Abstract
In this work, an experimental study of melting heat transfer of nano-enhanced phase change materials (NePCM) in a differentially-heated rectangular cavity was performed. Two height-to-width aspect ratios of the cavity, i.e., 0.9 and 1.5, were investigated. The model NePCM samples were prepared by dispersing graphene nanoplatelets (GNP) into 1-tetradecanol, having a nominal melting point of 37°C, at loadings up to 3 wt.%. The viscosity was found to have a more than 10-fold increase at the highest loading of GNP. During the melting experiments, the wall superheat at the heating boundary was set to be 10°C or 30°C. It was shown that with increasing the loading of GNP, both the heat storage and heat transfer rates during melting decelerate to some extent, at all geometrical and thermal configurations. This suggested that the use of NePCM in such cavity may not be able to enhance the heat storage rate due to the dramatic growth in viscosity, which deteriorates significantly natural convective heat transfer during melting to overweigh the enhanced heat conduction by only a decent increase in thermal conductivity. This also suggested that the numerically predicted melting accelerations and heat transfer enhancements, as a result of the increased thermal conductivity, in the literature are likely overestimated because the negative effects due to viscosity growth are underestimated.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Zalba B., Marı́n J.M., Cabeza L.F., Mehling H., Review on thermal energy storage with phase change: materials, heat transfer analysis and applications. Applied Thermal Engineering, 2003, 23(3): 251–283.
Fukusako S., Yamada M., Melting heat transfer inside ducts and over external bodies. Experimental Thermal and Fluid Science, 1999, 19(2): 93–117.
Dhaidan N.S., Khodadadi J.M., Melting and convection of phase change materials in different shape containers: A review. Renewable and Sustainable Energy Reviews, 2015, 43: 449–477.
Krishna J., Kishore P.S., Solomon A.B., Heat pipe with nano enhanced-PCM for electronic cooling application. Experimental Thermal and Fluid Science, 2017, 81: 84–92.
Vyshak N.R., Jilani G., Numerical analysis of latent heat thermal energy storage system. Energy Conversion and Management, 2007, 48(7): 2161–2168.
Zhou J., Chen Z., Liu D., Li J., Experimental study on melting in a rectangular enclosure heated below with discrete heat sources. Journal of Thermal Science, 2001, 10(3): 254–259.
Beckermann C., Viskanta R., Effect of solid subcooling on natural convection melting of a pure metal. ASME Journal of Heat Transfer, 1989, 111(2): 416–424.
Fan L.W., Khodadadi J.M., Thermal conductivity enhancement of phase change materials for thermal energy storage: A review. Renewable and Sustainable Energy Reviews, 2011 15(1): 24–46.
Khodadadi J.M., Fan L.W., Babaei H., Thermal conductivity enhancement of nanostructure-based colloidal suspensions utilized as phase change materials for thermal energy storage: a review. Renewable and Sustainable Energy Reviews, 2013, 24: 418–444.
Rao S.S., Srivastava A., Whole field measurements to understand the effect of nanoparticle concentration on heat transfer rates in a differentially-heated fluid layer. Experimental Thermal and Fluid Science, 2018, 92: 326–345.
Arasu A.V., Mujumdar A.S., Numerical study on melting of paraffin wax with Al2O3 in a square enclosure. International Communications in Heat and Mass Transfer, 2012, 39(1): 8–16.
Elbahjaoui R., El Qarnia H., El Ganaoui M., Melting of nanoparticle-enhanced phase change material inside an enclosure heated by laminar heat transfer fluid flow. The European Physical Journal Applied Physics, 2016, 74(2): 24616.
Dhaidan N.S., Khodadadi J.M., Al-Hattab T.A., Al-Mashat S.M., Experimental and numerical investigation of melting of phase change material/ nanoparticle suspensions in a square container subjected to a constant heat flux. International Journal of Heat and Mass Transfer, 2013, 66: 672–683.
Feng Y., Li H., Li L., Bu L., Wang T., Numerical investigation on the melting of nanoparticle-enhanced phase change materials (NEPCM) in a bottom-heated rectangular cavity using lattice Boltzmann method. International Journal of Heat and Mass Transfer, 2015, 81: 415–425.
Ho C.J., Gao J.Y., An experimental study on melting heat transfer of paraffin dispersed with Al2O3 nanoparticles in a vertical enclosure. International Journal of Heat and Mass Transfer, 2013, 62: 2–8.
Ho C.J., Gao J.Y., Preparation and thermophysical properties of nanoparticle-in-paraffin emulsion as phase change material. International Communications in Heat and Mass Transfer, 2009, 36(5): 467–470.
Yu Z.T., Fang X., Fan L.W., Wang X., Xiao Y. Q., Zeng Y., Increased thermal conductivity of liquid paraffin-based suspensions in the presence of carbon nano-additives of various sizes and shapes. Carbon, 2013, 53: 277–285.
Fan L.W., Zhu Z.Q., Zeng Y., Ding Q., Liu M.J., Unconstrained melting heat transfer in a spherical container revisited in the presence of nano-enhanced phase change materials (NePCM). International Journal of Heat and Mass Transfer, 2016, 95: 1057–1069.
Hu N., Zhu Z.Q., Li Z.R., Tu J., Fan L.W., Close-contact melting heat transfer on a heated horizontal plate: revisited in the presence of nano-enhanced phase change materials (NePCM). International Journal of Heat and Mass Transfer, 2018, 124: 794–799.
Zeng Y., Fan L.W., Xiao Y.Q., Yu Z.T., Cen K.F., An experimental investigation of melting of nanoparticleenhanced phase change materials (NePCMs) in a bottom-heated vertical cylindrical cavity. International Journal of Heat and Mass Transfer, 2013, 66: 111–117.
Fan L.W., Zhu Z.Q., Zeng Y., Lu Q., Yu Z.T., Heat transfer during melting of graphene-based composite phase change materials heated from below. International Journal of Heat and Mass Transfer, 2014, 79: 94–104.
Acknowledgments
This material is based upon work supported by the Zhejiang Provincial Natural Science Foundation of China under Grant No. LR17E060001. FAN Liwu would like to thank a start-up fund granted by the “100 Talents Program” of Zhejiang University.
Author information
Authors and Affiliations
Corresponding authors
Rights and permissions
About this article
Cite this article
Li, Z., Hu, N., Tu, J. et al. Experimental Investigation of Heat Storage and Heat Transfer Rates during Melting of Nano-Enhanced Phase Change Materials (NePCM) in a Differentially-Heated Rectangular Cavity. J. Therm. Sci. 29, 503–511 (2020). https://doi.org/10.1007/s11630-020-1225-2
Received:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11630-020-1225-2