Abstract
Some of organic materials such as antibiotics are hazardous contaminants in the aquatic environment because of their adverse effects on aquatic life, environment, and humans. In this work, a batch reactor of ultraviolet (UV) light and peroxydisulfate were studied for the degradation of tylosin as a model antibiotic in water. The effect of different parameters such as UV irradiation, peroxydisulfate concentration, antibiotic concentration, and pH on removal of tylosin was investigated carefully. No significant destruction was observed using separate UV illumination. More than 90% removal occurred when peroxydisulfate was added to the solution in optimum levels of tylosin and peroxydisulfate concentration.
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
Background
Antibiotics play an important role due to their high consumption rates in both veterinary and human medicine. These materials such as tylosin (Table1) which is used in veterinary medicine to treat bacterial infections in a wide range of species at low concentrations in the environment the development of antibiotic resistant bacteria[1]. In fact, bacteria have been observed to transfer their resistance in laboratory settings as well as in the natural environment[2]. Furthermore, the presence of antibiotics in wastewaters has increased in recent years, and their abatement will be a challenged in the near future.
Antibiotic wastewater has high chemical oxygen demand (COD) and low biochemical oxygen demand (BOD); hence, biological processes are unsuitable for the wastewater treatment. Advanced oxidation processes (AOPs) have proved to be highly effective in the degradation of most of the pollutants in wastewaters[3]. AOPs are alternative techniques of destruction of many other organics in wastewater and effluents. These processes generally involve UV/H2O2, UV/O3, UV/ or UV/Fenton's reagent for the oxidative degradation of contaminants[4–6]. Recently, there were numerous studies on UV/ application in wastewater treatment mainly because of high reactivity of UV/ process and high solubility of peroxydisulfate[4].
Peroxydisulfate is a strong oxidant (E0 = 2.05 V) which can be purchased in the form of ammonium, sodium or potassium salt. It has been reported that the reaction rate constants of UV/ and UV/ (the most common process) is the same[7]. Moreover, peroxydisulfate benefits UV/H2O2 and other similar approaches by the following reasons: (1) peroxydisulfate ions seem to be more promising because of the potential quenching effect of using H2O2 when the process is not well controlled (such as overdosing)[7]. (2) Since peroxydisulfate is a solid oxidant, it would be more capable for industrial uses in comparison to liquid oxidants such as H2O2. (3) Peroxydisulfate salts are much cheaper than other oxidants like hydrogen peroxide and ozone[8, 9].
In this study, degradation of tylosin as an antibiotic pollutant from contaminated water by UV/ process was studied. Moreover, effect of different parameters such as UV irradiation, peroxydisulfate concentration, antibiotic concentration, and pH was investigated.
Experimental
Tylosin was obtained from Razak Co. (Islamic Republic of Iran, P.O.B 13185-1671, Tehran, Iran) and used without further purification. Characteristics of this antibiotic are shown in Table1. The antibiotic is determined in an aqueous medium using a scanning UV–vis spectrophotometer (Shimadzu 160, Shimadzu Corporation, Nakagyo-ku, Kyoto, Japan). Ammonium peroxydisulfate was obtained from Merck & Co., Inc. (Whitehouse Station, NJ, USA). Dilute solutions of sodium hydroxide and hydrochloric acid were used for pH adjustment. A 30-W UV lamp was manufactured by Philips (Koninklijke Philips Electronics N.V., St. Vali-asr Ave., Iran). The volume of sample was 100 ml, and all the temperature (25 ± 4°C). Peroxydisulfate concentration varied from 0.5 to 20 mM, while antibiotic concentration varied from 20 to 80 ppm. The effect of pH was investigated in the range of 2.4 to 9.8.
Results and Discussion
Effect of UV irradiation and peroxydisulfate on degradation of tylosin
Degradation of tylosin was investigated with UV irradiation only, without UV radiation, and UV radiation plus in concentrations of 2 mM of peroxydisulfate, the antibiotic concentration of 40 ppm and natural pH (pH = 6.7). In the first case without any peroxydisulfate, approximately, we had maximum degradation of 11%, while using peroxydisulfate without UV irradiation, we had no degradation. UV plus peroxydisulfate outweighs the two mentioned cases clearly by 80% removal (Figure1). This effective degradation is due to the formation of hydroxyl and sulfate radicals because of UV illumination. Reactions of peroxydisulfate were slow at normal temperature. Thus, as summarized in Equations 1 to 5, thermal or photochemical activated decomposition of ion to radical is proposed for acceleration of the process[10]:
where R is an organic reagent.
Once is formed, it can produce a rapid attack on any oxidizable agent including organic contaminants (e.g., tylosin)[11]. Also, available oxidants in the solution and their corresponding intermediates are indicated in Equations 6 to 12:
Both and are possibly responsible for the destruction of organic contaminants, and either radical may predominate over the other depending on pH conditions. and react with organic compounds mainly by three mechanisms: hydrogen abstraction, hydrogen addition, and electron transfer. Sulfate radicals exhibit a higher standard reduction potential than hydroxyl radicals at neutral pH, and both radicals exhibit similar reduction potentials under acidic conditions[8]. In general, is more likely to participate in electron transfer reactions than is which is more likely to participate in hydrogen abstraction or addition reactions[12].
Effect of initial peroxydisulfate concentration
Initial concentration has a promising effect on degradation of tylosin. Investigations were made by varying the concentration of from 0.5 to 20 mM at fixed initial antibiotic concentration of 40 ppm, natural pH, and room temperature of 25°C ± 1°C. Studies revealed that increase in amount of would enhance degradation of the tylosin respectively[13]. These observations can be explained by the fact that the increase in concentration of peroxydisulfate results in higher generation of hydroxyl and sulfate radicals (Figure2). It is likely because of excessive generation of hydroxyl radicals (Equations 1 and 6) would be recombined to form less reactive H2O2 (Equation 13), which is a known quencher of OH· radical (Equation 14). Therefore, the destruction of tylosin was slightly slowed down at higher dosages. However, such a recombination effect of the radical was likely not very effective due to the low steady-state concentrations of the radicals; higher decay rates of tylosin at higher dosages are still expected[5, 13]:
Effect of initial tylosin concentration
The initial antibiotic concentration has a remarkable effect on photolytic degradation of tylosin. Tylosin concentration varied from 20 to 80 ppm at constant dosage of peroxydisulfate (2 mM). Degradation of 91% is observed in 20 ppm, while only 78% of degradation is achieved in 80 ppm concentration of tylosin (Figure3). As shown in Figure3, the higher concentration of tylosin was, the lower the degradation rate would be. One possible reason may be that the increase in antibiotic concentration decreases the ratio of hydroxyl radical to tylosin and percentage of degradation reduces in result.
Effect of the initial pH
The effect of initial pH was investigated in the range of 2.4 to 9.8 in constant concentration of tylosin (40 ppm), peroxydisulfate (2 mM), and temperature (25°C ± 1°C; Figure4). pH 6.7 was found to be the most effective level of pH in decolorization of tylosin. However, effective photodegradation of tylosin was observed at all pH levels, which reveals the efficiency of this method in treatment of wastewater in different regions. The destruction performance increased from low to initial neutral pH (pH = 6.7) levels, but it started to reduce when basic pH was performed. The decreasing photodecay at pH ≥ 7 can be explained by the following reasons: (a) the instability of H2O2 at high pH level, (b) relatively higher amounts of and were generated catalytically in alkaline conditions, which induced recombination of these two radicals (Equation 9), though this could be minor[14].
Conclusion
The application of peroxydisulfate along with UV irradiation as an advanced oxidation process at laboratory scale introduces an effectual and safe method for degradation of tylosin. Almost no antibiotic removal was achieved using peroxydisulfate alone. On the other hand, destruction percentage of 11% was obtained using UV irradiation alone. Finally, more than 97% of antibiotic content was removed using UV irradiation and peroxydisulfate simultaneously. Degradation rate of tylosin was dependent on the antibiotic concentration, peroxydisulfate concentration, and pH. Increase in antibiotic concentration would decrease the degradation as degradation of 91% was observed in 20 ppm, while only 78% of degradation was achieved in 80 ppm concentration of tylosin. Neutral pH (6.7) was monitored as the optimum pH; however, all levels of pH demonstrate satisfactory removal.
References
Walter MV, Vennes JV: Occurrence of multiple-antibiotic-resistant enteric bacteria in domestic sewage and oxidation lagoons. Appl Environ Microbiol 1985,50(4):930–933.
Kanai H: Drug-resistance and distribution of conjugative R plasmids in Escherichia coli strains isolated from healthy adult animals and humans. Jpn J Vet Sci 1983, 45: 171–178. 10.1292/jvms1939.45.171
Pera-Titus M, Garcia-Molina V, Baños MA, Gimenez J, Esplugas S: Degradation of chlorophenols by means of advanced oxidation processes: a general review. Appl Catal B Environ 2004, 47: 219–256. 10.1016/j.apcatb.2003.09.010
Vilhunen SH, Sillanp MET: Ultraviolet light emitting diodes and hydrogen peroxide in the photodegradation of aqueous phenol. J Hazard Mater 2009, 161: 1530. 10.1016/j.jhazmat.2008.05.010
Daneshvar N, Aber S, Seyed Dorraji MS, Khataee AR, Rasoulifard MH: Photocatalytic degradation of the insecticide diazinon in the presence of prepared nanocrystalline ZnO powders under irradiation of UV-C light. Sep Purif Technol 2007,58(1):91–98. 10.1016/j.seppur.2007.07.016
Daneshvar N, Rasoulifard MH, Khataee AR, Hosseinzadeh F: Removal of C.I. Acid Orange 7 from aqueous solution by UV irradiation in the presence of ZnO nano powder. J Hazard Mater 2007, 143: 95–101. 10.1016/j.jhazmat.2006.08.072
Chu W, Lau TK, Fung SC: Effects of combined and sequential addition of dual oxidants (H2O2/S2O8(2-)) on the aqueous carbofuran photodegradation. J Agric Food Chem 2006,54(26):10047–10052. 10.1021/jf062018k
Anipsitakis GP, Dionysiou DD: Radical generation by the interaction of transition metals with common oxidants. Environ Sci Technol 2004,38(13):3705–3712. 10.1021/es035121o
Anipsitakis GP, Dionysiou DD: Degradation of organic contaminants in water with sulfate radicals generated by the conjunction of peroxymonosulfate with cobalt. Environ Sci Technol 2003, 37: 4790–4797. 10.1021/es0263792
Salari D, Daneshvar N, Niaei A, Aber S, Rasoulifard MH: Immobilization of TiO 2 Nanopowder on glass beads for photocatalytic decolorization of an Azo Dye C. I. Directed Red 23. J Environ Sci Health Part A 2008, 43: 1–7. 10.1080/03601230701734774
Liang CJ, Bruell CJ, Marley MC, Sperry KL: Thermally activated persulfate oxidation of trichloroethylene (TCE) and 1,1,1-trichloroethane (TCA) in aqueous systems and soil slurries. Soil Sedim Contam 2003, 12: 207.
Minisci F, Citterio A: Free-radical addition to olefins in the presence of redox systems. Acc Chem Res 1983, 16: 27. 10.1021/ar00085a005
Rasoulifard MH, Marandi R, Majidzadeh H, Bagheri I: Ultraviolet light-emitting diodes and peroxydisulfate for degradation of basic red 46 from contaminated water. Environ Eng Sci 2011, 28: 229–235. 10.1089/ees.2010.0202
Lau TK, Chu W, Graham NJD: The aqueous degradation of butylated hydroxyanisole by UV/S2O8(2-): study of reaction mechanisms via dimerization and mineralization. Environ Sci Technol 2007,41(2):613–9. 10.1021/es061395a
Acknowledgment
The authors are grateful to the University of Zanjan for the financial support.
Author information
Authors and Affiliations
Corresponding author
Additional information
Competing interests
The authors declare that they have no competing interests.
Authors contributions
AB carried out the molecular genetic studies, participated in the sequence alignment and drafted the manuscript. JY carried out the immunoassays. MT participated in the sequence alignment. ES participated in the design of the study and performed the statistical analysis. FG conceived of the study, and participated in its design and coordination. All authors read and approved the final manuscript. All authors read and approved the final manuscript.
Authors’ original submitted files for images
Below are the links to the authors’ original submitted files for images.
Rights and permissions
Open Access This article is distributed under the terms of the Creative Commons Attribution 2.0 International License (https://creativecommons.org/licenses/by/2.0), which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.
About this article
Cite this article
Rasoulifard, M.H., Majidzadeh, H., Demneh, F.T. et al. Photocatalytic degradation of tylosin via ultraviolet-activated persulfate in aqueous solution. Int J Ind Chem 3, 16 (2012). https://doi.org/10.1186/2228-5547-3-16
Received:
Accepted:
Published:
DOI: https://doi.org/10.1186/2228-5547-3-16