Abstract
Experimental investigations on generic truck models were carried out on the combined drag reducing effects of platooning and base flaps. A towing tank facility was used with model scales of 1:15 and Reynolds numbers of up to 106. Two vehicle and three vehicle configurations with variable intervehicle distances were analyzed without considering the influence of a ground proximity. The potential of two and three vehicle platoons for drag reduction is clearly demonstrated exemplary for flap angles of 15°. Under certain conditions base flaps increase these benefits. However, their effect depends on the intervehicle distance, the flap angle, and the vehicle position within the platoon. The platoon drag can be reduced by additional 25 % when base flaps are added which corresponds to an overall platoon drag reduction of about 40 %.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
Abbreviations
- A :
-
frontal vehicle area, m2
- C d :
-
drag coefficient, []
- c p :
-
pressure coefficient, []
- d :
-
distance normalized with sqrt(A), []
- α :
-
base flap deflection angle, °
References
Betterflow GmbH (2020). http://www.betterflow.com, Accessed on November 23, 2020.
Bilanin, A. J. (1985). Vehicle drag reducer. US Patent No. 4682808.
Boivin, M. and Roberge, K. (2001). Air drag reducing apparatus. US Patent No. 6257654.
Bonnet, C. and Fritz, H. (2000). Fuel consumption reduction in a platoon: Experimental results with two electronically coupled trucks at close spacing. SAE Paper No. 2000-01-3056.
Browand, F. and Hammache, M. (2004). The limits of drag behavior for two bluff bodies in tandem. SAE Paper No. 2004-01-1145.
Browand, F., McArthur, J. and Radovich, C. (2004). Fuel saving achieved in the field test of two tandem trucks. California Partners for Advanced Transit and Highways (PATH). Research Paper No. UCB-ITS-PRR-2004-20.
Browand, F., Radovich, C. and Boivin, M. (2005). Fuel savings by means of flaps attached to the base of a trailer: Field test results. SAE Paper No. 2005-01-1016.
Cooper, K. R. (1985). The effect of front-edge rounding and rear-edge shaping on the aerodynamic drag of bluff vehicles in ground proximity. SAE Trans., 727–757.
Doppenberg, S. P. (2015). Drag Influence of Tails in a Platoon of Bluff Bodies. M. S. Thesis. Delft University, Delft, The Netherlands.
European Truck Platooning Challenge (2016). https://www.eutruckplatooning.com, Accessed on May 12, 2016.
Gad-el-Hak, M. (1987). The water towing tank as an experimental facility. Experiments in Fluids 5, 5, 289–297.
Gheyssens, T. (2016). Aerodynamic Analysis of a Platoon of Bluff Bodies Subjected to Cross Wind, a Numerical Investigation on the Effect of Drag Reduction Devices. Ph. D. Dissertation. Delft University, Delft, The Netherlands.
Göhring, E. and Krämer, W. (1991). Fahrwiderstandsreduzierende massnahmen zur weiteren optimierung der wirtschaftlichkeit von sattelzügen-teil 1. Automobiltechnische Zeitschrift 93,7/8, 434–139.
Gu, Z. (1996). On interference between two circular cylinders at supercritical Reynolds number. J. Wind Engineering and Industrial Aerodynamics 62, 2–3, 175–190.
Hammache, M. and Browand, F. (2004). On the Aerodynamics of Tractor-Trailers. The Aerodynamics of Heavy Vehicles: Trucks, Buses, and Trains (pp. 185–205). Springer, Berlin, Heidelberg. Germany.
Hammache, M., Michaelian, M. and Browand, F. (2002). Aerodynamic forces on truck models, including two trucks in tandem. California Partners for Advanced Transit and Highways (PATH). Research Paper No. UCB-ITS-PRR-2007-27.
Hoerner, S. F. (1965). Fluid-Dynamic Drag. Hoerner Fluid Dynamics. Brick Town, New Jersey, USA.
Hoffmann, F., Schmidt, H. J., Nayeri, C. and Paschereit, O. (2015). Drag reduction using base flaps combined with vortex generators and fluidic oscillators on a bluff body. SAE Int. J. Commercial Vehicles 8,2015-01-2890, 705–712.
Jönsson, M., Wagner, C. and Loose, S. (2014). Particle image velocimetry of the underfloor flow for generic high-speed train models in a water towing tank. Proc. Institution of Mechanical Engineers, Part F: J. Rail and Rapid Transit 228, 2, 194–209.
Koenig, K. and Roshko, A. (1985). An experimental study of geometrical effects on the drag and flow field of two bluff bodies separated by a gap. J. Fluid Mechanics, 156, 167–204.
KONVOI Project (2016). http://www.ika.rwth-aachen.de/de/forschung/projekte/fahrerassistenz-und-fahrzeugf%C3%BChrung/1635-konvoi.html, Accessed on May 12, 2016.
Lammert, M. P., Duran, A., Diez, J., Burton, K. and Nicholson, A. (2014). Effect of platooning on fuel consumption of class 8 vehicles over a range of speeds, following distances, and mass. National Renewable Energy Lab. (NREl). Report No. 2014-01-2438.
Larsson, L., Hammar, L., Nilsson, L. U., Berndtsson, A., Knutson, K. and Danielson, H. (1989). A study of ground simulation-correlation between wind-tunnel and water-basin tests of a full scale car. SAE Trans., 421–446.
Mason, W. T. and Beebe, P. S. (1978). The Drag Related Flow Field Characteristics of Trucks and Buses. Aerodynamic Drag Mechanisms of Bluff Bodies and Road Vehicles (pp. 45–93). Springer. Boston, Massachusetts, USA.
McAuliffe, B. R. and Ahmadi-Baloutaki, M. (2018). A wind-tunnel investigation of the influence of separation distance, lateral stagger, and trailer configuration on the drag-reduction potential of a two-truck platoon. SAE Int. J. Commercial Vehicles 11, 2, 125–150.
Nayeri, C. N., Glas, J. and Paschereit, C. O. (2010). Towing tank experiments for bluff body aerodynamics. Engineering Conf Int. (ECI), Potsdam, Germany.
PATH Project (2016). http://www.path.berkeley.edu/research/automated-and-connected-vehicles/truck-platooning, Accessed on May 12, 2016.
Patten, J., McAuliffe, B., Mayda, W. and Tanguay, B. (2012). Review of aerodynamic drag reduction devices for heavy trucks and buses. NRC-CNRC, Report No. CSTT-HVC-TR-205.
Porth, D. and Krämer, W. (1991). Fahrwiderstandsreduzierende massnahmen zur weiteren optimierung der wirtschaftlichkeit von sattelzuegen-teil 2. Automobiltechnische Zeitschrift 93, 10, 634–640.
Porth, D. and Krämer, W. (1993). Verringerung des verlustleistungspotentials bei nutzfahrzeugen. Automobiltechnische Zeitschrift 95, 12, 642–649.
Schmidt, H. J., Woszidlo, R., Nayeri, C. N. and Paschereit, C. O. (2015). Drag reduction on a rectangular bluff body with base flaps and fluidic oscillators. Experiments in Fluids 56, 7, 1–16.
Schmidt, H. J., Woszidlo, R., Nayeri, C. N. and Paschereit, C. O. (2016). Fluidic oscillators for bluff body drag reduction in water. 54th AIAA Aerospace Sciences Meeting. San Diego, California, USA.
Schmidt, H. J., Woszidlo, R., Nayeri, C. N. and Paschereit, C. O. (2018). The effect of flow control on the wake dynamics of a rectangular bluff body in ground proximity. Experiments in Fluids 59, 6, 1–16.
Törnell, J., Sebben, S. and Elofsson, P. (2021). Experimental investigation of a two-truck platoon considering inter-vehicle distance, lateral offset and yaw. J. Wind Engineering and Industrial Aerodynamics, 213, 104596.
Tsugawa, S., Kato, S. and Aoki, K. (2011). An automated truck platoon for energy saving. IEEE/RSJ Int. Conf. Intelligent Robots and Systems (IROS), San Francisco, California, USA.
Wabash National (2020). http://www.wabashnational.com, Accessed on November 23, 2020.
WABCO (2020). http://www.wabco-auto.com, Accessed on November 23, 2020.
Watkins, S., Saunders, J. W. and Hoffmann, P. H. (1993). Comparison of road and wind-tunnel drag reductions for commercial vehicles. J. Wind Engineering and Industrial Aerodynamics 49, 1–3, 411–420.
Acknowledgement
The funding for the presented Investigations was provided by the German Science Foundation (Deutsche Forschungsgemeinschaft). The authors also acknowledge for fruitful discussions with Lennart Löfdahl.
Author information
Authors and Affiliations
Corresponding author
Additional information
Publisher’s Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Nayeri, C.N., Schmidt, HJ. Platooning and Base Flaps for Drag Reduction of Trucks. Int.J Automot. Technol. 23, 1673–1680 (2022). https://doi.org/10.1007/s12239-022-0145-4
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12239-022-0145-4