Abstract
In this study, friction spot joining (FSJ) was applied to dual-phase steel DP980 using a newly-developed silicon nitride (Si3N4) tool with a threaded pin, after which microstructure and strength of the joint were examined. The cross-sectional microstructure was distinctly classified into four zones which experienced the different heat cycles and deformation histories during FSJ. Electron probe micro analyzer revealed that silicon, oxygen and nitrogen were involved in the alternate band patterns observed in the stir zone, which could be attributed to contamination from the tool. The contamination was prevented by coating of the tool surface and the use of Ar shielding. The mechanical tests showed that the contamination reduced the joint strength, especially the cross tensile strength.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Tumuluru M.D: Resistance spot welding of coated high-strength dual-phase steels, Welding Journal, 2006, vol. 85, no. 8, pp. 31–37.
Peterson W.: Dilution of weld metal to eliminate interfacial fractures of spot welds in high and ultra high strength steels, Proceedings of International Conference on Advances in Welding Technology, Columbus, OH, September 1997, pp. 331–346.
Ferrasse S., Verrier P., Meesemaecker F.: Resistance spot weldability of high strength steels for use in car industry, Doc. IIW-1369-97 (ex-doc. III-1076–97), Welding in the World, 1998, vol. 41, no. 3, pp. 177–195.
Yoshitake A., Yasuda K.: Vision of application technologies for high strength steel sheets supporting automobile weight reduction, JFE technical report, 2007, 10, pp. 1–7.
Wada S.: Control of instability of Si3N4 during pressureless sintering, Journal of the Ceramic Society of Japan, 2001, 109, pp. 803–808.
Oikawa H., Murayama G., Hiwatashi S., Matsuyama K: Resistance spot weldability of high strength steel sheets for automobiles and the quality assurance of joints, Doc. IIW-1783-06 (ex-doc. III-1382–06), Welding in the World, 2007, vol. 51, no. 3/4, pp. 7–18.
Ohashi R., Fujimoto M., Ikeda R., Ono M.: Proceedings 7th International Symposium on Friction Stir Welding Conference, Awaji, Japan, 2008.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Ohashi, R., Fujimoto, M., Mironov, S. et al. Friction Spot Joining of High Strength Steel Sheets for Automotives. Weld World 53, 23–27 (2009). https://doi.org/10.1007/BF03266711
Published:
Issue Date:
DOI: https://doi.org/10.1007/BF03266711