Conclusions
-
1.
The hot deformation of corrosion-resistant steels of the ferritic, austenitic, and austenitic—ferritic classes in the 900–1100°C interval at rates\(\dot \varepsilon = 10^{ - 2} - 10^{ - 3} \) sec−1 results in dynamic recrystallization.
-
2.
Various types of substructures are formed in the initial stages of plastic flow, depending on the deformation conditions and the type of crystal lattice of the steels, and, consequently, different mechanisms of dynamic recrystallization are realized.
-
3.
Substructure formation in the initial grains and gradual transformation of low- to high-angle boundaries are the mechanisms responsible for the formation of recrystallized grains in the ferritic steels over the entire temperature region investigated, and in the austenitic-class steel at high temperatures.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Literature cited
M. I. Gol'dshtein, S. V. Grachev, and Yu. G. Veksler, Special Steels [in Russian], Metallurgiya, Moscow (1985).
S. S. Gorelik, Recrystallization of Metals and Alloys [in Russian], Metallurgiya, Moscow (1978).
M. L. Bernshtein, V. A. Zaimovskii, and L. M. Kaputkina, Thermomechanical Treatment of Steel, [in Russian], Metallurgiya, Moscow (1983).
O. A. Kaibyshev, Superplasticity of Commercial Alloys [in Russian], Metallurgiya, Moscow (1984).
T. Maki, K. Akasaka, K. Okuno, and I. Tamura, "Dynamic recrystallization of austenite in 18-8 stainless steel and 18 Ni maraging steel," Trans. Iron Steel Inst. Jpn.22, 253–261 (1982).
S. Sakui, T. Sakai, and K. Takeishi, "deformation of austenite in a plain carbon steel," Trans. Iron Steel Inst. Jpn.17, 718–725 (1977).
C. Ouchi and T. Okita, "Dynamic recrystallization behavior of austenite in Nb-bearing high-strength low-alloy steels and stainless steel," Trans. Iron Steel Inst. Jpn.,22, 543–551 (1982).
T. Maki, S. Okaguchi, and I. Tamura, "Dynamic recrystallization in ferritic stainless steel," ICSMA6,1, 529–534 (1982).
T. Chandra, D. Bendeich, and B. P. Dunne, "Dynamic recovery and recrystallization in a duplex stainless," ICSMA6,1, 505–510 (1982).
G. Glover and C. M. Sellars, "Recovery and recrystallization during high temperature deformation of iron," Metall. Trans.4, No. 3, 765–775 (1973).
C. M. Sellars, "Recrystallization of metals during hot deformation," Philos. Trans. R. Soc. London, Ser. A.,A288, 147–158 (1978).
V. V. Rybin, Large Plastic Deformations and Failure of Metals [in Russian], Metallurgiya, Moscow (1986).
N. G. Zaripov, A. R. Vaganov, and R. O. Kaibyshev, "Dynamic recrystallization of a magnesium alloy," Fiz. Met. Metalloved.,63, No. 4, 774–781 (1987).
Additional information
Institute of Problems of Metal Superplasticity, Ufa. Translated from Metallovedenie i Termicheskaya Obrabotka Metallov, No. 5, pp. 19–23, May, 1992.
Rights and permissions
About this article
Cite this article
Belyakov, A.N., Kaibyshev, R.O. Structural changes in corrosion-resistant steels during hot deformation. Met Sci Heat Treat 34, 324–329 (1992). https://doi.org/10.1007/BF00776657
Issue Date:
DOI: https://doi.org/10.1007/BF00776657