Abstract
In this paper a general formula for finding the maximum allowable dynamic load (MADL) of flexible link mobile manipulators is presented. The main constraints used for the proposed algorithm are the actuator torque capacity and the limited error bound for the end-effector during motion on a given trajectory. The accuracy constraint is taken into account with two boundary lines which are equally offset due to the given end-effector trajectory, while a speed-torque characteristics curve of a typical DC motor, is used for applying the actuator torque constraint. Finite element method (FEM), which is able to consider the full nonlinear dynamic of mobile manipulator is applied to derive the kinematic and dynamic equations. In order to verify the effectiveness of the presented algorithm, two simulation studies considering a flexible two-link planar manipulator mounted on a mobile base are presented and the results are discussed.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Thomas M, Yuan-Chou HC, Tesar D (1985) Optimal actuator sizing for robotic manipulators based on local dynamic criteria. J Mech Transm Autom Des 107:163–169
Wang LT, Ravani B (1988) Dynamic load carrying capacity of mechanical manipulators. Part I, problem formulation. J Dyn Syst Meas Control 110:46–52
Wang LT, Ravani B (1988) Dynamic load carrying capacity of mechanical manipulators. Part II, computational procedure and applications. J Dyn Syst Meas Control 110:53–61
Korayem MH, Basu A (1994) Formulation and numerical solution of elastic robot dynamic motion with maximum load carrying capacity. Robotica 12:253–261
Korayem MH, Basu A (1994) Dynamic load carrying capacity for robotic manipulators with joint elasticity imposing accuracy constraints. J. of Robotic and Autonomous Systems 13:219–229
Yue S, Tso SK, Xu WL (2001) Maximum dynamic payload trajectory for flexible robot manipulators with kinematic redundancy. Mech Mach Theory 36:785–800
Korayem MH, Ghariblu H (2003) Maximum allowable load on wheeled mobile manipulators imposing redundancy constraints. J. of Robotic and Autonomous Systems 44(2):151–159
Rey DA, Papadopoulos EG (1997) Online automatic tip-over presentation for mobile and redundant manipulators. Proc. of the IEEE International Conference on Intelligent Robots and Systems (IROS’97) 1273–1278
Papadopoulos E, Gonthier Y (1999) A frame force for large force task planning of mobile and redundant manipulators. J Robot Syst 16(3):151–162
Seraji H (1998) A unified approach to motion control of mobile manipulators. J. of Robot Research 17(12):107–118
Chung PH et al. An extension to operational space for kinematically redundant manipulators: kinematics and dynamics. IEEE International Conference on Robotics and Automation 16(5):592–596
Usoro PB, Nadira R, Mahil (1986) A finite element-lagrange approach to modeling lightweight flexible manipulators. J Dyn Syst Meas Control 108:198–205
Heidari A (2005) Maximum dynamic load carrying capacity for flexible robot manipulators with finite element approach. M.Sc. Thesis, Mechanical Engineering Department, Iran University Science and Technology, October 2005
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Korayem, M.H., Heidari, A. & Nikoobin, A. Maximum allowable dynamic load of flexible mobile manipulators using finite element approach. Int J Adv Manuf Technol 36, 606–617 (2008). https://doi.org/10.1007/s00170-006-0863-1
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s00170-006-0863-1