Abstract
In this paper, the free vibration and torsional static analysis of cylindrical shell are developed using modified strain gradient theory. In doing this, the governing equations and classical and non-classical boundary conditions are derived using Hamilton’s principle. After obtaining equations governing the problem, the differential quadrature method is used to discretize the equations of motion of the vibration problem and to examine the single-walled carbon nanotube (SWCNT) with two clamped-free and clamped–clamped supports as a special application of this formulation. Also, torsional static analysis is carried out for the clamped–clamped SWCNT. Results reveal that SWCNT rigidity in strain gradient theory is higher than that in couple stress theory or the classical theory, which leads to increase in torsional frequencies and decrease in torsion of SWCNT. Results also demonstrate that the effect of size parameter and SWCNT torsion in different lengths and diameters is considerable.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Zhou L., Shi S.: Molecular dynamic simulations on tensile mechanical properties of single-walled carbon nanotubes with and without hydrogen storage. Comput. Mater. Sci. 23(1), 166–174 (2002)
Wang L., Xu Y.Y., Ni Q.: Size-dependent vibration analysis of three-dimensional cylindrical microbeams based on modified couple stress theory: a unified treatment. Int. J. Eng. Sci. 68, 1–10 (2013) doi:10.1016/j.ijengsci.2013.03.004
Akgöz B., Civalek Ö.: Modeling and analysis of micro-sized plates resting on elastic medium using the modified couple stress theory. Meccanica 48(4), 863–873 (2013)
Zeighampour, H.; Beni, Y.T.: A shear deformable cylindrical shell model based on couple stress theory. Arch. Appl. Mech. 85(4), 539–553 (2014)
Zeighampour, H.; Beni, Y.T.: Free vibration analysis of axially functionally graded nanobeam with radius varies along the length based on strain gradient theory. Appl. Math. Model. 39(18), 5354–5369 (2015)
Zeighampour H., Beni Y.T.: Size-dependent vibration of fluid-conveying double-walled carbon nanotubes using couple stress shell theory. Phys. E 61, 28–39 (2014)
Dehrouyeh-Semnani A.M.: The influence of size effect on flapwise vibration of rotating microbeams. Int. J. Eng. Sci. 94, 150–163 (2015)
Beni, Y.T.; Mehralian, F.; Razavi, H.: Free vibration analysis of size-dependent shear deformable functionally graded cylindrical shell on the basis of modified couple stress theory. Compos. Struct. 120, 65–78 (2015)
Zeighampour, H.; Beni, Y.T.; Mehralian, F.: A shear deformable conical shell formulation in the framework of couple stress theory. Acta Mech. 226(8), 2607–2629 (2015)
Baninajjaryan A., Beni Y.T.: Theoretical study of the effect of shear deformable shell model, elastic foundation and size dependency on the vibration of protein microtubule. J. Theor. Biol. 382, 111–121 (2015)
Shojaeian, M.; Beni, Y.T.: Size-dependent electromechanical buckling of functionally graded electrostatic nano-bridges. Sens. Actuators A Phys. 232(1), 49–62 (2015)
Das S.L., Mandal T., Gupta S.S.: Inextensional vibration of zig–zag single-walled carbon nanotubes using nonlocal elasticity theories. Int. J. Solids Struct. 50(18), 2792–2797 (2013) doi:10.1016/j.ijsolstr.2013.04.019
Kahrobaiyan M., Tajalli S., Movahhedy M., Akbari J., Ahmadian M.: Torsion of strain gradient bars. Int. J. Eng. Sci. 49(9), 856–866 (2011)
Akgöz B., Civalek Ö.: Longitudinal vibration analysis for microbars based on strain gradient elasticity theory. J. Vib. Control 20(4), 606–616 (2014)
Akgöz B., Civalek Ö.: A new trigonometric beam model for buckling of strain gradient microbeams. Int. J. Mech. Sci. 81, 88–94 (2014)
Akgöz B., Civalek Ö.: A microstructure-dependent sinusoidal plate model based on the strain gradient elasticity theory. Acta Mech. 226(7), 2277–2294 (2015)
Sedighi H.M., Koochi A., Abadyan M.: Modeling the size dependent static and dynamic pull-in instability of cantilever nanoactuator based on strain gradient theory. Int. J. Appl. Mech. 6(5), 1450055 (2014)
Narendar S., Ravinder S., Gopalakrishnan S.: Strain gradient torsional vibration analysis of micro/nano rods. Int. J. Nanodimens. 3(1), 1–17 (2012)
Zeverdejani M.K., Beni Y.T.: The nano scale vibration of protein microtubules based on modified strain gradient theory. Curr. Appl. Phys. 13(8), 1566–1576 (2013) doi:10.1016/j.cap.2013.05.019
Beni Y.T., Karimipour I., Abadyan M.: Modeling the instability of electrostatic nano-bridges and nano-cantilevers using modified strain gradient theory. Appl. Math. Model. 39(9), 2633–2648 (2015)
Gurtin M.E., Weissmüller J., Larché F.: A general theory of curved deformable interfaces in solids at equilibrium. Philos. Mag. A 78(5), 1093–1109 (1998) doi:10.1080/01418619808239977
Sahmani S., Bahrami M., Aghdam M.: Surface stress effects on the postbuckling behavior of geometrically imperfect cylindrical nanoshells subjected to combined axial and radial compressions. Int. J. Mech. Sci. 100, 1–22 (2015)
Sedighi H.M., Daneshmand F., Abadyan M.: Modified model for instability analysis of symmetric FGM double-sided nano-bridge: corrections due to surface layer, finite conductivity and size effect. Compos. Struct. 132, 545–557 (2015)
Akgöz B., Civalek Ö.: Strain gradient elasticity and modified couple stress models for buckling analysis of axially loaded micro-scaled beams. Int. J. Eng. Sci. 49(11), 1268–1280 (2011) doi:10.1016/j.ijengsci.2010.12.009
Wang B., Zhao J., Zhou S.: A micro scale Timoshenko beam model based on strain gradient elasticity theory. Eur. J. Mech. A Solids 29(4), 591–599 (2010) doi:10.1016/j.euromechsol.2009.12.005
Zhao J., Zhou S., Wang B., Wang X.: Nonlinear microbeam model based on strain gradient theory. Appl. Math. Model. 36(6), 2674–2686 (2012) doi:10.1016/j.apm.2011.09.051
Yin L., Qian Q., Wang L.: Strain gradient beam model for dynamics of microscale pipes conveying fluid. Appl. Math. Model. 35(6), 2864–2873 (2011) doi:10.1016/j.apm.2010.11.069
Natsuki T., Tsuchiya T., Ni Q.-Q., Endo M.: Torsional elastic instability of double-walled carbon nanotubes. Carbon 48(15), 4362–4368 (2010) doi:10.1016/j.carbon.2010.07.050
Asghari M., Rafati J., Naghdabadi R.: Torsional instability of carbon nano-peapods based on the nonlocal elastic shell theory. Phys. E 47, 316–323 (2013) doi:10.1016/j.physe.2012.06.016
Gheshlaghi B., Hasheminejad S.M., Abbasion S.: Size dependent torsional vibration of nanotubes. Phys. E 43(1), 45–48 (2010) doi:10.1016/j.physe.2010.06.015
Lim C.W., Li C., Yu J.L.: Free torsional vibration of nanotubes based on nonlocal stress theory. J. Sound Vib. 331(12), 2798–2808 (2012) doi:10.1016/j.jsv.2012.01.016
Lam D.C.C., Yang F., Chong A.C.M., Wang J., Tong P.: Experiments and theory in strain gradient elasticity. J. Mech. Phys. Solids 51(8), 1477–1508 (2003) doi:10.1016/S0022-5096(03)00053-X
Zeighampour H., Beni Y.T.: Cylindrical thin-shell model based on modified strain gradient theory. Int. J. Eng. Sci. 78, 27–47 (2014)
Soedel W.: Vibrations of Shells and Plates, 3rd edn. Taylor & Francis, London (2004)
Shu C.: Differential Quadrature and Its Application in Engineering. Springer, Berlin (2000)
Zong Z., Zhang Y.: Advanced Differential Quadrature Methods. CRC Press, Boca Raton (2009)
Ansari R., Gholami R., Ajori S.: Torsional vibration analysis of carbon nanotubes based on the strain gradient theory and molecular dynamic simulations. J. Vib. Acoust. 135(5), 051016 (2013)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Zeighampour, H., Beni, Y.T. & Karimipour, I. Torsional Vibration and Static Analysis of the Cylindrical Shell Based on Strain Gradient Theory. Arab J Sci Eng 41, 1713–1722 (2016). https://doi.org/10.1007/s13369-015-1940-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s13369-015-1940-2