Abstract
Maximum total displacement (D) is plotted against fault or thrust width(W) for 65 faults, thrusts, and groups of faults from a variety of geological environments. Displacements range from 0.4 m to 40 km and widths from 150 m to 630 km, and there is a near linear relationship betweenD andW 2. The required compatibility strains (e s) in rocks adjacent to these faults increases linearly withW and with\(\sqrt D \) and ranges frome s=2×10−4 toe s=3×10−1. These are permanent ductile strains, which compare with values ofe s=2×10−5 for the elastic strains imposed during single slip earthquake events, which are characterised by a linear relationship between slip (u) andW.
The data are consisten with a simple growth model for faults and thrusts, in which the slip in successive events increases by increments of constant size, and which predicts a relationship between displacement and width of the formD=cW 2. Incorporation of constant ductile strain rate into the model shows that the repreat time for slip events remains constant throughout the life of a fault, while the displacement rate increases with time. An internally consistent model withe s=2×10−5, giving repeat times of 160 years and instantaneous displacement rates of 0.02 cm/yr, 0.2 cm/yr, and 2.0 cm/yr when total displacement is 1 m, 100 m, and 10 km, and slip increasing by 0.5 mm with each event, gives a good approximation of the data. The model is also applicable to stable sliding, the slip rate varying with ductile strain rate and withW 2.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Boyer, S. E. andElliott, D. (1982),Thrust systems. Amer. Assoc. Petr. Geol.66, 9, 1196–1230.
Elliott, D. (1976),The energy balance and deformation mechanisms of thrust sheets. Phil. Trans. R. Soc. London A283, 289–312.
Eshelby, J. D. (1957),The determination of the elastic field of an ellipsoidal inclusion and related problems. Proc. Roy. Soc. London A241, 376–396.
Gudmundsson, A. (1980),The Vogur Fissure Swarm, Reykjanes Peninsula, SW Iceland. Jokull30, 43–64.
Hanks, T. C. (1977),Earthquake stress drops, ambient tectonic stress, and stresses that drive plate motions. Pure Appl. Geophys.115, 441–458.
Kanamori H. andAnderson, D. L. (1975)Theoretical basis of some empirical relation in seismology. Bull. Seism. Soc. Am.65, 1073–1095.
Laughton, A. S. andSearle, R. C. (1979),Tectonic Processes of Slow Spreading Ridges, inDeep Drilling Results in the Atlantic Ocean: Ocean Crust. M. Talwani, C. G. Harrison, and D. E. Hayes (eds.), Maurice Ewing Ser., Vol. 2, AGU, Washington, D.C.
Muraoka, H. andKamata, H. (1983),Displacement distribution along minor fault traces. J. Struct. Geol.5, 483–495.
Ramsay, J. G. andHuber, M. I. (1983),The techniques of modern structural geology. Vol. 1, Strain Analysis. Academic Press, London, 307 pp.
Rippon, J. H. (1985),Contoured patterns of the throw and hade of normal faults in the coal measures (Westphalian) of north-east Derbyshire. Proc. Yorkshire Geol. Soc.45, 147–161.
Scholz, C. H. (1982),Scaling laws for large earthquakes: Consequences for physical models. Bull. Seism. Soc. Am.72, 1–14.
Searle, R. C. (1983),Gloria survey of the East Pacific Rise near 3.5°S: Tectonic and volcanic characteristics of a fast spreading mid-ocean rise. Tectonophys.101, 319–344.
White, S. (1976),The effects of strain on the microstructures, fabrics, and deformation mechanisms in quartzites. Phil. Trans. R. Soc. London A283, 289–312.
Williams, G. andChapman, T. (1983),Strains developed in the hanging walls of thrusts due to their slip/propagation rates: A dislocation model. J. Struct. Geol.5, 563–571.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Watterson, J. Fault dimensions, displacements and growth. PAGEOPH 124, 365–373 (1986). https://doi.org/10.1007/BF00875732
Received:
Revised:
Accepted:
Issue Date:
DOI: https://doi.org/10.1007/BF00875732