Abstract
A thermally grown oxide (TGO) layer of Al2O3 is formed between a CoNiCrAlY bond coating and a zirconia top coating of a thermal barrier coating (TBC) system on an Inconel 738 substrate during exposure at 1050°C. Thick TGO is vulnerable to damage in terms of cracking and spallation. In order to estimate the TBC failure, fundamental damage data of TGO that is induced by compressed air are monitored to determine the failure mode and the state of damage by using a nondestructive acoustic emission (AE) system. The defects of the TGO are detected and evaluated by means of AE signal analysis with the root mean squared value in the frequency range of 100 kHz to 400 kHz. The thickness of the TGO increased with the oxidation time. The RMS (Root Mean Square) value decreased almost linearly as the TGO thickness increased up to the failure of the TBC. The amplitude of the AE signal decreased dramatically when the TGO was delaminated. The AE signals for pattern classification were evaluated in accordance with the TBC layer. It is conceivable that the center value represents the damage state of the TBC coating.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Abbreviations
- M:
-
Ni, Fe, Co or their combination
References
Song, Y. S., Lee, I. G., Lee, D. Y., Kim, D. J., Kim, S., and Lee, K., “High-Temperature Properties of Plasma-Sprayed Coatings of YSZ/ NiCrALY on Inconel Substrate,” Materials Science and Engineering: A, Vol. 332, No. 1, pp. 129–133, 2002.
Lee, K. H., Park, J. H., Ye, K. H., Jeon, C. H., Kim, S. T., et al., “Acoustic Emission Source Analysis of Vacuum Plasma Sprayed Conicraly Coatings,” Journal of the Korean Physical Society, Vol. 48, No. 6, pp. 1691–1695, 2006.
Dong, Z. L., Khor, K. A., and Gu, Y. W., “Microstructure Formation in Plasma-Sprayed Functionally Graded NiCoCrAlY/Yttria-Stabilized Zirconia Coatings,” Surface and Coatings Technology, Vol. 114, No. 2, pp. 181–186, 1999.
Ravichandran, K. S., An, K., Dutton, R. E., and Semiatin, S., “Thermal Conductivity of Plasma-Sprayed Monolithic and Multilayer Coatings of alumina and Yttria-Stabilized Zirconia,” Journal of the American Ceramic Society, Vol. 82, No. 3, pp. 673–682, 1999.
Khor, K. A. and Yang, J., “Rapidly Solidified Neodymia-Stabilised Zirconia Coatings Prepared by DC Plasma Spraying,” Surface and Coatings Technology, Vol. 96, No. 2, pp. 313–322, 1997.
Brindley, W. J., “Properties of Plasma-Sprayed Bond Coats,” Journal of Thermal Spray Technology, Vol. 6, No. 1, pp. 85–90, 1997.
Trochidis, A. and Polyzos, B., “Dislocation Annihilation and Acoustic Emission during Plastic Deformation of Crystals,” Journal of the Mechanics and Physics of Solids, Vol. 42, No. 12, pp. 1933–1944, 1994.
Baram, J. and Rosen, M., “Effect of Grain Size on the Acoustic Emission Generated during the Plastic Deformation of Aluminum,” Materials Science and Engineering, Vol. 45, No. 3, pp. 255–262, 1980.
Dunn, J. C., “A Fuzzy Relative of the ISODATA Process and Its Use in Detecting Compact Well-Separated Clusters,” Journal of Cybernetics, Vol. 3, No. 3, pp. 32–57, 1973.
Bezdek, J. C., “Pattern Recognition with Fuzzy Objective Function Algorithms,” Kluwer Academic Publishers, pp. 43–92, 1981.
Chen, W. R., Wu, X., Marple, B. R., Nagy, D. R., and Patnaik, P. C., “TGO Growth Behaviour in TBCs with APS and HVOF Bond Coats,” Surface and Coatings Technology, Vol. 202, No. 12, pp. 2677–2683, 2008.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, PH., Kim, JS., Park, JH. et al. Classification of defects in a thermal barrier coating layer using the fuzzy C-means algorithm. Int. J. Precis. Eng. Manuf. 16, 53–57 (2015). https://doi.org/10.1007/s12541-015-0006-4
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12541-015-0006-4