Abstract
We examine a thermoelectric harvester that converts electrical energy from the naturally occurring temperature difference between ambient air and large thermal storage capacitors such as building walls or the soil. For maximum power output, the harvester design is implemented in two steps: source matching of the thermal and electrical interfaces to the energy source (system level) followed by load matching of the generator to these interfaces (subsystem level). Therefore, we measure thermal source properties such as the temperature difference, the air velocity, and the cutoff frequency in two application scenarios (road tunnel and office building). We extend a stationary model of the harvester into the time domain to account for transient behavior of the source. Based on the model and the source measurements, we perform the source and load matching. The resulting harvester consists of a pin fin heat sink with a thermal resistance of 6.2 K/W and a cutoff frequency 2.5 times greater than that of the source, a thermoelectric generator, and a DC/DC step-up converter starting at a total temperature difference of only ΔT = 1.2 K. In a final road tunnel field test, this optimized harvester converts 70 mJ of electrical energy per day without any direct solar irradiation. The energy provided by the harvester enables 415 data transmissions from a wireless sensor node per day.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
J.M.W. Brownjohn, Philos. Trans. R. Soc. 365, 589 (2007).
S. Roundy, P.K. Wright, and J.M. Rabaey, Energy Scavenging for Wireless Sensor Networks (Boston: Kluwer Academic, 2003).
J. Henderson, Proc. of the 14th Intersociety Energy Conversion Engineering Conference (1979), p. 1835.
J.W. Stevens, Energy Convers. Manag. 42, 709 (2001).
K. Matsuura and D.M. Rowe, Handbook of Thermoelectrics, ed. D.M. Rowe (Boca Raton: CRC, 1995), p. 573.
E. Lawrence and G. Snyder, Proc. of the 21st International Conference on Thermoelectrics (2002), pp. 446–449. doi:10.1109/ICT.2002.1190357.
Y. Meydbray, R. Singh, and A. Shakouri, Proc. of the 24th International Conference on Thermoelectrics (2005), pp. 348–351. doi:10.1109/ICT.2005.1519958
F.P. Incropera, D.P. DeWitt, T.L. Bergman, and A.S. Lavine, Fundamentals of Heat and Mass Transfer, 6th ed. (Hoboken: Wiley, 2007).
K.K. Sikka, K.E. Torrance, C.U. Scholler, and P.I. Salanova, IEEE Trans. Compon. Packag. Technol. (2002). doi:10.1109/TCAPT.2002.1010019.
Verein Deutscher Ingenieure, VDI-Wärmeatlas (Springer, Berlin, 2006).
J.M. Damaschke, IEEE Trans. Ind. Appl. 33, 5 (1997).
M. Freunek, Untersuchung der Thermoelektrik zur Energieversorgung autarker Systeme (Tönning: Der andere Verlag, 2010).
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Moser, A., Erd, M., Kostic, M. et al. Thermoelectric Energy Harvesting from Transient Ambient Temperature Gradients. J. Electron. Mater. 41, 1653–1661 (2012). https://doi.org/10.1007/s11664-011-1894-4
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11664-011-1894-4