Abstract
As the byproduct of TiO2 industrial production, impure FeSO4·7H2O was used for the synthesis of LiFePO4. With the purified solution of FeSO4·7H2O, FePO4·xH2O was prepared by a normal titration method and a controlled crystallization method, respectively. Then LiFePO4 materials were synthesized by calcining the mixture of FePO4·xH2O, Li2CO3, and glucose at 700°C for 10 h in flowing Ar. The results indicate that the elimination of FeSO4·7H2O impurities reached over 95%, and using FePO4·xH2O prepared by the controlled crystallization method, the obtained LiFePO4 material has fine and sphere-like particles. The material delivers a higher initial discharge specific capacity of 149 mAh·g−1 at a current density of 0.1C rate (1C = 170 mA·g−1); the discharge specific capacity also maintains above 120 mAh·g−1 after 100 cycles even at 2C rate. Thus, the employed processing is promising for easy control, low cost of raw material, and high electrochemical performance of the prepared material.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Padhi A.K., Nanjundaswamy K.S., and Goodenough J.B., Phospho-olivines as positive-electrode materials for rechargeable lithium batteries, J. Electrochem. Soc., 1997, 144(4): 1188.
Padhi A.K., Nanjundaswamy K.S., Masquelier C., and Goodenough J.B., Effect of structure on the Fe3+/Fe2+ redox couple in iron phosphates, J. Electrochem. Soc., 1997, 144(5): 1609.
Yamada A, Chung S.C., and Hinokuma K., Optimized LiFePO4 for lithium battery cathodes, J. Electrochem. Soc., 2001, 148(3): A224.
Chung S.Y., Bloking J.T., and Chiang Y.M., Electronically conductive phospho-olivines as lithium storage electrodes, Nat. Mater., 2002, 1(2): 123.
Chen Z.H. and Dahn J.R., Reducing carbon in LiFePO4/C composite electrodes to maximize specific energy, volumetric energy, and tap density, J. Electrochem. Soc., 2002, 149(9): A1184.
Ravet N., Abouimrane A., Armand M., Chung S.Y., Bloking J.T., and Chiang Y.M., On the electronic conductivity of phospho-olivines as lithium storage electrodes, Nat. Mater. 2003, 2: 702.
Swoyer J.L, Barker J., and Saidi M.Y., Lithium iron(II) phospho-olivines prepared by a novel carbothermal reduction method, Electrochem. Solid State Lett., 2003, 6(3): A53.
Herle P.S., Ellis B., Coombs N., and Nazar L.F., Nano-network electronic conduction in iron and nickel olivine phosphates, Nat. Mater., 2004, 3: 147.
Myung S.T., Komaba S., Hirosaki N., Yashiro H., and Kumagai N., Emulsion drying synthesis of olivine LiFePO4/C composite and its electrochemical properties as lithium intercalation material, Electrochim. Acta, 2004, 49(24): 4213.
Park K.S., Kang K.T., Lee S.B., Kim G.Y., Park Y.J., and Kim H.G.., Synthesis of LiFePO4 with fine particle by co-precipitation method, Mater. Res. Bull., 2004, 39(12): 1803.
Cho T.H. and Chung H.T., Synthesis of olivine-type LiFePO4 by emulsion-drying method, J. Power Sources, 2004, 133(2): 272.
Yang J.S. and Xu J.J., Nonaqueous sol-gel synthesis of high-performance LiFePO4. Electrochem. Solid State Lett., 2004, 7(12): A515.
Wang G.X., Bewlay S., and Yao J., Characterization of LiMxFe1−x PO4 (M = Mg, Zr, Ti) cathode materials prepared by the sol-gel method, Electrochem. Solid State Lett., 2004, 7(12): A503.
Hong J., Wang C.S., and Kasavajjula U., Kinetic behavior of LiFeMgPO4 cathode material for Li-ion batteries, J. Power Sources, 2006, 162(2): 1289.
Hu G.R., Gao X.G., Peng Z.D., Du K., Tan X.Y., and Liu Y.J., Influence of Ti4+ doping on electrochemical properties of LiFePO4/C cathode material for lithium-ion batteries, Trans. Nonferrous Met. Soc. Chin. 2007, 17(2): 296.
Belharouak I., Johnson C., and Amine. K., Synthesis and electrochemical analysis of vapor-deposited carbon-coated LiFePO4, Electrochem. Commun., 2005, 7(10): 983.
Shin H.C., Cho W., and Jang H., Electrochemical properties of carbon-coated LiFePO4 cathode using graphite, carbon black, and acetylene black, Electrochim. Acta, 2006, 52(4): 1472.
Peng Z.D., Gao X.G., Hu G.R., Tan X.Y., Du K., Deng X.R., and Liu Y.X., Technological optimization of LiFePO4 preparation by water quenching treatment, J. Cent. South Univ. Technol., 2007, 14(5): 56
Wang L.N., Zhang Z.G., and Zhang K.L., A simple, cheap soft synthesis routine for LiFePO4 using iron(III) raw material, J. Power Sources, 2007, 167(1): 200.
Liu H., Xie J.Y., and Wang K., Synthesis and characterization of LiFePO4/(C + Fe2P) composite cathodes, Solid State Ionics, 2008, 179(27–32): 1768.
Kuwahara A., Suzuki S., and Miyayama M., High-rate properties of LiFePO4/carbon composites as cathode materials for lithium-ion batteries, Ceram. Int., 2008, 34(4): 863.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Peng, Z., Cao, Y., Zhou, Y. et al. Synthesis of LiFePO4 using FeSO4·7H2O byproduct from TiO2 production as raw material. Rare Metals 28, 612–617 (2009). https://doi.org/10.1007/s12598-009-0117-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12598-009-0117-0