Results of measurement of torsional strength of the weld joint of the VT6 titanium alloy produced by linear friction welding are presented. For a comparison, the same method was used to test monolithic specimens of the VT6 alloy. Torsional strength values of the weld joint (τUS = 861 MPa and φ = 110°) correspond to the strength of the monolithic material. In this case, the specimens fail along the base metal.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
A. Varis and M. Frost, Mat. Sсi. Eng., A271, 477–484 (1999).
W.-Y. Li, T. J. Ma, S. Q. Yang, et al., Mater. Lett., 62, 293–296 (2008).
P. E. Denney and E. A. Metzbower, Weld. J., 68, 342s–346s (1989).
P. S. Liu, W. A. Baeslack, and J. Hurley, Weld. J., 73, 175s–181s (1994).
W. A. Baeslack, J. Mater. Sci. Lett., 1, 229–231 (1982).
P. Wanjara and M. Jahazi, Metall. Mater. Trans., A36, 2149–2164 (2005).
M. V. Karavaeva, S. K. Kiseleva, V. M. Bychkov, et al., Pis’ma Mater., 2, No. 1, 40–44 (2012).
E. A. Borisov, Metallography of Titanium Alloys [in Russian], Metallurgiya, Moscow (1980).
GOST 3565-80 “Metals. Torsion Test Method.”
T. A. Gordeeva and I. P. Zhegina, Analysis of Kinks in the Estimation of the Reliability of Materials [in Russian], Machinostroenie, Moscow (1978).
Author information
Authors and Affiliations
Corresponding author
Additional information
Translated from Izvestiya Vysshikh Uchebnykh Zavedenii, Fizika, No. 6, pp. 67–73, June, 2015.
Rights and permissions
About this article
Cite this article
Suleimanova, G.R., Kabirov, R.R., Karavaeva, M.V. et al. Investigation of Torsional Strength of the VT6 Weld Joint Produced by Linear Friction Welding. Russ Phys J 58, 815–821 (2015). https://doi.org/10.1007/s11182-015-0574-x
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11182-015-0574-x