Abstract
This research conducted a triaxial test on lime-treated clay with different contents to analyze the effect of mechanical properties. Scanning electron microscope (SEM) and low-field nuclear magnetic resonance (NMR) analysis were used to analyze the effect. X-ray diffraction (XRD) was used to analyze the chemical changes of calcium oxide on red clay. The results show that with the increase of calcium oxide content, the strength increases, and it can be increased by 282% at 200 kPa confining pressure. The calcium oxide in the red clay reacted with the water in the soil to form calcium hydroxide. The alkaline environment will erode the edge of the soil particles and cause pores to become larger. SEM observed that the addition of calcium oxide caused the agglomeration of soil particles and changed the pore structure of red clay. Low-field NMR showed that calcium oxide had a significant effect on the pore structure of red clay. Calcium oxide increased the total pore volume of the soil sample. Calcium oxide had a substantial influence on the three pore distribution ranges, I (1.1–11 µm), II (15–137 µm), and III (137–512 µm). The porosity fitted with shear strength, it negatively correlated with I and III, and positively correlated with II.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
Al-Mukhtar M, Belanteur N, Tessier D, Vanapalli S (1996) The fabric of a clay soil under controlled mechanical and hydraulic stress states. Applied Clay Science 11(2–4):99–115, DOI: https://doi.org/10.1016/S0169-1317(96)00023-3
Alonso E, Pinyol N, Gens A (2013) Compacted soil behaviour: Initial state, structure and constitutive modelling. Géotechnique 63(6):463–478, DOI: https://doi.org/10.1680/geot.11.P.134
ASTM D2850-15 (2013) Standard test method for unconsolidated-undrained triaxial compression test on cohesive soils. ASTM D2850-15, West Conshohocken, PA, USA
Bell FG (1996) Lime stabilization of clay minerals and soils. Engineering Geology 42(4):223–237, DOI: https://doi.org/10.1016/0013-7952(96)00028-2
Bozbey I (2018) Microfabric evaluation of lime-treated clays by mercury intrusion porosimetry and environment scanning electron microscopy. International Journal of Civil Engineering 16(4B):443–456, DOI: https://doi.org/10.1007/s40999-017-0151-5
Changizi F, Haddad A (2017) Effect of nanocomposite on the strength parameters of soil. KSCE Journal of Civil Engineering 21(3):676–686, DOI: https://doi.org/10.1007/s12205-016-1471-8
Chen L, Chen, Yang X, Bi P, Ding X, Huang X, Wang H (2020) Effect of calcium carbonate on the mechanical properties and microstructure of red clay. Advances in Materials Science and Engineering 2020, DOI: https://doi.org/10.1155/2020/5298186
Daigle H, Johnson A (2016) Combining mercury intrusion and nuclear magnetic resonance measurements using percolation theory. Transport in Porous Media 111(3):669–679, DOI: https://doi.org/10.1007/s11242-015-0619-1
Delage P, Lefebvre G (1984) Study of the structure of a sensitive Champlain clay and of its evolution during consolidation. Canadian Geotechnical Journal 21(1):21–35, DOI: https://doi.org/10.1139/t84-003
Eisazadeh A, Kassim K, Nur H (2012) Stabilization of tropical kaolin soil with phosphoric acid and lime. Natural Hazards Journal 61(3):931–942, DOI: https://doi.org/10.1007/s11069-011-9941-2
Eltwati A, Tarhuni F, Elkaseh A (2020) Engineering properties of clayey soil stabilized with waste granite dust. Journal of Critical Reviews 7(16):794–802
Fisher RA (1919) XV. The correlation between relatives on the supposition of mendelian inheritance. Transactions of the Royal Society of Edinburgh 52(2):399–33, DOI: https://doi.org/10.1017/S0080456800012163
Fleury M, Berthe G, Chevalier T (2019). Diffusion of water in industrial cement and concrete. Magnetic Resonance Imaging 56:32–36, DOI: https://doi.org/10.1016/j.mri.2018.09.010
Gallegos DP, Smith DM (1988) A NMR technique for the analysis of pore structure: Determination of continuous pore size distributions. Journal of Colloid and Interface Science 122(1):143–153, DOI: https://doi.org/10.1016/0021-9797(88)90297-4
GB/T 50123-1999 (1999) National standard of the People’s Republic of China. Standard for geotechnical testing method. GB/T 50123-1999, CSBTS & Ministry of Construction, Beijing, China
Ghobadi MH, Abdilor Y, Babazadeh R (2014) Stabilization of clay soils using lime and effect of pH variations on shear strength parameters. Bulletin of Engineering Geology and the Environment 73(2):611–619, DOI: https://doi.org/10.1007/s10064-013-0563-7
Guidobaldi G, Cambi C, Cecconi M, Comodi P, Deneele D, Paris M, Russo G, Vitale E, Zucchini A (2018). Chemo-mineralogical evolution and microstructural modifications of a lime treated pyroclastic soil. Engineering Geology 245:333–343, DOI: https://doi.org/10.1016/j.enggeo.2018.09.012
Jaeger F, Bowe S, van As H, Schaumann G (2009) Evaluation of 1H NMR relaxometry for the assessment of pore-size distribution in soil samples. European Journal of Soil Science 60(6):1052–1064, DOI: https://doi.org/10.1111/j.1365-2389.2009.01192.x
Kilic R, Kucukali O, Ulamis K (2016) Stabilization of high plasticity clay with lime and gypsum (Ankara, Turkey). Bulletin of Engineering Geology and the Environment 75(2):735–744, DOI: https://doi.org/10.1007/s10064-015-0757-2
Koliji A, Vulliet L, Laloui L (2010) Structural characterization of unsaturated aggregated soil. Canadian Geotechnical Journal 47(3):297–311, DOI: https://doi.org/10.1139/T09-089
Lemaire K, Deneele D, Bonnet S, Legret M (2013). Effects of lime and cement treatment on the physicochemical, microstructural and mechanical characteristics of a plastic silt. Engineering Geology 166:255–261, DOI: https://doi.org/10.1016/j.enggeo.2013.09.012
Liang C, Xiao LZ, Zhou CC, Zhang Y, Liao GZ, Jia ZJ (2019). Two-dimensional nuclear magnetic resonance method for wettability determination of tight sand. Magnetic Resonance Imaging 56:144–150, DOI: https://doi.org/10.1016/j.mri.2018.09.020
Lin BT, Cerato AB (2015) Shear strength of shale weathered expansive soils along swell-shrink paths: Analysis based on microscopic properties. Environmental Earth Sciences 74(9):6887–6899, DOI: https://doi.org/10.1007/s12665-015-4691-1
Liu Y, Li Z, Guo L, Kang W, Zhou Y (2018) Pore characteristics of soft soil under triaxial shearing measured with NMR. Chinese Journal of Rock Mechanics and Engineering 37(08):1924–1932, DOI: https://doi.org/10.13722/j.cnki.jrme.2018.0118 (in Chinese)
Lv Q, Chang C, Zhao B, Ma B (2018) Loess soil stabilization by means of SiO2 nanoparticles. Soil Mechanics and Foundation Engineering 54(6):409–413, DOI: https://doi.org/10.1007/s11204-018-9488-2
Oualmakran M, Mercatoris B, Francois B (2016) Pore-size distribution of a compacted silty soil after compaction, saturation, and loading. Canadian Geotechnical Journal 53(12):1902–1909, DOI: https://doi.org/10.1139/cgj-2016-0184
Saba S, Delage P, Lenoir N, Cui YJ, Tang AM, Bamichon JD (2014). Further insight into the microstructure of compacted bentonite-sand mixture. Engineering Geology 168:141–148, DOI: https://doi.org/10.1016/j.enggeo.2013.11.007
Saeed KA, Kassim KA, Nur H (2015) Strength of lime-cement stabilized tropical lateritic clay contaminated by heavy metals. KSCE Journal of Civil Engineering 19(5):887–892, DOI: https://doi.org/10.1007/s12205-013-0086-6
Sakr MA, Shahin MA, Metwally YM (2008) Utilization of lime for stabilizing soft clay soil of high organic content. Geotechnical and Geological Engineering 27(1):105, DOI: https://doi.org/10.1007/s10706-008-9215-2
Shan Y, Mo H, Yu S, Chen J (2016) Analysis of the maximum dynamic shear modulus and particle arrangement properties of saturated soft clay soils. Soil Mechanics and Foundation Engineering 53(4):226–232, DOI: https://doi.org/10.1007/s11204-016-9390-8
Tchalenko J, Morgenstern N (1967) Microscopic structures in kaolin subjected to direct shear. Géotechnique 17(4):309–328, DOI: https://doi.org/10.1680/geot.1967.17.4.309
Tovey N (1980) A digital computer technique for orientation analysis of micrographs of soil fabric. Journal of Microscopy 120(3):303–315, DOI: https://doi.org/10.1111/j.1365-2818.1980.tb04150.x
Wang S, Chen Z, Li X, Peng Z, Yuan J (2012) Pore-damage evolution and mechanical properties of remolded soil by CT-triaxial test. Transactions of the Chinese Society of Agricultural Engineering 28(07):150–154, DOI: https://doi.org/10.3969/j.issn.1002-6819.2012.07.025 (in Chinese)
Wang J, Xiao LZ, Liao GZ, Zhang Y, Cui YS, Sun Z, Dong Y, Hu L (2019). NMR characterizing mixed wettability under intermediate-wet condition. Magnetic Resonance Imaging 56:156–160, DOI: https://doi.org/10.1016/j.mri.2018.09.023
Yunus NZM, Wanatowski D, Hassan NA (2016) Shear strength and compressibility behaviour of lime-treated organic clay. KSCE Journal of Civil Engineering 20(7):1721–1727, DOI: https://doi.org/10.1007/s12205-015-0438-5
Zhao H, Ge L, Petry T, Sun Y (2014) Effects of chemical stabilizers on an expansive clay. KSCE Journal of Civil Engineering 18(5):1009–1017, DOI: https://doi.org/10.1007/s12205-013-1014-5
Zimmermann I, Filser S, Mordhorst A, Fleige H, Horn R (2019) Structural stabilization of soil backfill with quicklime. Journal of Plant Nutrition and Soil Science 182(4):578–585, DOI: https://doi.org/10.1002/jpln.201800511
Acknowledgments
This study was supported by the National Natural Science Foundation of China (No. 41762022 and 41967037).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Chen, L., Chen, X., Wang, H. et al. Mechanical Properties and Microstructure of Lime-Treated Red Clay. KSCE J Civ Eng 25, 70–77 (2021). https://doi.org/10.1007/s12205-020-0497-0
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-020-0497-0