
Authors and Affiliations
Additional information
Work was supported by the U.S. Atomic Energy Commission.
Rights and permissions
About this article
Cite this article
Gieske, J.H., Allred, R.E. Elastic constants of B-A1 composites by ultrasonic velocity measurements. Experimental Mechanics 14, 158–165 (1974). https://doi.org/10.1007/BF02322839
Received:
Revised:
Issue Date:
DOI: https://doi.org/10.1007/BF02322839