Abstract
This paper discusses some methodological questions regarding the application of EMG-driven models to estimate muscle forces, for the triceps surae performing isometric contractions. Ankle torque is estimated from a Hill-type muscle model driven by EMG data, collected from the three components of triceps surae and tibialis anterior. Ankle joint torque is synchronously collected from a dynamometer, which is compared to the sum of each muscle force multiplied by the respective ankle moment arm. A protocol consisting of two steps of low and medium/high loads is used. Raw EMG signal is processed and used as the input signal for the muscle model. The difference between simulated and dynamometer measured torque is calculated as the RMS error between the two curves. A set of nominal muscle model parameters is initially chosen from literature (e.g., OpenSim), which allows observing the characteristics of the error distribution. One possibility to improve model accuracy is using individual muscle parameters. We investigated the effect of applying simple scale factors to the nominal muscle model parameters and using ultrasound for estimating muscle maximum force. Other questions regarding muscle model improvements are also addressed, such as using a nonlinear formulation of activation dynamics and variable pennation angle. Surface EMG signals acquisition and processing can also affect force estimation accuracy. Electrodes positioning can influence signal amplitude, and the one-channel EMG may not represent actual excitation for the whole muscle. We have shown that high density EMG reduces, in some cases, the torque estimation error.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
References
Fleming, B.C., Beynnon, B.D.: In Vivo measurement of ligament/tendon strains and forces: a review. Ann. Biomed. Eng. 32, 318–328 (2004)
Yeadon, M.R., King, M.A., Wilson, C.: Modeling the maximum voluntary joint torque/angular velocity relationship in human movement. J. Biomech. 39, 476–482 (2006)
Anderson, D.E., Madigana, M.L., Nussbaum, M.A.: Maximum voluntary joint torque as a function of joint angle and angular velocity: model development and application to the lower limb. J. Biomech. 40, 3105–3113 (2007)
Thelen, D.G., Schultz, A.B., Alexander, N.B., Ashton-Miller, J.A.: Effects of age on rapid ankle torque development. J. Gerontol. 5IA(5), M226–M232 (1996)
DeVita, P., Hortobagyi, T.: Obesity is not associated with increased knee joint torque and power during level walking. J. Biomech. 36, 1355–1362 (2003)
Menegaldo, L.L., Fleury, A.T., Weber, H.I.: Biomechanical modeling and optimal control of human posture. J. Biomech. 36, 1701–1712 (2003)
Anderson, F.C., Pandy, M.G.: Dynamic optimization of human walking. J. Biomech. Eng. 123, 381–391 (2001)
Ackermann, M., van den Bogert, A.J.: Optimality principles for model-based prediction of human gait. J. Biomech. 43, 1055–1060 (2010)
Yamaguchi, G.T., Moran, D.W., Si, J.: A computationally efficient method for solving the redundant problem in biomechanics. J. Biomech. 28, 999–1005 (1995)
Bottasso, C.L., Prilutsky, B.I., Croce, A., Imberti, E., Sartirana, S.: A numerical procedure for inferring from experimental data the optimization cost functions using a multibody model of the neuro-musculoskeletal system. Multibody Syst. Dyn. 16, 123–154 (2006)
Beck, T.W., DeFreitas, J.M., Stock, M.S., Dillon, M.A.: Comparison of the muscle activation pattern for the vastus lateralis before and after an 8-week resistance training program. Biomed. Signal Process. Control 5, 264–270 (2010)
Clancy, E.A., Hogan, N.: Multiple site electromyography amplitude estimation. IEEE Trans. Biomed. Eng. 42, 203–211 (1995)
Lloyd, D.G., Besier, T.F.: An EMG-driven musculoskeletal model to estimate muscle forces and knee joint moments in vivo. J. Biomech. 36, 765–776 (2003)
Langenderfer, J., LaScalza, S., Mell, A., Carpenter, J.E., Kuhn, J.E., Hughes, R.E.: An EMG-driven model of the upper extremity and estimation of long head biceps force. Comput. Biol. Med. 35, 25–39 (2005)
Blajer, W., Czaplicki, A., Dziewiecki, K., Mazur, Z.: Influence of selected modeling and computational issues on muscle force estimates. Multibody Syst. Dyn. 24, 473–492 (2010)
Menegaldo, L.L., Oliveira, L.F.: Effect of muscle model parameter scaling for isometric plantar flexion torque prediction. J. Biomech. 42, 2597–2601 (2009)
Oliveira, L.F., Vieira, T.M.M., Menegaldo, L.L., Merletti, R.: Can the use of a high density EMG system improve a biomechanical model for predicting ankle plantar flexors force. In: Proceedings of 22th ISB Congress, Cape Town, South Africa (2009)
Oliveira, L.F., Menegaldo, L.L.: Study of muscle torque sharing patterns in isometric plantar flexion by an EMG-driven biomechanical model. In: Proceedings of the Annual Meeting of the American Society of Biomechanics, State College, PA (2009)
Oliveira, L.F., Menegaldo, L.L.: Input error in an EMG-driven muscle model: an analysis based on isometric plantar flexion (2011 submitted)
Oliveira, L.F., Menegaldo, L.L.: Individual-specific muscle maximum force estimation using ultrasound for ankle joint torque prediction using an EMG-driven Hill-type model. J. Biomech. 43, 2816–2821 (2010)
Menegaldo, L.L., Oliveira, L.F.: Plantar flexors isometric force distribution patterns with the knee extended or flexed. In: Abstracts of 6th World Congress of Biomechanics, Singapore (2010)
Oliveira, L.F., Menegaldo, L.L.: Torque sharing in submaximal isometric plantar flexion: an analysis based on an EMG-driven muscle model. In: Proceedings of XXII Brazilian Congress on Biomedical Engineering, Tiradentes, Brazil (2010)
Silva, M.P.T., Ambrósio, J.A.C.: Kinematic Data Consistency in the Inverse Dynamic Analysis of Biomechanical Systems. Multibody Syst. Dyn. 8, 219–239 (2002)
Piazza, S.J., Delp, S.L.: The influence of muscles on knee flexion during the swing phase of gait. J. Biomech. 29, 723–733 (1996)
Zajac, F.E.: Muscle and tendon: properties, models, scaling and application to biomechanics and motor control. CRC. Crit. Rev. Biomed. Eng. 17, 359–411 (1989)
Menegaldo, L.L., Fleury, A.T., Weber, H.I.: Moment arms and musculotendon lengths estimation for a three-dimensional lower-limb model. J. Biomech. 37, 1447–1453 (2004)
Brand, R., Crowninshield, R., Wittstock, C., Pedersen, D., Clark, C., Van Frieken, F.: A model of lower extremity muscular anatomy. J. Biomech. Eng. 104, 304–310 (1982)
Wickiewicz, T.L., Roy, R.R., Powell, P.L., Edgerton, V.R.: Muscle architecture of the human lower limb. Clin. Orthop. Relat. Res. 179, 275–283 (1983)
Delp, S.L., Anderson, F.C., Arnold, A.S., Loan, P., Habib, A., John, C., Guendelman, E., Thelen, D.G.: OpenSim: open-source software to create and analyze dynamic simulations of movement. IEEE Trans. Biomed. Eng. 54, 1940–1950 (2007)
Garner, B.A., Pandy, M.G.: Estimation of musculotendon properties in the human upper limb. Ann. Biomed. Eng. 31, 207–220 (2003)
Redl, C., Gfoehler, M., Pandy, M.G.: Sensitivity of muscle force estimates to variations in muscle–tendon properties. Hum. Mov. Sci. 26, 306–319 (2007)
Buchanan, T.S., Lloyd, D.G., Manal, K., Besier, T.F.: Neuromusculoskeletal modeling: estimation of muscle forces and joint moments and movements from measurements of neural command. J. Appl. Biomech. 20, 367–395 (2004)
Manal, K., Buchanan, T.S.: Subject-specific estimates of tendon slack length: a numerical method. J. Appl. Biomech. 20, 195–203 (2004)
Winby, C.R., Lloyd, D.G., Kirk, T.B.: Evaluation of different analytical methods for subject-specific scaling of musculotendon parameters. J. Biomech. 41, 1682–1688 (2008)
Miyatani, M., Kanechisa, H., Ito, M., Kawakami, Y., Fukunaga, T.: The accuracy of volume estimates using ultrasound muscle thickness measurements in different muscle groups. Eur. J. Appl. Physiol. 91, 264–272 (2004)
Ward, S.R., Eng, C.M., Smallwood, L.H., Lieber, R.L.: Are current measurements of lower extremity muscle architecture accurate? Clin. Orthop. Relat. Res. 467, 1074–1082 (2009)
Powell, P.L., Roy, R.R., Kanim, P., Bello, M.A., Edgerton, V.R.: Predictability of skeletal muscle tension from architectural determinations in guinea pig hindlimbs. J. Appl. Physiol. 57, 1715–1721 (1984)
Hoy, M.G., Zajac, F.E., Gordon, M.E.: A musculoskeletal model of the human lower extremity: the effect of muscle, tendon, and moment arm on the moment-angle relationship of musculotendon actuators at the hip, knee, and ankle. J. Biomech. 23, 157–169 (1990)
Buchanan, T.S.: Evidence that maximum muscle stress is not a constant: differences in specific tension in elbow flexors and extensors. Med. Eng. Phys. 17, 529–536 (1995)
Narici, M.V., Roi, G.S., Landoni, L., Minetti, A.E., Cerretelli, P.: Changes in force, cross-sectional area and neural activation during strength training and detraining of the human quadriceps. Eur. J. Appl. Physiol. Occup. Physiol. 59, 310–319 (1989)
Kawakami, Y., Abe, T., Kuno, S.-Y., Fukunaga, T.: Training-induced changes in muscle architecture and specific tension. Eur. J. Appl. Physiol. Occup. Physiol. 72, 37–43 (1995)
Menegaldo, L.L., Oliveira, L.F.: An EMG-driven model to evaluate quadriceps strengthening after an isokinetic training. Procedia IUTAM 2, 131–141 (2011)
Woods, J.J., Bigland-Ritchie, B.: Linear and nonlinear surface EMG/force relationships in human muscles. An anatomical/functional argument for the existence of both. Am. J. Phys. Med. 62, 287–299 (1983)
Manal, K., Buchanan, T.S.: One-parameter neural activation to muscle activation model: estimating isometric joint moments from electromyograms. J. Biomech. 36, 1197–1202 (2003)
Kawakami, Y., Ichinose, Y., Fukunaga, T.: Architectural and functional features of human triceps surae muscles during contraction. J. Appl. Physiol. 85, 398–404 (1998)
Maganaris, C.N.: A predictive model of moment-angle characteristics in human skeletal muscle: application and validation in muscles across the ankle joint. J. Theor. Biol. 230, 89–98 (2004)
Karamanidis, K., Stafilidis, S., DeMonte, G., Morey-Klapsing, G., Bruggemann, G., Arampatzis, A.: Inevitable joint angular rotation affects muscle architecture during isometric contraction. J. Electromyogr. Kinesiol. 15, 608–616 (2005)
Clancy, E.A., Morin, E.L., Merletti, R.: Sampling, noise-reduction and amplitude estimation issues in surface electromyography. J. Electromyogr. Kinesiol. 12, 1–16 (2002)
Alonso, F.J., Del Castillo, J.M., Pintado, P.: Application of singular spectrum analysis to the smoothing of raw kinematic signals. J. Biomech. 38, 1085–1092 (2005)
Farina, D., Merletti, R., Enoka, R.: The extraction of neural strategies from the surface EMG. J. Appl. Physiol. 96, 1486–1495 (2004)
Merletti, R., Holobar, A., Farina, D.: Analysis of motor units with high-density electromyography. J. Electromyogr. Kinesiol. 18, 879–890 (2008)
Cavalcanti Garcia, M.A., Vieira, T.M.M.: Surface electromyography: why, when and how to use it. Rev. Andal Med. Deporte 04, 17–28 (2011)
Staudenmann, D., Kingma, I., Daffertshofer, A., Stegeman, D.F., van Dieen, J.H.: Towards optimal multi-channel EMG electrode configurations in muscle force estimation: a high-density EMG study. J. Electromyogr. Kinesiol. 15, 1–11 (2005)
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Menegaldo, L.L., Oliveira, L.F. The influence of modeling hypothesis and experimental methodologies in the accuracy of muscle force estimation using EMG-driven models. Multibody Syst Dyn 28, 21–36 (2012). https://doi.org/10.1007/s11044-011-9273-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11044-011-9273-8