Abstract
Shear tests under normal unloading were carried out to further study the shear mechanical behavior of marlstone containing parallel fissures. The results reveal that the failure on the rock bridge is tensile failure except for the limited extrusion failure at the tip of the prefabricated fissure. The failure on both sides is generally tensile-shear mixed failure, in which the tensile failure is mainly concentrated in the middle of both sides. In general, it can be summarized as a tensile-shear failure mode of STS-T-STS (S means shear failure, T means tension failure). The failure normal stress of the specimens gradually increases and then decreases with the increase of the fissure inclination, increases with an increase in the initial normal/shear stress, and decreases with the increase of the unloading rate. Strong dilation occurred in the shear process of the specimens, which shows obvious arch effect. The variation law of dilatancy deformation and horizontal deformation in the stage of normal stress unloading is just opposite to that of the failure normal stress. The increasing effect of high shear stress on shear deformation is greater than that of dilatancy deformation, while the inhibiting effect of high normal stress on dilatancy deformation is greater than that of the shear deformation.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Brideau M, Yan M, Stead D (2009) The role of tectonic damage and brittle rock fracture in the development of large rock slope failures. Geomorphology 103(1):30–49, DOI: https://doi.org/10.1016/j.geomorph.2008.04.010
Eberhardt E, Stead D, Coggan JS (2004) Numerical analysis of initiation and progressive failure in natural rock slopes — The 1991 Randa rockslide. International Journal of Rock Mechanics and Mining Sciences 41(1):69–87, DOI: https://doi.org/10.1016/S1365-1609(03)00076-5
GB/T 50266-2013 (2013) Standard for tests method of engineering rock masses. GB/T 50266-2013, China Planning Press, Beijing, China (in Chinese)
Gehle C, Kutter HK (2003) Breakage and shear behaviour of intermittent rock joints. International Journal of Rock Mechanics and Mining Sciences 40(5):687–700
Gratchev I, Kim DH, Yeung CK (2016) Strength of rock-like specimens with pre-existing cracks of different length and width. Rock Mechanics and Rock Engineering 49(11):4491–4496, DOI: https://doi.org/10.1007/s00603-016-1013-1
Guo S, Qi S (2015) Numerical study on progressive failure of hard rock samples with an unfilled undulate joint. Engineering Geology 193(1):173–182, DOI: https://doi.org/10.1016/j.enggeo.2015.04.023
Hoek E (1983) Strength of jointed rock masses. Geotechnique 33(3):187–223, DOI: https://doi.org/10.1680/geot.1983.33.3.187
Huang R (2008) Geodynamical process and stability control of high rock slope development. Chinese Journal of Rock Mechanics and Engineering 27(8):1525–1544, DOI: https://doi.org/10.3321/j.issn:1000-6915.2008.08.002 (in Chinese)
Huang R, Huang D (2014) Evolution of rock cracks under unloading condition. Rock Mechanics and Rock Engineering 47(2):453–466, DOI: https://doi.org/10.1007/s00603-013-0429-0
Huang R, Qi S (2017) Engineering geology: Review and prospect of past ten years in China. Journal of Engineering Geology 25(2):257–276, DOI: https://doi.org/10.13544/j.cnki.jeg.2017.02.001 (in Chinese)
Lajtai EZ (1969) Shear strength of weakness planes in rock. International Journal of Rock Mechanics and Mining Sciences 6(5):499–515, DOI: https://doi.org/10.1016/0148-9062(69)90016-3
Liu E (2012) Deformation mechanisms of crushable blocky materials upon lateral unloading for a biaxial stress state. Rock Mechanics and Rock Engineering 45(3):439–444, DOI: https://doi.org/10.1007/s00603-011-0210-1
Post G, Bonazzi D (1987) Latest thinking on the malpasset accident. Engineering Geology 24(5):339–353, DOI: https://doi.org/10.1016/0013-7952(87)90071-8
Ren HL, Zhuang XY, Anitescu C, Rabczuk T (2019) An explicit phase field method for brittle dynamic fracture. Computers and Structures 217(2019):45–56, DOI: https://doi.org/10.1016/j.compstruc.2019.03.005
Tang F (1989) Mechanism analysis of landslide by mining. Journal of Xi’an Mining Institute 3(3):32–36, DOI: https://doi.org/10.13800/j.cnki.xakjdxxb.1989.03.007 (in Chinese)
Terzaghi K (1962) Stability of steep slopes on hard unweathered rock. Geotechnique 12(4):251–270, DOI: https://doi.org/10.1680/geot.1962.12.4.251
Wong RHC, Leung WL, Wang SW (2001) Shear strength studies on rock-like models containing arrayed open joints. Proceedings of the 38th US symposium on rock mechanics (USRMS), July 7–10, Washington DC, USA
Wong R, Wang S (2002) Experimental and numerical study on the effect of material property, normal stress and the position of joint on the progressive failure under direct shear. Proceedings of the mining and tunneling innovation and opportunity, July 7–10, Toronto, ON, Canada
Xiao R, Chen H, Leng Y, Wei Y, Wang W (2018a) Preliminary analysis on the failure process and mechanism of the August 28 collapse in Nayong County, Guizhou Province. The Chinese Journal of Geological Hazard and Control 29(1):3–9, DOI: https://doi.org/10.16031/j.cnki.issn.1003-8035.2018.01.02 (in Chinese)
Xiao T, Huang M, Cheng C, He Y (2018b) Experimental investigation on the mechanical characteristics and deformation behaviour of fractured rock-like material with one single fissure under the conventional triaxial compression. Shock and Vibration 2018(2018):1–11, DOI: https://doi.org/10.1155/2018/2608639
Xie H Q, He C (2004) Study of the unloading characteristics of a rock mass using the triaxial test and damage mechanics. International Journal of Rock Mechanics and Mining Sciences 41(3):74–80, DOI: https://doi.org/10.1016/j.ijrmms.2004.03.022
Yang S, Jiang Y Z, Xu W, Chen X (2008) Experimental investigation on strength and failure behavior of pre-cracked marble under conventional triaxial compression. International Journal of Solids and Structures 45(17):4796–4819, DOI: https://doi.org/10.1007/978-3-662-47303-0_8
Yin Z, Liu X, Yang Z, Jiang Y, Zhao Y, Li S (2020) Shear characteristics and failure mode of hard brittle marl with parallel discontinuous structural plane. Arabian Journal for Science and Engineering 45:8219–8229, DOI: https://doi.org/10.1007/s13369-020-04674-5
Zhang J, Zhou X (2020) AE event rate characteristics of flawed granite: From damage stress to ultimate failure. Geophysical Journal International 222(2):795–814, DOI: https://doi.org/10.1093/gji/ggaa207
Zhang J, Zhou X, Zhou L, Berto F (2019) Progressive failure of brittle rocks with non-isometric flaws: Insights from acousto-optic-mechanical (AOM) data. Fatigue and Fracture of Engineering Materials and Structures 42(8):1787–1802, DOI: https://doi.org/10.1111/ffe.13019
Zhao Z, Jing H, Shi X, Han G (2019) Experimental and numerical study on mechanical and fracture behavior of rock-like specimens containing pre-existing holes flaws. European Journal of Environmental and Civil Engineering 2:1–21, DOI: https://doi.org/10.1080/19648189.2019.1657961
Zhong Z, Huang D, Zhang Y, Ma G (2020) Experimental study on the effects of unloading normal stress on shear mechanical behaviour of sandstone containing a parallel fissure pair. Rock Mechanics and Rock Engineering 53(4):1647–1663, DOI: https://doi.org/10.1007/s00603-019-01997-0
Zhou S, Rabczuk T, Zhuang X (2018a) Phase field modeling of quasistatic and dynamic crack propagation: Comsol implementation and case studies. Advances in Engineering Software 122:31–49, DOI: https://doi.org/10.1016/j.advengsoft.2018.03.012
Zhou S, Zhuang X, Rabczuk T (2018b) A phase-field modeling approach of fracture propagation in poroelastic media. Engineering Geology 240:189–203, DOI: https://doi.org/10.1016/j.enggeo.2018.04.008
Zhou S, Zhuang X, Rabczuk T (2019) Phase field modeling of brittle compressive-shear fractures in rock-like materials: A new driving force and a hybrid formulation. Computer Methods in Applied Mechanics and Engineering 355:729–752, DOI: https://doi.org/10.1016/j.cma.2019.06.021
Zhuang X, Zhou S, Sheng M, Li G (2019) On the hydraulic fracturing in naturally-layered porous media using the phase field method. Engineering Geology 266:105306, DOI: https://doi.org/10.1016/j.enggeo.2019.105306
Acknowledgments
This work was supported by the National Key R and D Program of China (Grant No. 2018YFC1504802); the Fundamental Research Funds for the Central Universities (Grant No.2019CDXYTM0032); and the National Natural Science Foundation of China (Grant No. 41972266).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Yin, Z., Liu, X., Yang, Z. et al. Shear Behavior of Marlstone Containing Parallel Fissure under Normal Unloading. KSCE J Civ Eng 25, 1283–1294 (2021). https://doi.org/10.1007/s12205-021-0959-z
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s12205-021-0959-z