Abstract
A method is proposed for calculating the cutting characteristics in the end milling of stainless steel workpieces. The calculation is based on analysis of the parameters for the chip-formation zone and takes account of softening of the material under the action of the cutting temperature. The calculated tool life and the torque are approximated by polynomial equations, which may be used to calculate the constraints on milling and to optimize the machining conditions.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Rott, O., Homberg, D., and Mense, C., A comparison of analytical cutting force models, Preprint of the Weierstrass Institute for Applied Analysis and Stochastics, Berlin, 2006, no. 1151.
Altintas, Y., Manufacturing Automation, Cambridge: Cambridge Univ. Press, 2000.
Faassen, R.P.H., Wouw van de, N., Oosterling, J.A.J., and Nijmeijer, H., Prediction of regenerative chatter by modeling and analysis of high-speed milling, Int. J. Mach. Tools Manuf., 2003, vol. 43, pp. 1437–1446.
GARANT, Handbook on cutting. http://www.hoffmann- group.com/fileadmin/catalog/en/BK_ZHB_ 2009_en/blaetterkatalog/index.html.
Grubyi, S.V., Modelirovanie protsessa rezaniya tverdosplavnym i almaznymi reztsami: uchebnoe posobie (Modeling of Cutting Process by Carbide and Diamond Tools: Manual), Moscow: Mosk. Gos. Tekh. Univ. im. N.E. Baumana, 2010.
Grubyi, S.V., Fizicheskie zakonomernosti protsessa iznashivaniya tverdosplavnykh i instrumentov: uchebnoe posobie (The Physical Principles of Wear of Carbide and Diamond Tools: Manual), Moscow: Mosk. Gos. Tekh. Univ. im. N.E. Baumana, 2013.
Grubyi, S.V. and Zaitsev, A.M., Analysis of the end mills after milling of case parts of aluminium alloys, Nauka Obraz., 2013, no. 12. http://technomag. bmstu.ru/doc/634375.html.
Grubyi, S.V. and Zaitsev, A.M., Description of milling conditions of the pockets in case parts of aluminium alloys, Nauka Obraz., 2014, no. 5. http://technomag. bmstu.ru/doc/709770.html.
Reznikov, A.N., Teplofizika protsessov mekhanicheskoi obrabotki materialov (Thermal Physics of Mechanical Treatment of Materials), Moscow: Mashinostroenie, 1981.
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © S.V. Grubyi, 2016, published in Vestnik Mashinostroeniya, 2016, No. 11, pp. 75–82.
About this article
Cite this article
Grubyi, S.V. Cutting characteristics in the end milling of stainless steel. Russ. Engin. Res. 37, 125–133 (2017). https://doi.org/10.3103/S1068798X17020083
Published:
Issue Date:
DOI: https://doi.org/10.3103/S1068798X17020083