Abstract
The aim of this study is to numerically investigate the influence of particle breakage on the mechanical behavior of granular materials using a discrete element method (DEM). To enable particle crushing, non-crushable elementary particles are boned together to represents the granular aggregates which can be crushed when the external force exceeds its strength. The flaw of the aggregate was also modeled by randomly distributed void. Single particle crushing tests were carried out to determine the distribution of particle strength. The results of single particle crushing tests illustrate that the simulated single particle fracture strength and pattern agree well with the Weibull’s distribution equation. Conventional oedometer tests, drained monotonic and cyclic triaxial tests were also carried out to investigate the crushing of the aggregates and the associated mechanical behaviors. The effect of confining pressure on the crushing of aggregates and the mechanical behavior was also analyzed. It was found that the peak stress and dilation decrease significantly when particle crushing was considered. The deformation behavior of the specimen is essentially controlled by two factors: particle rearrangement - induced dilation and particle crushing - induced contraction. The increase of permanent strain and the reduction of dilation were observed during cyclic loading and they tend to reach a stable state after a certain number of cycles. The crushing of aggregate is most significant in the first two cycles. The results also indicated that for the same axial strain the volumetric strain and the bound breakage in the cyclic loading tests are significantly larger than that in the monotonic loading tests, especially at high cyclic stress ratio.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Ashby MF & Jones DRH (1986) Engineering materials 2. Pergamon Press, Oxford.
Åström JA, Herrmann HJ (1998) Fragmentation of grains in a two-dimensional packing. The European Physical Journal 5 (3): 551–554. DOI: 10.1007/s100510050476
Cheng YP, Nakata Y, Bolton MD (2003) Distinct element simulation of crushable soil. Géotechnique 53 (7): 633–641. DOI: 10.1680/geot.2003.53.7.633
Cheng YP, Bolton MD, Nakata Y (2004) Crushing and plastic deformation of soils simulated using DEM. Géotechnique 54 (2): 131–141. DOI: 10.1680/geot.2004.54.2.131
Cundall PA, & Strack ODL (1979) A discrete numerical model for granular assemblies. Géotechnique 29 (1): 47–65. DOI: 10.1680/geot.1979.29.1.47
Deluzarche R, and Cambou B (2006) Discrete numerical modelling of rockfill dams. International Journal for Numerical and Analytical Methods in Geomechanics 30 (11): 1075–1096. DOI: 10.1002/nag.514
Gu XQ, Yang J, Huang MS (2013) DEM simulations of the small strain stiffness of granular soils: effect of stress ratio. Granular Matter 15 (3): 287–298. DOI: 10.1007/s10035-013-0407-y
Gu XQ, Huang MS, Qian JG (2014) DEM investigation on the evolution of microstructure in granular soils under shearing. Granular Matter 16 (1): 91–106. DOI: 10.1007/s10035-013-0467-z
Kong DZ, Zhang BY, Sun X (2009) Triaxial tests on particle breakage strain of artificial rockfill materials. Chinese Journal of Geotechnical Engineering 31 (3): 464–469.
Lobo-Guerrero S, Vallejo LE (2005) Crushing a weak granular material: experimental numerical analyses. Géotechnique 55 (3): 245–249. DOI: 10.1680/geot.2005.55.3.245
Nakata Y, Hyde AFL, Hyodo M, Murata H (1999) A probabilistic approach to sand particle crushing in the triaxial test. Géotechnique 49 (5): 567–583. DOI:10.1680/geot.1999.49. 5.567
McDowell GR, Bolton MD (1998) On the micro mechanics of crushable aggregates. Géotechnique 48 (5): 667–679. DOI: 10.1680/geot.1998.48.5.667
McDowell GR, Amon A (2000) The application of Weibull statistics to the facture of soil particles. Soils Found 40 (5): 133–141. DOI: 10.3208/sandf.40.5_133
McDowell GR, Harireche O (2002a) Discrete element modelling of soil particle fracture. Géotechnique 52 (2): 131–135. DOI: 10.1680/geot.2002.52.2.131
McDowell GR, Harireche O (2002b) Discrete element modelling of yielding and normal compression of sand. Géotechnique 52 (4): 299–304. DOI: 10.1680/geot.2002.52.4.299
McDowell GR, de Bono JP (2013) On the micro mechanics of one-dimensional normal compression. Géotechnique 63 (11): 895–908. DOI: 10.1680/geot.12.P.041
McDowell GR, de Bono JP (2013) DEM of triaxial tests on crushable sand. Granular Matter 16 (4): 551–562. DOI: 10.1007/s10035-014-0500-x
Munjiza A, Owen DRJ, Bicanic N (1995) A combined finitediscrete element method in transient dynamics of fracturing solids. Engineering Computations 12 (2): 145–174. DOI: 10.1108/02644409510799532
Munjiza A (2004) The combined finite-discrete element method. Wiley, Chichester, U.K. DOI: 10.1002/0470020180
Owen DRJ, Feng YT, Neto EAD, et al. (2004) The modelling of multi-fracturing solids and particulate media. International Journal for Numerical Methods in Engineering 60 (1): 317–339. DOI: 10.1002/nme.964
Qian JG, Huang MS, Sun HZ (2011). Macro-micromechanical approaches for non-coaxiality of coarse grained soils. Science China-Technological Sciences 54(s1):147–153. DOI: 10.1007/s11431-011-4634-3
Qian JG, You ZP, Huang MS, GU XQ (2013a) A micromechanics-based model for estimating localized failure with effects of fabric anisotropy. Computers and Geotechnics 50: 90–100. DOI: 10.1016/j.compgeo.2013.01.001
Qian JG, You ZP, Huang MS (2013b) Anisotropic characteristics of granular materials under simple shear. Journal of Central South University 20 (8): 2275–2284. DOI: 10.1007/s11771-013-1734-1
Robertson D (2000) Computer simulations of crushable aggregates. PhD dissertation, Cambridge University, UK.
Thornton C (2000) Numerical simulations of deviatoric shear deformation of granular media. Géotechnique 50 (1): 43–53. DOI: 10.1680/geot.2000.50.1.43
Tsoungui O, Vallet D, Charmet JC (1999) Numerical model of crushing of grains inside two-dimensional granular materials. Powder Technology 105 (1): 190–198. DOI: 10.1016/S0032-5910(99)00137-0
Ueda TM, Yamada Y (2013) DEM simulation on the onedimensional compression behavior of various shaped crushable granular materials. Granular Matter 15 (5): 675–684. DOI: 10.1007/s10035-013-0415-y
Wang J, Yan H (2011) 3D DEM Simulation of Crushable Granular Soils under Plane Strain Compression Condition. Procedia Engineering. 14: 1713–1720. DOI: 10.1016/j.proeng. 2011.07.215
Wang J, Yan H (2013) On the role of particle breakage in the shear failure behavior of granular soils by DEM. International Journal for Numerical and Analytical Methods in Geomechanics 37 (8): 832–854. DOI: 10.1002/nag.1124
Weibull W (1951) A statistical distribution function of wide applicability. Journal of Applied Mechanics 18: 293–297.
Wichtmann T, Niemunis A, Triantafyllidis TH (2007) Strain accumulation in sand due to cyclic loading: drained cyclic tests with triaxial extension. Soil Dynamics and Earthquake Engineering 27 (1): 42–48. DOI: 10.1016/j.soildyn.2006.04.001
Xiang J, Munjiza A and Latham JP (2009) Finite strain, finite rotation quadratic tetrahedral element for the combined finite-discrete element method. International Journal for Numerical Methods in Engineering 79 (8): 946–978. DOI: 10.1002/nme.2599
Zhou W, Ma G, Chang XL, et al. (2015) Discrete modeling of rockfill materials considering the irregular shaped particles and their crushability. Engineering Computations 32 (4): 1104–1120. DOI: 10.1108/EC-04-2014-0086
Acknowledgments
This work was supported by National Natural Science Foundation of China (Grant Nos. 51578413, 51238009 and 41272291) and the Fundamental Research Funds for the Central Universities.
Author information
Authors and Affiliations
Corresponding author
Additional information
http://orcid.org/0000-0001-9639-3627
http://orcid.org/0000-0002-0130-5565
http://orcid.org/000-0002-2010-6510
http://orcid.org/0000-0002-1990-6641
Rights and permissions
About this article
Cite this article
Qian, Jg., Gu, Jb., Gu, Xq. et al. Discrete numerical modeling of granular materials considering crushability. J. Mt. Sci. 14, 758–770 (2017). https://doi.org/10.1007/s11629-016-4051-y
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11629-016-4051-y