Abstract
Walking with the knee joint locked increases the amplitude of pelvic tilt and results in an unnatural gait. This paper introduces a powered gait orthosis with a moveable knee joint designed to improve the gait speed of patients with spinal cord injury (SCI). The unlockable knee joint powered gait orthosis (UKJ-PGO) uses a gas spring cylinder and a solenoid locking device to enable flexion of the joint, while the rigidity of the hip-joint device is enhanced using air muscles. A gait analysis was conducted to evaluate the performance of the UKJ-PGO, and the kinematic parameters obtained were compared with those of a standard PGO. In the gait of SCI patients using the UKJ-PGO, the new knee-joint device enabled flexion during the swing phase and showed a decrease in pelvic tilt compared with the standard PGO gait. As greater flexion was possible at the knee joint, the duration of the stance phase substantially decreased to near to the normal value, and the duration of the swing phase increased accordingly. In addition, the gait using the UKJ-PGO was faster than that with the standard PGO.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Abbreviations
- UKJ-PGO:
-
unlockable knee joint powered gait orthosis
- RGO:
-
reciprocating gait orthosis
References
Douglas, R., Larson, P. F., D’Ambrosia, R. and McCall, R. E., “The LSU reciprocating gait orthosis,” Orthopedics, vol. 6, pp. 834–839, 1983.
Beckman, J., “The Louisiana State University reciprocating gait orthosis,” Physiotherapy, vol. 73, pp. 386–392, 1987.
Salter, C., “The Louisiana State University Reciprocating Gait Orthosis for adult spinal cord injured patients,” Physiotherapy, vol. 41, pp. 13–15, 1989.
Jefferson, R. J. and Whittle, M. W., “Performance of three walking orthoses for the paralyzed: a case study gait analysis,” Prosthet. Orthot. Int., vol. 14, pp. 103–110, 1990.
Lissens, M. A., Peeraer, L., Tirez, B. and Lysens, R., “Advanced Reciprocating gait Orthosis (ARGO) in paraplegic patients,” Eur. J. Phys. Med. Rehab., vol. 3, pp. 147–156, 1993.
Ijzerman, M. J., Baardman, G., Hermens, H. J., Veltink, P., Boom, H. B. K. and Zilvold, G., “The influence of the reciprocal cable performance,” Prosthet. Orthot. Int., vol. 21, pp. 52–61, 1997.
Motloch, W., “Principles of orthotic management for child and adult paraplegia and clinical experience with the Isocentric RGO,” Proceedings of 7th World Congress of the International Society in Prosthetics and Orthotics, p. 28, 1992.
Winchester, P. K, Carollo, J. J., Parekh, R. N., Lutz, L. M. and Aston, J. J., “A comparison of paraplegic gait performance using two types of reciprocating gait orthoses,” Prosthet. Orthot. Int., vol. 17, pp. 101–106, 1993.
Harvey, L. A., Davis, G. M., Smith, M. B. and Engel, S., “Energy expenditure during gait using the Walkabout and the Isocentric Reciprocal Gait Orthosis in persons with paraplegia,” Arch Phys. Med. Rehabil., vol. 79, No. 8, pp. 945–949, 1998.
Solomonow, M., Baratta, R., Shoji, H., Ichie, M., Hwang, S., Rightor, N., Walker, W., Douglas, R. and D’Ambrosia, R., “FES powered locomotion of paraplegics fitted with the LSU reciprocating gait orthoses (RGO),” Proc. Annual Int. Conf. IEEE Eng. Medicine and Biology Soc., vol. 4, p. 1672, 1988.
Ruthenberg, B. J., Wasylewski, N. A. and Beard, J. E., “An experimental device for investigating the force and power requirements of a powered gait orthosis,” J. of Rehabilitation, vol. 34, No. 2, pp. 203–213, 1997.
Ohta, Y., Yano, H., Suzuki, R., Yoshida, M., Kawashima, N. and Nakazawa, K., “A two-degree-of-freedom motor-powered gait orthosis for spinal cord injury patients,” Journal of Engineering in Medicine, vol. 221, No. 6, pp. 629–639, 2007.
Kang, S. J., Ryu, J. C., Kim, G. S. and Mun, M. S, “Hip Joint Control of PGO for Paraplegics,” Key Engineering Material, vol. 326–328, pp. 735–738, 2006.
Ferrarin, M., Stallard, J., Palmieri, R. and Pedotti, A., “Estimation of deformation in a walking orthosis for paraplegic patients,” Clin. Biomech., vol. 8, pp. 255–261, 1993.
Klute, G. K., Czerniecki, J. M. and Hannaford, B., “McKibben Artificial Muscles: Pneumatic Actuators with Biomechanical Intelligence,” Proceeding of the IEEE/ASME 1999 International Conference on Advanced Intelligent Mechatronics (AIM’99), pp. 221–226, 1999.
Colbrunn, R. W., “Design and Control of a Robotic Leg with Braided Pneumatic Actuators,” M.S. Thesis, CASE WESTERN RESERVE UNIV., pp. 5–19, 2000.
Edwards, J. and Rithalia, S., “Powered hip orthosis,” Springer-Verlag, pp. 483–492, 1996.
Christopher, L. V. and Brian, L. D., “Dynamics of Human Gait (2nd edition),” Kiboho Publishers, pp. 97–106, 1999.
Lee, J. W. and Lee, G. K., “Adaptive Postural Control for Trans-Femoral Prostheses Based on Neural Networks and EMG Signals,” International Journal of Precision Engineering and Manufacturing, vol. 6, No. 3, pp. 37–44, 2005.
Liu, H., Lee, J. C. and Li, B. R., “High Precision Pressure Control of a Pneumatic Chamber using a Hybrid Fuzzy PID Controller,” International Journal of Precision Engineering and Manufacturing, vol. 8, No. 3, pp. 8–13, 2007.
Bae, T. S., Kim, S. K. and Mun, M. S., “A Musculoskeletal Model for Biomechanical Analysis of Transfemoral Amputees Climbing Stairs,” International Journal of Precision Engineering and Manufacturing, vol. 9, No. 1, pp. 30–33, 2008.
Saunders, J. B. D. M., Inman, V. T. and Eberhart, H. S., “The major determinants in normal and pathological gait,” Journal of Bone and Joint Surgery, vol. 35, pp. 543–558, 1953.
Peter, J. G. and Malcolm, H. G., “A knee and ankle flexing hybrid orthosis for paraplegic ambulation,” Medical Engineering & Physics, vol. 25, No. 7, pp. 539–545, 2003.
Murray, M., “Gait as total pattern of movement,” American Journal of Physical, vol. 46, No. 1, pp. 290–333, 1967.
Saleh, M. and Murdoch, G., “In defence of gait analysis. Observation and measurement in gait assessment,” Journal of Bone and Joint Surgery, vol. 67-B, No. 2, pp. 237–241, 1985.
Robinson, J. L. and Smidt, G. L., “Quantitative gait evaluation in the clinic,” Physical Therapy, vol. 61, No. 3, pp. 351–353, 1981.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Kim, G., Kang, S., Kang, S. et al. Unlockable knee joint mechanism for powered gait orthosis. Int. J. Precis. Eng. Manuf. 10, 83–89 (2009). https://doi.org/10.1007/s12541-009-0051-y
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12541-009-0051-y