Abstract
The structural phase transformations have been revealed and the characteristics of the creep and long-term strength at 650, 670, and 700°C and 60–140 MPa have been determined in six Russian reactor steels with a bcc structure after quenching and high-temperature tempering. Creep tests were carried out using specially designed longitudinal and transverse microsamples, which were fabricated from the shells of the fuel elements used in the BN-600 fast neutron reactor. It has been found that the creep rate of the reactor bcc steels is determined by the stability of the lath martensitic and ferritic structures in relation to the diffusion processes of recovery and recrystallization. The highest-temperature oxide-free steel contains the maximum amount of the refractory elements and carbides. The steel strengthened by the thermally stable Y–Ti nanooxides has a record high-temperature strength. The creep rate at 700°C and 100 MPa in the samples of this steel is lower by an order of magnitude and the time to fracture is 100 times greater than that in the oxide-free reactor steels.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
V. V. Chuev, V. N. Lanskikh, A. N. Ogorodov, A. G. Sheikman, and A. G. Sergeev, “Efficiency of fuel assemblies of fast reactors,” in Studies of Structural Materials of Elements of the Active Zone of Fast Sodium Reactors (Ural. Otd. Ross. Akad. Nauk, Ekaterinburg, 1994), pp. 85–140.
I. A. Portnykh, V. V. Sagaradze, A. V. Kozlov, and L. A. Skryabin, “Relationship of the characteristics of radiation-induced porosity in steel Kh16N15M2GTR (ChS–68) with the temperature and dose of neutron irradiation,” Phys. Met. Metallogr. 94, 95–101 (2002).
A. V. Tselishchev, V. S. Ageev, Y. P. Budanov, A. G. Ioltukhovskii, N. M. Mitrofanova, M. V. Leontieva-Smirnova, I. A. Shkabura, L. M. Zabud’Ko, A. V. Kozlov, V. V. Mal’tsev, and A. V. Povstyanko, “Development of structural steel for fuel elements of sodium-cooled fast reactors,” Atomic Energy 108, 274–280 (2010).
V. V. Sagaradze, B. N. Goshchitskii, V. L. Arbuzov, and Yu. N. Zuev, “Precipitation-hardening austenitic steel for fast neutron reactors,” Metal Sci. Heat Treat. 45, 293–299 (2003).
V. L. Arbuzov, B. N. Gothchitskii, S. E. Danilov, A. E. Kar’kin, V. D. Parkhomenko, V. V. Sagaradze, A. G. Zaluzhnyi, and Y. N. Zuev, “Accumulation and annealing of radiation defects and the hydrogen effect thereon in an austenitic steel 16Cr15Ni3Mo1Ti upon low-temperature neutron and electron irradiation,” Phys. Met. Metallogr. 117, 89–98 (2016).
P. J. Maziasz, “Overview of microstructural evolution in neutron-irradiated austenitic stainless steels,” J. Nucl. Mater. 205, 118–145 (1995).
H. R. Brager, “The effect of cold working and preirradiation heat treatment on void formation in neutronirradiation type 316 stainless steel,” J. Nucl. Mater. 57, 103–113 (1975).
G. R. Odette, “On mechanisms controlling swelling in ferrite and martensite alloys,” J. Nucl. Mater. 155–157, 921–927 (1988).
E. Dequidt, J. Arroyo, and M. Schirra, “The mechanical behavior of newly designed low-activation high chromium martensitic steels,” J. Nucl. Mater. 179–181, 659–662 (1991).
V. L. Arbuzov, V. I. Voronin, B. N. Goschitskiy, S. E. Danilov, V. A. Kazantsev, N. V. Kataeva, V. V. Sagaradze, V. M. Chernov, M. V. Leontieva-Smirnova, and E. M. Mozhanov, “Features of structural and phase states and physical properties of the ferritic and martensitic steel EK-181 after different thermal treatment,” Vopr. At. Nauki Tekhn. Ser.: Mater. Nov. Mater. No. 1, 8–21 (2015).
V. M. Chernov, M. V. Leont’eva-Smirnova, M. M. Potapenko, N. A. Polekhina, I. Yu. Litovchenko, A. N. Tyumentsev, E. G. Astafurova, and L. P. Khromova, “Structure phase transformations and physical properties of ferritic-martensitic 12% chromium steels EK-181 and ChS-139,” Tech. Phys. 61, 97–102 (2016).
A. N. Tyumentsev, V. M. Chernov, M. V. Leont’eva-Smirnova, E. G. Astafurova, N. A. Shevyako, and I. Yu. Litovchenko, “Microstructure of EK-181 ferritic-martensitic steel after heat treatment under various conditions,” Tech. Phys. 57, 48–54 (2012).
A. N. Orlov, A. M. Parshin, and Yu. V. Trushin, “Physical aspects of decrease of irradiation swelling of structural alloys,” Zh. Tekhn. Fiz. 53, 2367–2372 (1983).
V. V. Sagaradze, V. M. Nalesnik, S. S. Lapin, and V. M. Aliabev, “Precipitation hardening and radiation damageability of austenitic stainless steels,” J. Nucl. Mater. 202, 137–144 (1983).
V. V. Sagaradze and S. S. Lapin, “Inconventional approaches to the suppression of irradiation-induced swelling of stainless steels,” Phys. Met. Metallogr. 83, 417–427 (1997).
V. S. Ageev, A. A. Nikitina, B. V. Safronov, V.V. Tsvelev, A. P. Chukanov, N. F. Vil’danova, K. A. Kozlov, T. N. Kochetkova, and V. V. Sagaradze, “Structure and thermal creep of the oxide-dispersionstrengthened EP-450 reactor steel,” Phys. Met. Metallogr. 106, 318–325 (2008).
V. V. Sagaradze, V. I. Shalaev, V. L. Arbuzov, B. N. Goshchitskii, T. Yun, Q. Wan, J. Sun, “Radiation resistance and thermal creep of ODS ferritic steels,” J. Nucl. Mater. 295, 265–272 (2001).
S. Ukai, M. Harada, and H. Okada, “Alloying design of oxide dispersion strengthened ferritic steel for long life FBRs core materials,” J. Nucl. Mater. 204, 65–73 (1993).
I. Monnet, P. Dubuisson, Y. Serruys, M. O. Ruault, O. Kaitasov, and B. Jouffrey, “Microstructural investigation of the stability under irradiation of oxide dispersion strengthened ferritic steels,” J. Nucl. Mater. 335, 311–321 (2004).
C. Crayton, E. Rath, I. Chu, and S. Launois, “Microstructural evolution of Y2O3 and MgAl2O4 ODS EUROFER steels during their elaboration by mechanical milling and hot isostatic pressing,” J. Nucl. Mater. 335, 83–102 (2004).
I. Hilger, M. Tegel, M. J. Gorley, P. S. Grant, T. Weibgarber, and B. Kieback, “The structural changes of Y2O3 in ferritic ODS alloys during milling,” J. Nucl. Mater. 447, 242–247 (2014).
M. Klimiankou, R. Lindau, and A. Möslang, “HRTEM study of yttrium oxide particles in ODS steels for fusion reactor application,” J. Crystal Growth 249, 381–387 (2003).
Author information
Authors and Affiliations
Corresponding author
Additional information
Original Russian Text © V.V. Sagaradze, T.N. Kochetkova, N.V. Kataeva, K.A. Kozlov, V.A. Zavalishin, N.F. Vil’danova, V.S. Ageev, M.V. Leont’eva-Smirnova, A.A. Nikitina, 2017, published in Fizika Metallov i Metallovedenie, 2017, Vol. 118, No. 5, pp. 522–534.
Rights and permissions
About this article
Cite this article
Sagaradze, V.V., Kochetkova, T.N., Kataeva, N.V. et al. Structure and creep of Russian reactor steels with a BCC structure. Phys. Metals Metallogr. 118, 494–506 (2017). https://doi.org/10.1134/S0031918X17050131
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1134/S0031918X17050131