Abstract
CaCu3Ti4O12 ceramic with a giant dielectric constant was synthesized by sol-gel method and sintered in three different sintering conditions: 1 035 °C for 48 h, 1 080 °C for 3 h and 48 h. The phase of the ceramics, the element distribution, the valance state of Ti ions at grain boundaries, and the electrical properties were characterized via X-ray diffraction (XRD), energy dispersive X-ray analysis (EDAX), X-ray photoelectron spectroscopy (XPS), electrical conduction and dielectric measurement. The results demonstrate that the grain-boundary microstructure and the electrical properties are influenced by sintering conditions: ➀ By raising sintering temperature, the Cu-rich and Ti-poor grain boundary was formed and grain resistivity was decreased. ➁ By prolonging sintering time, the content of Ti3+ near the grain boundary increased, leading to the decrease of the grain-boundary resistivity and the increase of the activation energy at grain boundary. The ceramic, sintering at 1 080 °C for 48 h, exhibited a small grain resistivity (60.5 Ω · cm), a large grain-boundary activation energy (0.42 eV), and a significantly enhanced dielectric constant (close to 1×105 at a low frequency of 1×103 Hz ). The results of electrical properties accord with the internal boundary layer capacitor model for explaining the giant dielectric constant observed in CaCu3Ti4O12 ceramics.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Ramirez A P, Subramanian M A, Gardel M, et al. Giant dielectric constant response in a copper-titanate [J]. Solid State Communications, 2000, 115(5): 217–220.
Kolev N, Bontchev R P, Jacobson A J, et al. Raman spectroscopy of CaCu3Ti4O12 [J]. Physical Review B, 2002, 66: 132102–132102-4.
Subramanian M A, Li D, Duan N, et al. High dielectric constant in ACu3Ti4O12 and ACu3Ti3FeO12 phases [J]. Journal of Solid State Chemistry, 2000, 151: 323–325.
Zhu Y, Zheng J C, Wu L, et al. Nanoscale disorder in CaCu3Ti4O12: A new route to the enhanced dielectric response [J]. Physical Review Letters, 2007, 99: 037602–037602-4.
Delugas P, Alippi P, Fiorentini V, et al. Reorientable dipolar CuCa antisite and anomalous screening in CaCu3Ti4O12 [J]. Physical Review B, 2010, 81: 081104–081104-4.
Li M, Shen Z J, Nygren M. Origin(s) of the apparent high permittivity in CaCu3Ti4O12 ceramics: Clarification on the contributions from internal barrier layer capacitor and sample-electrode contact effects [J]. Journal of Applied Physics, 2009, 106(10): 104106–104106-8.
Kwon S, Huang C C, Subramanian M A, et al. Effects of cation stoichiometry on the dielectric properties of CaCu3Ti4O12 [J]. Journal of Alloys and Compounds, 2009, 473(1–2): 433–436.
Adams T B, Sinclair D C, West A R. Characterization of grain boundary impedances in fine- and coarse-grained CaCu3Ti4O12 ceramics[J]. Physical Review B, 2006, 73: 094124–094124-9.
Li M, Feteira A, Sinclair D C, et al. Influence of Mn doping on the semiconducting properties of CaCu3Ti4O12 ceramics [J]. Applied Physics Letters, 2006, 88(23): 232903–232903-3.
Li M, Feteira A, Sinclair D C, et al. Incipient ferroelectricity and microwave dielectric resonance properties of CaCu2.85Mn0.15Ti4O12 ceramics [J]. Applied Physics Letters, 2007, 91(13): 132911–132911-3.
Yang Z, Zhang Y, You G, et al. Dielectric and electrical transport properties of the Fe3+-doped CaCu3Ti4O12 [J]. Journal of Materials Science & Technology, 2012, 28(12): 1145–1150.
Wang C C, Zhang L W. Oxygen-vacancy-related dielectric anomaly in CaCu3Ti4O12: Post-sintering annealing studies [J]. Physical Review B, 2006, 74: 024106–024106-4.
Lin Y H, Cai J, Li M, et al. Grain boundary behavior in varistor-capacitor TiO2-rich CaCu3Ti4O12 ceramics [J]. Journal of Applied Physics, 2008, 103(7): 074111–074111-5.
Patterson E A, Kwon S, Huang C C, et al. Effects of ZrO2 additions on the dielectric properties of CaCu3Ti4O12 [J]. Applied Physics Letters, 2005, 87(18): 182911–182911-3.
Fang T T, Mei L T, Ho H F. Effects of Cu stoichiometry on the microstructures, barrier-layer structures, electrical conduction, dielectric responses, and stability of CaCu3Ti4O12 [J]. Acta Materialia, 2006, 54(10): 2867–2875.
Luo F C, He J L, Hu J, et al. Electric and dielectric properties of Bi-doped CaCu3Ti4O12 ceramics [J]. Journal of Applied Physics, 2009, 105(7): 076104–076104-3.
Yang Z, Zhang Y, Lu Z H, et al. Electrical conduction and dielectric properties of the Rb-doped CaCu3Ti4O12 [J]. Journal of the American Ceramic Society, 2013, 96(3): 806–811.
Yang Z, Zhang Y, Zhang K, et al. Effect of grain-boundary behavior on the dc electric conduction in Rb-doped CaCu3Ti4O12 [J]. Journal of Materials Science: Materials in Electronics, 2013, 24(3): 1063–1067.
Zhao Y H, Gao R J, Su G, et al. Effect of dispersant on CaCu3Ti4O12 powders synthesized by oxalate co-precipitation method [J]. Materials Letters, 2013, 91: 187–190.
Sangwong N, Yamwong T, Thongbai P. Synthesis, characterization and giant dielectric properties of CaCu3Ti4O12 ceramics prepared by a polyvinyl pyrrolidone-dimethylfor mamide solution route [J]. Journal of Electroceramics, 2013, 31(1–2): 181–188.
Ahmad M M. Giant dielectric constant in CaCu3Ti4O12 nanoceramics [J]. Applied Physics Letters, 2013, 102(23): 232908–232908-4.
Swatsitang E, Niyompan A, Putjuso T. Giant dielectric, low dielectric loss, and non-ohmic properties of nanocrystalline CaCu3Ti4O12 [J]. Journal of Materials Science: Materials in Electronics, 2013, 24(9): 3514–3520.
Kumar R, Zulfequar M, Sharma L, et al. Growth of nanocrystalline CaCu3Ti4O12 ceramic by the microwave flash combustion method: structural and impedance spectroscopic studies [J]. Crystal Growth & Design, 2015, 15(3): 1374–1379.
Ahmad M M, Yamada K. Grain size effect on the giant dielectric constant of CaCu3Ti4O12 nanoceramics prepared by mechanosynthesis and spark plasma sintering [J]. Journal of Applied Physics, 2014, 115(15): 154103–154103-6.
Jesurani S, Kanagesan S, Velmurugan R, et al. A comparative study of conventional sintering with microwave sintering of high dielectric calcium copper titanate nano powder synthesized by sol-gel route [J]. Transactions of the Indian Ceramic Society, 2011, 70(2): 79–85.
Yang Z, Zhang Y, Xiong R, et al. Effect of sintering in oxygen on electrical conduction and dielectric properties in CaCu3Ti4O12 [J]. Materials Research Bulletin, 2013, 48(2): 310–314.
Wang B, Pu Y P, Wu H D, et al. Influence of sintering atmosphere on dielectric properties and microstructure of CaCu3Ti4O12 ceramics [J]. Ceramics International, 2013, 39: S525–S528.
Prakash B S, Varma K B R. The influence of the segregation of Cu-rich phase on the microstructural and impedance characteristics of CaCu3Ti4O12 ceramics [J]. Journal of Materials Science, 2007, 42(17): 7467–7477.
Schmidt R, Stennett M C, Hyatt N C, et al. Effects of sintering temperature on the internal barrier layer capacitor (IBLC) structure in CaCu3Ti4O12 (CCTO) ceramics [J]. Journal of the European Ceramic Society, 2012, 32(12): 3313–3323.
Zhang L, Tang Z J. Polaron relaxation and variable-range-hopping conductivity in the giant-dielectric-constant material CaCu3Ti4O12 [J]. Physical Review B, 2004, 70(17): 174306–174306-6.
Adams T B, Sinclair D C, West A R. Giant barrier layer capacitance effects in CaCu3Ti4O12 ceramics [J]. Advanced Materials, 2002, 14: 1321–1323.
Clarke D R. Varistor ceramics [J]. Journal of the American Ceramic Society, 1999, 82(3): 485–502.
Author information
Authors and Affiliations
Corresponding author
Additional information
Foundation item: Supported by the National Natural Science Foundation of China (51172166) and the Ph.D. Programs Foundation of City College, Wuhan University of Science and Technology (2014CYBSKY003)
Biography: YANG Zhi, female, Lecturer, Ph. D., research direction: ceramics with a giant dielectric constant.
Rights and permissions
About this article
Cite this article
Yang, Z., Xiong, R. Effect of sintering on grain boundary microstructure and electrical properties of CaCu3Ti4O12 ceramics. Wuhan Univ. J. Nat. Sci. 20, 255–261 (2015). https://doi.org/10.1007/s11859-015-1090-0
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11859-015-1090-0