Abstract
Open cast mines are the prime source of coal production in India. Due to an increase in coal demand, deeper surface mines are being planned to ensure better productivity with enhanced safety of these mines. The safe working environment and continuous production of the coal calls for the safe and stable design of cut slopes. The stability analysis of this slope requires in depth geotechnical investigation which are aided by result orientated stability assessment using empirical methods and numerical simulation. In the present study, a slope was examined to understand the mechanism and comparisons were made with field observations. The investigation has involved a 32m high cut slope from an open cast mine in Wardha valley coal field which has been analyzed using a two dimensional numerical simulation. The bench slope consisted of a low strength sandstones, shales and clay sequence. Hoek-Brown strength parameters established and used as input parameters in the model. The results indicate that the slope is critically stable and may lead to failure without warning and needs proper attention.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Barton, N., Lien, R. and Lunde, J. (1974) Engineering classification of rock masses for the design of tunnel support. Rock Mechanics, v.6(4), pp.189–236.
Bieniawski, Z.T. (1989) Engineering Rock Mass classifications: a complete manual for engineers and geologists in mining, civil and petroleum engineering, Wiley, New York, 251p.
Bishop, A.W. (1955) The use of the slip circle in the stability analysis of slopes. Geotechnique, v.5, pp.7–17.
Brawner, C.O., Pentz, D.L. and Compbell, D.B. (1975) Ground Stability in surface coal mines. Mining Congress Jour. v.61(6), pp.42–53.
Brawner, C.O. (1978) Stability in open pit and strip mining coal project, 1st International Symposium Stability in coal mining. Vancouver, pp.13-28.
Coates, D.F. (1964) Classification of rock for rock mechanics. Internat. Jour. Rock Mechanics & Mining Sci., v.1, pp.421–429.
Du Plessis, L. and Martin, D.C. (1991) Numerical modelling studies for design of high rock slopes at Palabora Copper Mine, Proceeding. 7th International Congress. International Society Rock Mechanics. Aachen, v.1, pp.799–804.
Goodman, R.E. (1989) Introduction to Rock Mechanics. 2nd edition. Wiley, New York, 562p.
Gupta, K.K. and Singh, D.P. (1985) Input parameters for rock slope design in open cast mine, 3rd Rock Mechanics Symposium. Roorkee, pp.27–37.
Hoek, E. and Bray, J.W. (1981) Rock Slope Engineering, 3rd ed. Institute of Mining and Metallurgy, London, 358p.
Hoek, E. and Brown, E.T. (1998) Practical estimates of rock mass strength. Internat. Jour. Rock Mechanics & Mining Sci., v.34, pp.1165–1186.
Hoek, E. and Karzulovic, A. (2000) Rock mass properties for surface mines. In: McCarter and Van Zyl (Eds.), Slope Stability in Surface Mining, Hustrulid, SME, Colorado, pp.59–70.
Hoek, E., Marinos, P. and Benissi, M. (1998) Applicability of the geological strength index (GSI) classification for very weak and sheared rock masses. The case of the Athens Schist Formation. Earth Environ. Sci. Bull. Engg. Geol. Environ., v.57(2),pp.151–160.
Janbu, N. (1954) Application of composite slip surface for stability analysis. In: Proc. European Conf. Stability of Earth Slopes, Stockholm, Sweden, pp.43–49.
Janbu, N. (1968) Slope stability computations. Institute for Geotknikk og Fundamenteringslære, Norges Tekniske Høskole, Soils Mechanics and Foundation Engineering, the Technical University of Norway.
Jhanwar, J.C., Chakraborty, A.K. and Thote, N.R. (2008) Investigation into the slope failure in an opencast coal mine—a case study. In: M.K. Mishra and H.B. Sahu (Eds.), Proceedings of Conference on Emerging Trends in Mining and Allied Industries. NIT Rourkela, pp.137–143.
Jhanwar, J.C., Saini, G.S. and Jethwa, J.L. (1996) Ground movement monitoring and stability assessment for a coal handling plant and workings of an opencast coal mine—a case study. In: R. Nath and B.P. Pandey (Eds.), Proceedings of National Conference on Ground Control in Mining. BHU-Varanasi, pp.433–444.
Jhanwar, J.C. and Thote, N.R. (2010) Investigation into slope failure in an opencast coal mine of WardhaValley Coalfield—a case study. Indian Mining Engg. Jour., v.49(4), pp.36–40.
Jhanwar, J. C. and THOTE, N. R. (2011) Slope Failures in the Opencast Coal Mines of Wardha Valley Coalfield in Central India: A Study, Rock Mechanics & Rock Engineering. DOI 10.1007/s00603-011-0139-4.
Monjezi, M. and Singh, T.N. (2000) Slope instability in an open cast mine. Coal International, pp.145–147.
Oztekin B., Topal T. and Kolat, C. (2006) Assessment of degradation and stability of a cut slope in limestone. Ankara-Turkey. Engg. Geol., v.84(1–2), pp.12–30.
Pettifer, G.S. and Fookes, P.G. (1994) A revision of the graphical method for assessing the excavatability of rock. Quart. Jour. Engg. Geol., v.27, pp.145–164.
Rocscience, (2002) RocLab-Rock mass strength analysis using the Hoek-Brown failure criterion.
Rocscience, (2010) Slide 6.0 (http://www.rocscience.com)
Sarkar, K. and Singh, T.N. (2007) Evaluation of Instability Analysis of Slope — A Numerical Approach, Mining Engg. Jour., v.8(10), pp.11–31.
Singh, P.K. and Singh, T.N. (1996) Prediction of slope of open cast mine situated in fault rock mass by equivalent material modeling, 2nd National conference on Ground control in mining. India, pp.39–47.
Singh, T.N., Sharma, P.K. and Pandey, V. (2007) Numerical Approach for Evaluation of Instability of Slopes. International conference on Regional Rock Mechanics Symposium, Sri Lanka, pp.1–5.
Singh, T.N., Ulabhaje, A.V., Singh, D.P. and Gupta, K.K. (1989) Planning of slope stability in opencast mine-A model study, 3rd National Seminar on Surface Mining. Indian Mining & Engineering Jour., Dhanbad, pp.5.2.1–5.2.10.
Singh, V.K. and Dhar, B.B. (1994) Stability analysis of open-pit copper mine by use of numerical modelling methods, Trans. Institute of Mining and Metallurgical (Section A: Min. Industry), v.103, pp.A67–A74.
Singh, V.K., Prasad, M., Singh, S.K., Ras, D.G. and Singh, U.K. (1995) Slope design based on geotechnical study and numerical modelling of a deep open pit mine in India, Internat. Jour. Surface Mining, Reclamation and Environ., v.9, pp.105–111.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Verma, D., Kainthola, A., Thareja, R. et al. Stability analysis of an open cut slope in Wardha valley coal field. J Geol Soc India 81, 804–812 (2013). https://doi.org/10.1007/s12594-013-0105-8
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12594-013-0105-8