Abstract
The appearance of denuded zones following low stress creep in particle-containing crystalline materials is both a microstructural prediction and observation often cited as irrefutable evidence for the Nabarro-Herring (N-H) mechanism of diffusional creep. The denuded zones are predicted to be at grain boundaries that are orthogonal to the direction of the applied stress. Furthermore, their dimensions should account for the accumulated plastic flow.
In the present article, the evidence for such denuded zones is critically examined. These zones have been observed during creep of magnesium, aluminum, and nickel-base alloys. The investigation casts serious doubts on the apparently compelling evidence for the link between denuded zones and diffusional creep. Specifically, denuded zones are clearly observed under conditions that are explicitly not diffusional creep. Additionally, the denuded zones are often found in directions that are not orthogonal to the applied stress.
Other mechanisms that can account for the observations of denuded zones are discussed. It is proposed that grain boundary sliding accommodated by slip is the rate-controlling process in the stress range where denuded zones have been observed. It is likely that the denuded zones are created by dissolution of precipitates at grain boundaries that are simultaneously sliding and migrating during creep.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
O.D. Sherby and P.M. Burke: Progr. Mater. Sci., 1967, vol. 13, p. 325.
W.D. Cao, X.-P. Lu, A.F. Sprecher, and H. Conrad: in Superplasticity in Aerospace II, T.R. McNelley and H.C. Heikennen, eds., TMS, Warrendale, PA, 1990, p. 269.
B. Burton: in Diffusional Creep of Polycrystalline Materials, Trans Tech Pub, Aedermannsdorf, Switzerland, 1977.
J.P. Poirer: Creep of Crystals, Cambridge University Press, Cambridge, United Kingdom, 1985.
J. Wolfenstine, O.A. Ruano, J. Wadsworth, and O.D. Sherby: Scripta Metall. Mater., 1993, vol. 29, p. 515.
O.A. Ruano, O.D. Sherby, J. Wadsworth, and J. Wolfenstine: Scripta Mater., 1998, vol. 38, p. 1307.
J. Wadsworth, O.A. Ruano, and O.D. Sherby: in Creep Behavior of Advanced Materials for the 21st Century, R.S. Mishra, A.K. Mukherjee, and K.L. Murty, eds., TMS, Warrendale, PA, 1999, pp. 425–39.
F.R.N. Nabarro: in Creep Behavior of Advanced Materials for the 21st Century, R.S. Mishra, A.K. Mukherjee, and K.L. Murty, eds., TMS, Warrendale, PA, 1999, pp. 391–95.
P. Greenfield, C.C. Smith, and A.M. Taylor: Trans. AIME, 1961, vol. 221, p. 1065.
R.L. Squires, R.T. Weiner, and M. Philips: J. Nucl. Mater., 1963, vol. 8, p. 77.
V.J. Haddrell: J. Nucl. Mater., 1966, vol. 18, p. 231.
W. Vickers and P. Greenfield: J. Nucl. Mater., 1967, vol. 24, p. 249.
B.W. Pickles: J. Inst. Met., 1967, vol. 95, p. 333.
Walter A. Backofen, Francis J. Azzarto, G.S. Murty, and Stanley W. Zehr: in Ductility, ASM Seminar, Oct. 14–15, 1967, ASM, Metals Park, OH, 1967, pp. 279–310.
A. Karim, D.L. Holt, and W.A. Backofen: Trans. AIME, 1969, vol. 245, p. 2421.
A. Karim, D.L. Holt, and W.A. Backofen: Trans. AIME, 1969, vol. 245, p. 1131.
A. Karim: in Ultrafine-Grain Metals, J.J. Burke and V. Weiss, eds., Syracuse University Press, Syracuse, NY, 1970, p. 295.
K.R. McNee: Ph.D. Dissertation, Sheffield University, Sheffield, United Kingdom, 2000.
F.R.N. Nabarro: Report of a Conference on the Strength of Solids (Bristol), The Physical Society, London, 1948, pp. 75–90.
C. Herring: J. Appl. Phys., 1950, vol. 21, p. 437.
L.E. Raraty: J. Nucl. Mater., 1966, vol. 20, p. 344.
J.E. Harris and R.B. Jones: CEGB Report No. RD/B/R. 144, Berkeley Laboratories, Berkeley, England, July 1963.
J.E. Harris and R.B. Jones: J. Nucl. Mater., 1963, vol. 10, p. 360.
J.E. Harris: Met. Sci. J., 1973, vol. 7, p. 1.
P. Greenfield and W. Vickers: J. Nucl. Mater., 1967, vol. 22, p. 77.
L.E. Raraty, R. Baggott, and E.G. Wilson: J. Inst. Met., 1964, vol. 93, p. 134.
J. Herenguel: Mater. Res., 1962, vol. 1, p. 65.
M.F. Ashby and I.G. Palmer: Acta Metall., 1967, vol. 15, p. 420.
F. Garofalo, W.F. Domis, and F. von Gemmingen: Trans. AIME, 1964, vol. 230, p. 1460.
T.H. Alden: Trans. ASM., 1968, vol. 61, p. 559.
S.A. Shei and T.G. Langdon: Acta Metall., 1978, vol. 26, p. 639.
T. Yamane, N. Genma, and Y. Takahashi: J. Mater. Sci., 1984, vol. 19, p. 263.
B. Burton: Scr. Metall., 1969, vol. 3, p. 247.
D.K. Matlock and W.D. Nix: Metall. Trans., 1974, vol. 5, pp. 961–63.
O.A. Ruano, A.K. Miller, and O.D. Sherby: Mater. Sci. Eng., 1981, vol. 51, p. 9.
O.A. Ruano, J. Wadsworth, and O.D. Sherby: Mater. Sci., 1985, vol. 20, p. 3735.
A. Ball and M.M. Hutchison: Met. Sci. J., 1969, vol. 3, p. 1.
T. Yamane, N. Genma, and Y. Takahashi: J. Mater. Sci., 1984, vol. 19, p. 3171.
R.C. Gifkins: Mater. Characterization, 1994, vol. 32, p. 59.
M.J. Mills, J.C. Gibeling, and W.D. Nix: Acta Metall., 1985, vol. 33, p. 1503.
O.D. Sherby and J. Wadsworth: Progr. Mater. Sci., 1989, vol. 33, p. 169.
J. Herenguel and P. Lelong: Rev. Metallurgie Paris, 1958, vol. 55, p. 1057.
J.D. Whittenberger: Metall. Trans., 1984, vol. 15A, pp. 1753–62.
B. Fazan, O.D. Sherby, and J.E. Dorn: Trans. AIME, 1954, vol. 200, p. 919.
T.B. Gibbons: Mater. Sci., 1972, vol. 6, p. 13.
J.D. Whittenberger: Metall. Trans. A, 1977, vol. 8A, pp. 1155–63.
J.D. Whittenberger: Metall. Trans. A, 1977, vol. 8A, pp. 1863–70.
R. Timmins and E. Artz: Scripta Metall., 1988, vol. 22, p. 1353.
J.A. Wert and A. Varloteaux: in Aluminum Alloys: Their Physical and Mechanical Properties, E.A. Starke and T.H. Sanders, eds., EMAS, Warley, United Kingdom, 1986, vol. II, pp. 1255–67.
Ursula Koch: in Superplasticity in Aerospace, H.C. Heikkenen and T.R. McNelley, eds., TMS, Warrendale, PA, 1988, pp. 115–32.
D.H. Shin, K.S. Kim, D.W. Kum, and S.W. Nam: Metall. Trans. A, 1990, vol. 21A, pp. 2729–37.
C.H. Hamilton, C.C. Bampton, and N.E. Paton: in Superplastic Forming of Structural Alloys, N.E. Paton and C.H. Hamilton, eds., TMS-AIME, Warrendale, PA, 1982, pp. 173–89.
J.M. Belzunce: Engineer’s Dissertation, Stanford University, Stanford, CA, 1983.
M.K. Rao and A.K. Mukherjee: Mater. Sci. Eng., 1986, vol. 80, p. 181.
H.E. Addabo, G. Gonzalez-Doncel, O.A. Ruano, J.M. Belzunce, and O.D. Sherby: J. Mater. Res., 1989, vol. 4, p. 587.
M.G. Zelin: J. Mater. Sci., 1997, vol. 32, p. 1075.
W. Bang, T.K. Ha, and Y.W. Chang: in Superplasticity in Advanced Materials, Materials Science Forum, Namas Chandra, ed., Trans. Tech. Publications, Switzerland, 2001, vols. 357–359, pp. 171–76.
C.R. Barrett, J.L. Lytton, and O.D. Sherby: Trans. AIME, 1967, vol. 239, p. 170.
C.L. Meyers Jr., J.C. Shyne, and O.D. Sherby: J. Aus. Inst. Met., 1963, vol. 8, p. 171.
J. Lin and O.D. Sherby: Res. Mechanica, 1981, vol. 2, p. 251.
R.D. Kane and L.J. Ebert: Metall. Trans. A, 1976, vol. 7A, pp. 133–37.
R.W. Lund and W.D. Nix: Acta Metall., 1976, vol. 24, p. 469.
J.J. Stephens and W.D. Nix: Metall. Trans. A, 1985, vol. 16A, pp. 1307–24.
O.D. Sherby and E.M. Taleff: Mater. Sci. Eng. A, 2001, in press.
T.G. Langdon: Scripta Mater., 1996, vol. 35, p. 733.
G.W. Greenwood: in Creep Behavior of Advanced Materials for the 21st Century, R.S. Mishra, A.K. Mukherjee, and K.L. Murty, eds., TMS, Warrendale, PA, 1999, pp. 413–24.
K.R. McNee, G.W. Greenwood, and H. Jones: Scripta Mater., 2001, vol. 44, p. 351.
Author information
Authors and Affiliations
Additional information
This article is based on a presentation made in the workshop entitled “Mechanisms of Elevated Temperature Plasticity and Fracture,” which was held June 27–29, 2001, in Dan Diego, CA, concurrent with the 2001 Joint Applied Mechanics and Materials Summer Conference. The workshop was sponsored by Basic Energy Sciences of the United States Department of Energy.
Rights and permissions
About this article
Cite this article
Wadsworth, J., Ruano, O.A. & Sherby, O.D. Denuded zones, diffusional creep, and grain boundary sliding. Metall Mater Trans A 33, 219–229 (2002). https://doi.org/10.1007/s11661-002-0084-7
Issue Date:
DOI: https://doi.org/10.1007/s11661-002-0084-7