Abstract
In this study, a new method is proposed to identify the dynamic parameters of structures with higher accuracy compared to current methods. First, the wavelet-transformed representation of system responses is extracted from measured responses, and then the independent component analysis is used to achieve the modal characteristics. The simulation results of a multi-degree-of-freedom system illustrate that this method is capable of accurately identifying the modal information of lightly- and highly-damped structures. It is represented that continuous wavelet transform, due to its adaptive time-frequency resolution, is more efficient to be incorporated into independent component analysis compared to Short time Fourier transform (STFT). The latter is unable to accurately determine the modal response, especially at higher frequencies, while the proposed method can identify the system with marked accuracy. The efficiency of proposed method is also investigated under additive noise. Results shown that for highly- and lightly- damped system, the proposed method is able to capture the modal parameters especially in higher frequencies of vibration, along with the modal assurance criterion values with satisfactory accuracy, which indicates the robustness of the procedure compared to other available methodologies.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
J. N. Juang, Applied system identification, Prentice Hall, New Jersy, USA (1994).
A. Farzampour and A. Kamali Asl, Performance of tuned mass dampers in vibration response control of base-excited structures, Journal of Civil, Construction and Environmental Engineering, 2 (3) (2017) 87–94.
A. A. Farzampour and M. Yekrangnia, On the behavior of corrugated steel shear walls with and without openings, Second European Conference on Earthquake Engineering (2014).
J. Seo, L. Dueñas-Osoriob, J. I. Craigc and B. J. Goodnod, Metamodel-based regional vulnerability estimate of irregular steel moment-frame structures subjected to earthquake events, Engineering Structures, 45 (2012) 585–597.
X. He, B. Moaveni, J. P. Conte and A. Elgamal, Modal identication study of Vincent Thomas bridge using simulated wind-induced ambient vibration data, Computer-Aided Civil and Infrastructure Engineering, 23 (2008) 373–388.
B. Moaveni, X. He, J. P. Conte, J. A. Restrepo and M. Panagiotou, System identification study of a 7-story fullscale building slice tested on the UCSD-NEES shake table, Journal of Structural Engineering, 137 (2011) 705–717.
E. Reynders, G. Wursten and G. De Roeck, Output-only structural health monitoring in changing environmental conditions by means of nonlinear system identification, Structural Health Monitoring: An International Journal, 13 (2014) 82–93.
J. Slavic, M. Simonovski and M. Boltezar, Damping identification using a continuous wavelet transform: Application to real data, Journal of Sound and Vibration, 262 (2003) 291–307.
J. W. Hu, J. Lee and J. Seo, Performance-based optimal design of self-centering friction damping brace systems between recentering capability and energy dissipation, Journal of Mechanical Science and Technology, 28 (8) (2014) 3129–3136.
J. Seo and J. W. Hu, Seismic response and performance evaluation of self-centering LRB isolators installed on the CBF building under NF ground motions, Sustainability, 8 (109) (2016).
J. Lardies and S. Gouttebrouze, Identification of modal parameters using the wavelet transform, International Journal of Mechanical Sciences, 44 (2002) 2263–2283.
I. A. Kougioumtzoglou and P. D. Spanos, An identification approach for linear and nonlinear time-variant structural systems via harmonic wavelets, Mechanical Systems and Signal Processing, 37 (2013) 338–352.
A. Hyvarinen and E. Oja, Independent component analysis: Algorithms and applications, Neural Networks, 13 (2000) 411–430.
S. I. McNeill, Modal identification using blind source separation techniques, Ph.D. Thesis, Rice University, Houston, Texas, USA (2007).
B. Hazra and S. Narasimhan, Wavelet-based blind identification of the UCLA factor building using ambient and earthquake responses, Smart Materials and Structures, 19 (2010) 10.
A. Sadhu, B. Hazra and M. D. Pandey, Decentralized modalidentification using sparse blind source separation, Smart Materials and Structures, 20 (2011) 15.
A. Sadhu, B. Hazra and S. Narasimhan, Blind identification of earthquake-excited structures, Smart Materials and Structures, 21 (2012) 13.
A. Sadhu, B. Hazra and S. Narasimhan, Decentralized modal identification of structures using parallel factor decomposition and sparse blind source separation, Mechanical Systems and Signal Processing, 41 (2013) 396–419.
F. Abazarsa, S. F. Ghahari, F. Nateghi and E. Taciroglu, Response-only modal identification of structures using limited sensors, Structural Control and Health Monitoring, 20 (2013) 987–1006.
F. Poncelet, G. Kerschen, J.-C. Golinval and D. Verhelst, Output-only modal analysis using blind source separation techniques, Mechanical Systems and Signal Processing, 21 (2007) 2335–2358.
C. Zang, M. I. Friswell and M. Imregun, Decomposition of time domain vibration signals using the independent component analysis technique, 3rd International Conference on Identification in Engineering Systems, Swansea, UK (2002).
G. Kerschen, F. Poncelet and J.-C. Golinval, Physical interpretation of independent component analysis in structural dynamics, Mechanical Systems and Signal Processing, 21 (2007) 1561–1575.
Y. Yang and S. Nagarajaiah, Time-frequency blind source separation using independent component analysis for outputonly modal identification of highly damped structures, Journal of Structural Engineering, 139 (2013) 1780–1793.
Y. Yang and S. Nagarajaiah, Blind identi-cation of damage in time-varying system using independent component analysis with wavelet transform, Mechanical Systems and Signal Processing, 47 (2014) 3–20.
W. Staszewski and A. N. Robertson, Time–frequency and time–scale analyses for structural health monitoring, Philosophical Transactions for the Royal Society of London, Series A, Mathematical and Physical Sciences, 365 (2007) 449–477.
W. J. Staszewski and D. M. Wallace, Wavelet-based frequency response function for time-variant systems—An exploratory study, Mechanical Systems and Signal Processing, 47 (2014) 35–49.
A. Hyvarinen, FastICA [Computer software], Helsinki, Finland, Helsinki Univ. of Technology.
A. K. Chopra, Dynamic of structures: Theory and applications to earthquake engineering, Prentice Hall (2011).
Author information
Authors and Affiliations
Corresponding author
Additional information
Recommended by Associate Editor Gyuhae Park
Alireza Farzampour is a third-year Ph.D. student at Virginia Tech in Structures. He received his Bachelor’s and Master’s at Sharif University of Technology. His areas of interest include stability of structures, steel shear wall, dynamical systems, seismic hazard analysis and system identification of structures.
Arash Kamali Asl is a third-year Ph.D. student at University of Vermont in Geosystems Laboratory. He got his Bachelor’s and Master’s in civil engineering from Zanjan and Sharif University of Technology. His areas of interest include rapid seismic hazard analysis, dynamical systems and system identification.
Jong Wan Hu received his M.S. degrees from (1) G.W.W. School of Mechanical Engineering and (2) School of Civil and Environmental Engineering, respectively, in Georgia Institute of Technology. He then received his Ph.D. degree from School of Civil and Environmental Engineering, Georgia Institute of Technology. Dr. Hu has been Post-Doctorate Research Fellow at Structural, Mechanics, and Material Research Group in Georgia Institute of Technology. Dr. Hu also worked as an Associate Research Fellow at the Korea Institute of S&T Evaluation and Planning (KISTEP) and an Assistant Administrator at the National S&T Council (NSTC) for two years. He is currently an Assistant Professor in the University of Incheon. He has been active in the member of ASME and ASCE. His research interests are in the area of computational solid mechanics, composite materials, and plasticity modeling.
Rights and permissions
About this article
Cite this article
Farzampour, A., Kamali-Asl, A. & Hu, J.W. Unsupervised identification of arbitrarily-damped structures using time-scale independent component analysis: Part I. J Mech Sci Technol 32, 567–577 (2018). https://doi.org/10.1007/s12206-018-0104-6
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-018-0104-6