Abstract
This study investigates the effects of parameters such as a blade profile (changing the digit of the 4-digit NACA00xx airfoil), the Reynolds number, and the solidity on the performance characteristics of a straight bladed vertical axis wind turbine (VAWT). A numerical analysis, adopting the multiple stream tube (MST) method, is carried out to evaluate the performance depending on the parameters. The numerical result shows that the variation of a blade profile directly influences the power production, i.e., the high-digit NACA00xx airfoil provides higher power in a low speed zone (BSR < 3; BSR: blade speed ratio (ΩR/U f ), Ω: angular velocity of blade, R: radius of a straight Darrieus wind turbine, U f : free stream velocity) than the low-digit NACA00xx profile. On the contrary, the low-digit NACA00xx airfoil produces higher power in a high speed range (BSR > 5) than the high-digit NACA00xx profile. An enhancement of the power production is observed with increasing the Reynolds number on the whole tested blade speed ratio range (1 < BSR < 12). In particular, the rate of the enhancement of the power is rapidly decreased with the increases of the Reynolds number (\(Re = {{\rho \bar U_r c} \mathord{\left/ {\vphantom {{\rho \bar U_r c} \mu }} \right. \kern-\nulldelimiterspace} \mu }\), ρ: air density, \(\bar U_r\): mean resultant velocity acting on a blade with variable rotating speeds in a uniform free stream velocity (U f ), c: blade chord length, µ: air viscosity). For the effect of the solidity on the power production, a marked reduction of the range of the blade speed ratio that can provide the power is observed with increasing the solidity. A pattern of very steep variation of the power around the peak in the low speed zone (BSR < 3) is found in a high solidity range (σ > 0.3; σ: solidity (N c /R), N: number of blade, c: chord length of an airfoil), and this tendency is conspicuously different from that of the eggbeater-type Darrieus VAWT, which is interpreted as a gradual variation of the power around the peak.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
R. Howel, N. Qin, J. Edwards and N. Durrani, Wind tunnel and numerical study of a small vertical axis wind turbine, Renewable Energy, 35 (2010) 412–422.
M. Islam, D. S. K. Ting and A. Fartaj, Aerodynamic models for Darrieus-type straight-bladed vertical axis wind turbine, Renewable and Sustainable Energy Reviews, 12 (2008) 1087–1109.
M. M. A. Bhutta, N. Hayat, A. U. Farooq, Z. Ali, S. R. Jamil and Z. Hussain, Vertical axis wind turbine — A review of various configurations and design techniques, Renewable and Sustainable Energy Reviews, 16 (2012) 1926–1939.
J. Kjellin, F. Bülow, S. Eriksson, P. Deglaire, M. Leijon and H. Bernhoff, Power coefficient measurement on a 12 KW straight bladed vertical axis wind turbine, Renewable Energy, 36 (2011) 3050–3053.
S. Armstrong, A. Fiedler and S. Tullis, Flow separation on a high Reynolds number, high solidity vertical axis wind turbine with straight and canted blades and canted blades with fences, Renewable Energy, 41 (2011) 13–22.
P. Deglaire, S. Engblom, O. Ågren and H. Bernhoff, Analytical solutions for a single blade in vertical axis turbine motion in two-dimensions, European Journal of Mechanics B/Fluids, 28 (2009) 506–520.
B. K. Kirke and L. Lazauskas, Limitations of fixed pitch Darrieus hydrokinetic turbines and the challenge of variable pitch, Renewable Energy, 36 (2011) 893–897.
E. Hau, Wind turbines, Springer-Verlag Berlin Heidelberg, Germany (2006).
M. R. Castelli, A. Englaro and E. Benini, The Darrieus wind turbine: Proposal for a new performance prediction model, Energy, 36 (2011) 4919–4934.
S. V. Ghatage and J. B. Joshi, Optimisation of vertical axis wind turbine: CFD simulations and experimental measurements, The Canadian Journal of Chemical Engineering, 90 (2012) 1186–1201.
S. H. Wang and S. H. Chen, Blade number effect for a ducted wind turbine, Journal of Mechanical Science and Technology, 22 (2008) 1984–1992.
B. S. Kim, W. J. Kim, S. Y. Bae, J. H. Park and M. E. Kim, Aerodynamic design and performance analysis of multi-MW class wind turbine blade, Journal of Mechanical Science and Technology, 25(8) (2011) 1995–2002.
J. H. Strickland, The Darrieus turbine: a performance prediction model using multiple streamtubes, Sandia National Lab Report SAND75-0431, Sandia Laboratories, October (1975).
R. E. Sheldahl and P. C. Klimas, Aerodynamic characteristics of seven symmetrical airfoil sections through 180-degree angle of attack for use in aerodynamic analysis of vertical axis wind turbine, Sandia National Lab Report SAND80-2114, Sandia Laboratories, March (1981).
T. Burton, D. Sharpe, N. Tenkins and E. Bossanyi, Wind energy handbook, John Wiley & Sons Ltd, England (2001).
B. F. Blackwell, R. E. Sheldahl and L. V. Feltz, Wind tunnel performance data for the Darrieus wind turbine with NACA0012 blades, Sandia Lab Report SAND76-0130, Sandia Laboratories (1976).
W. Rozenn, C. S. Michael, L. J. Torben and P. S. Uwe, Simulation of shear and turbulence impact on wind turbine power performance, Riso-R-1722 (EN), Riso National Laboratory, Denmark, January (2010).
Author information
Authors and Affiliations
Corresponding author
Additional information
Recommended by Associate Editor Donghyun You
Sung-Cheoul Roh is an Associate Professor at the Department of Materials, Mechanical, and Automation Engineering of Yanbian University of Science and Technology in China. He received the B.S. from Seoul National University in 1991, and the M.S. and the Ph.D. from Korea Advanced Institute of Science and Technology (KAIST) in 1993 and in 2002, respectively, all in Mechanical Engineering. His recent interests are in wind turbine blade aerodynamics and enhancing the efficiency of solar energy system.
Seung-Hee Kang received the B.S. and M.S. from Korea Aerospace University in 1988 and 1991, respectively, and the Ph.D. from KAIST in 2005, all in Aerospace Engineering. He is an Associate Professor at the Department of Aerospace Engineering, Chonbuk National University. His current interests include numerical simulation, wind turbine blade, and wind tunnel testing.
Rights and permissions
About this article
Cite this article
Roh, SC., Kang, SH. Effects of a blade profile, the Reynolds number, and the solidity on the performance of a straight bladed vertical axis wind turbine. J Mech Sci Technol 27, 3299–3307 (2013). https://doi.org/10.1007/s12206-013-0852-x
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12206-013-0852-x