Mg2Si thermoelectric (TE) elements and modules were fabricated using a commercial polycrystalline Mg2Si source. A monobloc plasma-activated sintering technique was used to fabricate the TE elements and Ni electrodes. The TE modules were composed of n-type Mg2Si, using pin–fin structure elements, in order to achieve simple assembly and to realize stable operation at a temperature of ~800 K. The dimensions of each pin–fin element were 4.2 mm × 4.2 mm × 9.8 mm, and the TE module comprised nine pin–fin elements connected in series. The output characteristics of the pin–fin elements and the TE module were evaluated at temperature differences, ΔT, ranging from 100 K to 500 K. The observed values of open-circuit voltage (V OC) and output power (P) of a single pin–fin element were 98.7 mV and 50.9 mW, respectively, at the maximum ΔT of 500 K. The maximum V OC and P values for the TE module were 588 mV and 174.3 mW, respectively, at ΔT = 500 K.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
The 4th Assessment Report of the Intergovernmental Panel on Climate Change (IPCC), 2007.
T.M. Tritt and M.A. Subramanian, MRS Bull. 31, 188 (2006).
G.S. Nolas, J. Sharp, and H.J. Goldsmid, Thermoelectrics (Berlin: Springer, 2001), p. 146.
R.G. Morris, R.D. Redin, and G.C. Danielson, Phys. Rev. 109, 1909 (1958).
V.E. Borisenko, Semiconducting Silicides (Berlin: Springer, 2000), p. 285.
Y. Noda, H. Kon, Y. Furukawa, N. Otsuka, I.A. Nishida, and K. Masumoto, Mater. Trans. JIM 33, 845 (1992).
Y. Noda, H. Kon, Y. Furukawa, N. Otsuka, I.A. Nishida, and K. Masumoto, Mater. Trans. JIM 33, 851 (1992).
M. Fukano, T. Iida, K. Makino, M. Akasaka, Y. Oguni, and Y. Takanashi, Crystal Growth of Mg 2 Si by the Vertical Bridgman Method and the Doping Effect of Bi and Al on Thermoelectric Characteristics, ed. T.P. Hogan, J. Yang, R. Funahashi, and T.M. Tritt (Mater. Res. Soc. Symp. Proc. 1044, 2008), pp. 247–252.
M.W. Heller and G.C. Danielson, J. Phys. Chem. Solids 23, 601 (1962).
S. Bose, H.N. Acharya, and H.D. Banerjee, J. Mater. Sci. 28, 5461 (1993).
M. Akasaka, T. Iida, T. Nemoto, J. Soga, J. Sato, K. Makino, M. Fukano, and Y. Takanashi, J. Cryst. Growth 304, 196 (2007).
M. Akasaka, T. Iida, A. Matsumoto, K. Yamanaka, Y. Takanashi, T. Imai, and N. Hamada, J. Appl. Phys. 104, 013703 (2008).
J. Tani and H. Kido, Physica B364, 218 (2005).
J. Tani and H. Kido, J. Alloys Compd 466, 335 (2008).
S. Lemonnier, C. Goupil, J. Noudem, and E. Guilmeau, J. Appl. Phys. 104, 014505 (2008).
Y. Oguni, T. Iida, A. Matsumoto, T. Nemoto, J. Onosaka1, H. Takaniwa, T. Sakamoto, D. Mori1, M. Akasaka, J. Sato, T. Nakajima, K. Nishio, and Y. Takanashi, Formation of Transition-Metal-Based Ohmic Contacts to n-Mg 2 Si by Plasma Activated Sintering, ed. T.P. Hogan, J. Yang, R. Funahashi, and T.M. Tritt (Mater. Res. Soc. Symp. Proc. 1044, 2008), pp. 413–418.
Acknowledgements
This work was partly supported by a Grant-in-Aid for Research (B) by the Japanese Ministry of Education, Science, Sports, and Culture.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Nemoto, T., Iida, T., Sato, J. et al. Characteristics of a Pin–Fin Structure Thermoelectric Uni-Leg Device Using a Commercial n-Type Mg2Si Source. J. Electron. Mater. 39, 1572–1578 (2010). https://doi.org/10.1007/s11664-010-1277-2
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11664-010-1277-2