Abstract
Communication systems such as those used on satellite platforms demand high performance from individual components that make up the various systems and sub-systems. Switching and routing of RF signals between various modules is a routine and critical operation that determines the overall efficiency of the entire system. In this paper, we present the design and fabrication aspects of a direct contact RF MEMS switch designed to operate in the X band (8–12 GHz) with a target insertion of about 0·5 dB and isolation better than 30 dB. The actuation voltage is expected to be around 50 V. The die size is designed to be 3 mm (H) × 3 mm(W) × 2 mm(H). The switch is built from a low residual stress device layer of a highly conducting (0·005 Ohms-cm) silicon on insulator (SOI) wafer. After subsequent lithographic steps, the wafer is bonded to a Pyrex glass wafer which has been previously patterned with gold transmission lines and pull in electrodes. Being built from a single crystal silicon structure, the mechanical robustness of the actuator is much greater than the those in similar membrane-based devices. A 6 mask fabrication process utilizing Deep Reactive Ion Etching to achieve high aspect ratio stiction free structures was developed and implemented. Devices from the first fabrication run are being analysed in our laboratory.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Kim Jong-Man, Jae-Hyoung Park, Chang-Wook Baek, Yong-Kweon Kim 2004 The SiOG-based single crystalline silicon (SCS) RFMEMS switch with uniform characteristics. J. Microelectromechanical Systems 13: 1036–1042
Kim Jong-Man, Sanghyo Lee, Jung-Mu Kim, Chang-Wook Baek, Youngwoo Kwon, Yong-Kweon Kim 2005 A Mechanically reliable digital-type single crystalline silicon (SCS) RF MEMS variable capacitor. J. Micromechanics and Microengineering 15: 1854–1836
Rebeiz M Gabriel 2003 RF MEMS Theory, design and technology, (Hoboken: John Wiely and Sons)
Sakatak M, Komura Y, Seki T, Kobayashi K, Sano K, Horike S 1999 Micromachined relay which uses single crystal silicon electrostatic actuator, 12th IEEE International Conf. on Microelectromechanical Systems 21–24
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Giridhar, M.S., Jambhalikar, A., John, J. et al. An X band RF MEMS switch based on silicon-on-glass architecture. Sadhana 34, 625–631 (2009). https://doi.org/10.1007/s12046-009-0026-9
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12046-009-0026-9