Abstract
The exploitation of geo-resources is dominantly done using drilling and blasting. The breakage of rock mass by blasting has many challenges. The optimal breakage in an underground development face/tunnel blast is dependent on the relief area provided to the blast holes. This paper has discussed the impact of the number and diameter of the relief holes on the breakage pattern of the rock. The numerical simulation with varying numbers and diameter of relief hole was carried out for this purpose. The isosurface output from numerical simulation was plotted. The plot was used to compare the extent of deformation under varying conditions of relief holes. The analysis shows that the higher number of relief holes with optimum diameter gives more controlled deformation than single relief hole with larger diameter. The nearfield vibrations were also recorded by placement of seismographs. The waveform analysis of the recorded vibration was carried out. The redesigning of the blasting pattern was done using the results of numerical simulation and waveform analysis. The redesigned pattern consists of four relief holes of 115 mm diameter. It was found that the number of cut blast holes firing simultaneously should not be more than two in order to get the optimum breakage for the modelled condition. The blasting output with the revised design has resulted into the considerable improvements in the pull and reduction of overbreak. The revised pattern has addressed the issues of the socket formation at the site.
Article highlights
-
The manuscript covers numerical simulation based approach for assessment of blast induced deformation in an underground face blast under different variations of diameter and numbers of relief holes.
-
The numerical simulation based output reveals that the blast face shows more controlled deformation while using multiple number of relief holes of optimum diameter as compared to a single large daimeter relief hole.
-
The numerical simulation output in this paper has been used to redesign the blasting pattern of the face blast of a Lead-Zinc underground mine.
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.References
Abdel-Meguid M, Rowe RK, Lo KY (2003) Three-dimensional analysis of unlined tunnels in rock subjected to high horizontal stress. Can Geotech J 40:1208–24. https://doi.org/10.1139/t03-057
Allen RM (2014) An analysis of burn cut pull optimization through varying relief hole depths. Master Thesis, Missouri University of Science and Technology, Missouri, pp 8–9.
Ansys Autodyn Manual v 18.0.
Artero-Guerrero J, Pernas-Sánchez J, Teixeira-Dias F (2017) Blast wave dynamics: the influence of the shape of the explosive. J Hazard Mater 331:189–199. https://doi.org/10.1016/j.jhazmat.2017.02.035
Bieniawski ZT (1968) Fracture dynamics of rock. Int J Fract Mech. https://doi.org/10.1007/BF00186807
Bullock RL, Rostami J (2013) Tunneling and Underground Construction. Min 383 class notes, Missouri University of Science and Technology. Rolla, MO, USA
Bureau of Indian Standard (1979) Method for preparation of rock specimen for laboratory testing (IS: 9179–1979).
Bureau of Indian Standard (1981) Method of test for the determination of tensile strength by indirect tests on rock specimens (IS: 10082–1981).
Castedo R, Natale M, López LM, Sanchidrián JA, Santos AP, Navarro J (2018) Estimation of Jones-Wilkins-Lee parameters of emulsion explosives using cylinder tests and their numerical validation. Int J Rock Mech Min Sci 112:290–301. https://doi.org/10.1016/j.ijrmms.2018.10.027
Das R, Singh TN (2021) Effect of rock bolt support mechanism on tunnel in jointed rockmass: a numerical approach. Underground Space 6(4):409–420. https://doi.org/10.1016/j.undsp.2020.06.001
Davis LL, Hill LG (2001) In: AIP conference proceedings, Vol. 620, American Institute of Physics, pp 165–168
Gupta SN, Arora YK, Mathur RK, Iqbaluddin B, Prasad B, Sahni TN, Sharma SB (1995) Geological map of the Precambrians of the Aravalli region. southern Rajasthan and northeastern Gujarat. India (4 sheets. scale 1: 250,000). Geol. Surv. India.
Hasanipanah M, Monjezi M, Shahnazar A, Jahed Armaghani D, Farazmand A (2015) Feasibility of indirect determination of blast induced ground vibration based on support vector machine. Measurement 75:289–297. https://doi.org/10.1016/j.measurement.2015.07.019
Himanshu VK, Roy MP, Shankar R, Mishra AK, Singh PK (2021) Empirical approach based estimation of charge factor and dimensional parameters in underground blasting. Min Metall Explor 38:1059–1069. https://doi.org/10.1007/s42461-020-00374-8
Himanshu VK, Mishra AK, Roy MP, Vishwakarma AK, Singh PK (2021b) Numerical simulation based approach for assessment of blast induced deformation pattern in slot raise excavation. Int J Rock Mech Min Sci 144:104816. https://doi.org/10.1016/j.ijrmms.2021.104816
Holmberg R, Persson PA (1978) The Swedish approach to contour blasting. In: Proceedings of 4th annual conference of explosion blasting resonance international society of explosion engineering, pp 113–27.
Hu Y, Lu W, Chen M, Yan P, Zhang Y (2015) Numerical simulation of the complete rock blasting response by SPH-DAM-FEM approach. Simul Model Pract Theory 56:55–68. https://doi.org/10.1016/j.simpat.2015.04.001
Jimeno CL, Jimeno EL, Carcedo FJA (1995) Drilling and blasting of rocks. CRC, Boca Raton, p 219
Kumar VH, Kumar SN, Mahendra S, Venkat RV (2014) Blast induced damage to surrounding rock mass in an underground excavation. J Geol Resour Eng. https://doi.org/10.17265/2328-2193/2014.01.002
Mandal S K, Singh M M, Bhagat N K, Das Gupta S (2005) Causes of overbreak and influence of blast parameters for smooth undamaged wall. In: International symposium on advances in mining technology and management, IIT, Kharagpur, pp 49–58.
Mandal SK, Singh MM (2009) Evaluating extent and causes of overbreak in tunnels. Tunn Undergr Sp Technol 24:22–36. https://doi.org/10.1016/j.tust.2008.01.007
Mishra B, Upadhyay D, Bernhardt HJ (2006) Metamorphism of the host and associated rocks at the Rajpura-Dariba massive sulfide deposit Northwestern India. J Asian Earth Sci 26:21–37. https://doi.org/10.1016/j.jseaes.2004.09.012
Mitelman A, Elmo D (2014) Modelling of blast-induced damage in tunnels using a hybrid finite-discrete numerical approach. J Rock Mech Geotech Eng 6:565–573. https://doi.org/10.1016/j.jrmge.2014.09.002
Monjezi M, Ahmadi M, Sheikhan M, Bahrami A, Salimi AR (2010) Predicting blast-induced ground vibration using various types of neural networks. Soil Dyn Earthq Eng 30:1233–1236. https://doi.org/10.1016/j.soildyn.2010.05.005
Murthy VMSR, Dey K (2002) Development of predictive models for blast-induced rock damage assessment (BIRD) in tunnels. MHRD Project No: MHRD (27)/99–00/111/ME: 12–43.
Onederra IA, Furtney JK, Sellers E, Iverson S (2013) Modelling blast induced damage from a fully coupled explosive charge. Int J Rock Mech Min Sci 58:73–84. https://doi.org/10.1016/j.ijrmms.2012.10.004
Pan C, Li X, Li J, Zhao J (2021) Numerical investigation of blast-induced fractures in granite: insights from a hybrid LS-DYNA and UDEC grain-based discrete element method. Geomech Geophys Geo-Energ Geo-Resour 7:49. https://doi.org/10.1007/s40948-021-00253-6
Pramanik R, Deb D (2015) Implementation of smoothed particle hydrodynamics for detonation of explosive with application to rock fragmentation. Rock Mech Rock Eng 48:1683–1698. https://doi.org/10.1007/s00603-014-0657-y
Rezaeineshat A, Monjezi M, Mehrdanesh A, Khandelwal M (2020) Optimization of blasting design in open pit limestone mines with the aim of reducing ground vibration using robust techniques. Geomech Geophys Geo-Energ Geo-Resour 6:40. https://doi.org/10.1007/s40948-020-00164-y
Saghatforoush A, Monjezi M, Shirani Faradonbeh R, Jahed Armaghani D (2016) Combination of neural network and ant colony optimization algorithms for prediction and optimization of flyrock and back-break induced by blasting. Eng Comput 32:255–266. https://doi.org/10.1007/s00366-015-0415-0
Sanchidrián JA, López LM (2006) Calculation of the energy of explosives with a partial reaction model. comparison with cylinder test data. Propellants Explos Pyrotech 31:25–32. https://doi.org/10.1002/prep.200600003
Sharma PD (2005) Tunnel Blasting – Emulsion Explosives and Proper Blast Design are the Prerequisite for Better Efficiency. Indian J Mines. Met Fuel 9:154–165
Singh S (2018) Overbreak control in underground mines. Rock Mech Open Access J 1(1):11–17
Singh SP (1995) Mechanism of cut blasting. Trans Inst Min Metall 104(A1):134–138
Sugden T, Deb M, Windley BF (1990) Tectonic setting of mineralization in the Proterozoic Aravalli–Delhi orogenic belt, Northwestern India. In: Naqvi. S.M. (Ed.). Precambrian continental crust and its economic resources developments of precambrian geology. Elsevier, Amsterdam, pp 367–90.
Verma HK, Samadhiya NK, Singh M, Goel RK, Singh PK (2018) Blast induced rock mass damage around tunnels. Tunn Undergr Sp Technol 71:149–158. https://doi.org/10.1016/j.tust.2017.08.019
Verma HK, Samadhiya NK, Singh M, Prasad VVR, Goel RK (2016) Investigations of rock mass damage induced by blasting. J Rock Mech Tunn Technol 22:2016–2065
Verma HK, Samadhiya NK, Singh M, Prasad VVR (2014) Blast induced damage to surrounding rock mass in an underground excavation. J Geo Res Eng 2:13–19. https://doi.org/10.17265/2328-2193/2014.01.002
Vishwakarma AK, Himanshu VK, Kumar S, Roy MP (2020) Overbreak control in development face blasting of underground metal mine- a case study.In: Proceeding of national conference on advance mining, pp 473–82.
Wang J, Yin Y, Esmaieli K (2018) Numerical simulations of rock blasting damage based on laboratory-scale experiments. J Geophys Eng 15:2399–2417. https://doi.org/10.1088/1742-2140/aacf17
Xiao SY, Su LJ, Jiang YJ, Liu ZX (2019) Numerical analysis of hard rock blasting unloading effects in high in situ stress fields. Bull Eng Geol Environ 78:867–875. https://doi.org/10.1007/s10064-017-1067-7
Xia Y, Jiang N, Zhou C, Meng X, Luo X, Wu T (2021) Theoretical solution of the vibration response of the buried flexible HDPE pipe under impact load induced by rock blasting. Soil Dyn Earthq Eng 146:106743. https://doi.org/10.1016/j.soildyn.2021.106743
Xu L, Schreyer H, Sulsky D (2015) Blast-induced rock fracture near a tunnel. Int J Numer Anal Methods Geomech 39:23–50. https://doi.org/10.1002/nag.2294
Zhang X, Nguyen H, Bui XN, Tran QH, Nguyen DA, Bui DT et al (2020) Novel soft computing model for predicting blast-induced ground vibration in open-pit mines based on particle swarm optimization and XGBoost. Nat Resour Res 29:711–721. https://doi.org/10.1007/s11053-019-09492-7
Acknowledgements
Authors would like to thank the mine management of Rajpura Dariba Mine of M/s Hindustan Zinc Limited for the necessary support during the experimental trials. The support of Dr. Ravi Shankar, Project Assistant of CSIR-CIMFR is also thankfully acknowledged.
Author information
Authors and Affiliations
Corresponding author
Ethics declarations
Conflict of interest
On behalf of all authors, the corresponding author states that there is no conflict of interest.
Additional information
Publisher's Note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
About this article
Cite this article
Himanshu, V.K., Mishra, A.K., Vishwakarma, A.K. et al. Explicit dynamics based numerical simulation approach for assessment of impact of relief hole on blast induced deformation pattern in an underground face blast. Geomech. Geophys. Geo-energ. Geo-resour. 8, 19 (2022). https://doi.org/10.1007/s40948-021-00327-5
Received:
Accepted:
Published:
DOI: https://doi.org/10.1007/s40948-021-00327-5