Abstract
A time-dependent one-dimensional model of the Active Magnetic Regenerator (AMR) is described. The model assumes that the heat capacity of the pore fluid in the regenerator is negligible compared to the magnetic material. Measured magnetic material properties are used, including the effect of hysteresis. The variation of the fluid helium properties with temperature are included. Heat transfer between the fluid and bed is obtained from an emperical correlation, as is the pressure drop, axial conduction and axial dispersion.
Equations are presented and the numerical procedure used to solve them is discussed with emphasis on accuracy. The model has been applied to results from an AMR test device.
Access this chapter
Tax calculation will be finalised at checkout
Purchases are for personal use only
Preview
Unable to display preview. Download preview PDF.
Similar content being viewed by others
References
D. J. Janda et al, Design of an active magnetic regenerative hydrogen liquefier, this conf. (1991).
A. J. DeGregoria et al, Test results of an active magnetic regenerative refrigerator, this conf. (1991).
J. A. Barclay, The theory of an active magnetic regenerative refrigerator, Proc. 2nd Conf. of Refrigeration for Cryogenic Sensor and Electronic Systems (NASA, Goddard Research Center), (1982)..
F. W. Schmidt and A. J. Willmott, Thermal energy storage and regeneration, McGraw-Hill, 1981..
S. Whitaker, Forced convection heat transfer correlations for flow in pipes, past flat plates, single cylinders, single spheres, and for flow in packed beds and tube bundles, AIChE Journal Vol. 18, No. 2 (1972).
R. D. McCarty, Thermophysical properties of helium-4 from 2 to 1500 K with pressures to 1000 atmospheres, NBS technical note 631 (1972).
I. F. Macdonald et al, Flow through porous media — the ergun equation revisited, Ind. Eng. Chem. Fundam., 18, 199–208 (1970).
G. S. G. Beveridge and D. P. Haughey, Axial heat transfer in packed beds: Stagnant beds between 20 and 750C, Int. J. Heat Mass Transfer 14, 1093–1113 (1971).
S. Sarangi and H. S. Baral, Effects of axial conduction in the fluid on cryogenic regenerator performance, Cryog., 27 (1986).
C. B. Zimm et al, Materials for regenerative magnetic cooling spanning 20 K to 80 K, this conf. (1991).
Author information
Authors and Affiliations
Editor information
Editors and Affiliations
Rights and permissions
Copyright information
© 1992 Springer Science+Business Media New York
About this chapter
Cite this chapter
DeGregoria, A.J. (1992). Modeling the Active Magnetic Regenerator. In: Fast, R.W. (eds) Advances in Cryogenic Engineering. Advances in Cryogenic Engineering, vol 37. Springer, Boston, MA. https://doi.org/10.1007/978-1-4615-3368-9_13
Download citation
DOI: https://doi.org/10.1007/978-1-4615-3368-9_13
Publisher Name: Springer, Boston, MA
Print ISBN: 978-1-4613-6486-3
Online ISBN: 978-1-4615-3368-9
eBook Packages: Springer Book Archive