Abstract
In situ stress state becomes more and more significant with in-depth research on geodynamics and energy development. However, there has not been an economic and effective method developed to determine deep three-dimensional in situ stress. The Anelastic Strain Recovery (ASR) method is a newly developed technique that can determine three-dimensional in situ stresses. After the 12 May 2008 M s8.0 Wenchuan earthquake, the ASR method was used for the first time in mainland China to measure the in situ stresses in the WFSD scientific boreholes in Sichuan Province, China. In this paper, the basic procedure of the ASR method is introduced in detail and the compliances of ASR for boring cores are investigated. The results show that the maximum principal stress direction was NW64° at a measured depth (MD) of 1173 m (vertical depth 1151 m) in WFSD-1. The ratio of shear mode to the volume mode compliance of ASR was 2.9. And the three principal stresses at 1173 m MD in WFSD-1 are 43, 28 and 25 MPa. Combined with stress measurement results determined using other in situ measurement methods along the Longmenshan fault zone, the directions of the maximum horizontal principal stress changes from E-W to NEE-SWW to NWW-SEE when moving from NE to SW along the Longmenshan fault zone. This change is in agreement with the stress regime of the Longmenshan fault zone of the Wenchuan Earthquake, which supports a stress regime consisting predominantly of thrusts in the southwest and strike-slip in the northeast.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
An Q M, Ding L F, Wang H Z, et al. 2004. Research of property and activity of Longmen Mountain fault zone (in Chinese). Crustal Deform Earthq, 24: 115–119
Bohnhoff M, Baisch S, Harjes H P. 2004. Fault mechanisms of induced seismicity at the super deep German Continental Deep Drilling Program (KTB) borehole and their relation to fault structure and stress field. J Geophy Res, 109: B02309, doi: 10.1029/2003JB002528
Brereton N R, Chroston P N, Evans C J. 1995. Pore pressure as an explanation of complex anelastic strain recovery results. Rock Mech Rock Eng, 28: 59–66
Brown E T, Hoek E. 1978. Trends in relationships between measured rock in situ stresses and depth. Int J Rock Mech Min Sci Geomech Abstr, 15: 211–215
Byrne T B, Lin W, Tsutsumi A, et al. 2009. Anelastic strain recovery reveals extension across SW Japan subduction zone. Geophys Res Lett, 36: L23310, doi: 10.1029/2009GL040749
Chang C, McNeill L C, Moore J C, et al. 2010. In situ stress state in the Nankai accretionary wedge estimated from borehole wall failures. Geochem Geophys Geosyst, 11: Q0AD04, doi: 10.1029/2010GC003261
Chen Q C, Feng C J, Meng W, et al. 2012. Analysis of in situ stress measurements at the northeastern section of the Longmenshan fault zone after the 5·12 Wenchuan earthquake (in Chinese). Chin J Geophys, 55: 3923–3932
Chen Y. 1988. Mechanical Properties of Crest Rock: Theoretical Foundation and Experimental Methods (in Chinese). Beijing: Seismological Press. 279
Chen Y. 2009. Is the Wenchuan Earthquake induced by Zipingpu reservoir? Sci China Ser D-Earth Sci, 52: 431–433
Chester F M, Mori J J, Toczko S, et al. 2012. Japan Trench Fast Drilling Project (JFAST). IODP Prel Rept, 343/343T. doi: 10.2204/iodp.pr. 343343T.2012
Cui X F, Hu X P, Yu C Q, et al. 2011. Research on focal mechanism solutions of Wenchuan earthquake sequence (in Chinese). Acta Sci Nat Univer Pek, 47: 1063–1072
Dey T N, Kranz R L. 1988. State of stress and relationship of mechanical properties to hydrothermal alteration at Valles Caldera Core Hole 1, New Mexico. J Geophy Res, 93: 6108–6112
Du Y, Xie F R, Zhang X L, et al. 2009. The mechanics of fault slip of M s8.0 Wenchuan earthquake (in Chinese). Chin J Geophys, 52: 464–473
Engelder T. 1984. The time-dependent strain relaxation of Algerie granite. Int J Rock Mech Min Sci Geomech Abstr, 21: 63–73
Feng C J, Chen Q C, Tan C X, et al. 2013. A preliminary study of the influence of Wenchuan Ms8.0 earthquake on in situ stress state near longmenshan fault zone: A case study in Beichuan and Jiangyou areas (in Chinese). Acta Seis Sin, 35: 137–150
Hardebeck J L. 2004. Stress triggering and earthquake probability estimates. J Geophys Res, 109: B04310, doi: 10.1029/2003JB002437
Hickman S, Zoback M. 2004. Stress orientations and magnitudes in the SAFOD pilot hole. Geophy Res Lett, 31: L15S12, doi: 10.1029/2004GL020043
Hu X P, Yu C Q, Tao K, et al. 2008. Focal mechanism solutions of Wenchuan earthquake and its strong aftershocks obtained from initial P wave polarity analysis. Chin J Geophys, 51: 1711–1718
Hung J H, Ma K F, Wang C Y, et al. 2009. Subsurface structure, physical properties, fault zone characteristics and stress state in the scientific drill holes of Taiwan Chelungpu Fault Drilling Project. Tectonophysics, 466: 307–321
Jaeger J C, Cook N G W. 1981. Fundamentals of Rock Mechanics. Institute of Engineering Mechanics, Chinese Academy of Sciences (Translated). Beijing: Seismological Press. 382–397
Li H, Wang H, Xu Z, et al. 2012. Characteristics of the fault-related rocks, fault zones and the principal slip zone in the Wenchuan Earthquake Fault Scientific Drilling Project Hole-1 (WFSD-1). Tectonophysics, doi: dx.doi.org/10.1016/j.tecto.2012.08.021
Lin W, Doan M L, Moore J C, et al. 2010. Present-day principal horizontal stress orientations in the Kumano forearc basin of the southwest Japan subduction zone determined from IODP NanTroSEIZE drilling Site C0009. Geophys Res Lett, 37: L13303, doi: 10.1029/2010GL043158
Lin W, Kwasniewski M, Imamura T, et al. 2006. Determination of three-dimensional in situ stresses from anelastic strain recovery measurement of cores at great depth. Tectonophysics, 426: 221–238
Lin W, Saito S, Yamamoto Y, et al. 2011. Principal horizontal stress orientations prior to the 2011 Mw9.0 Tohoku-Oki, Japan, earthquake in its source area. Geophy Res Lett, 38: L00G10, doi: 10.1029/2011GL049097
Lin W, Yeh E C, Ito H, et al. 2007a. Current stress state and principal stress rotations in the vicinity of the Chelungpu Fault induced by the 1999 Chi-Chi, Taiwan, Earthquake. Geophys Res Lett, 34: L16307, doi: 10.1029/2007GL030515
Lin W, Yeh E, Ito H, et al. 2007b. Preliminary results of stress measurement by using drill cores of TCDP Hole-A: An application of anelastic strain recovery method to three-dimensional in situ stress determination. Ter Atmos Ocea Sci, 18: 379–393
Lin W. 2008. A core-based method to determined three-dimensional in situ stress in deep drilling wells: anelastic strain recovery technique. Chin J Rock Mech Eng, 27: 2387–2394
Liu J, Xiong T Y, Zhao Y, et al. 2012. Kinematic characteristics of Longmenshan active fault zone and its tectonic implication. J Jilin Univer (Earth Sci Ed), 42(Suppl): 320–330
Ma Z J, Jiang M. 1987. Strong earthquake periods and episodes in China. Earthq Res China, 3: 47–51
Matsuki K, Takeuchi K. 1993. Three-dimensional in situ stress determination by anelastic strain recovery of a rock core. Int J Rock Mech Min Sci Geomech Abstr, 30: 1019–1022
Matsuki K. 1991. Three-dimensional in Situ stress measurement with anelastic strain recovery of a rock core. In: Wittke W, ed. Proc 7th Int Congr Rock Mech. Aachen. 557–560
Matsuki K. 2008. Anelastic strain recovery compliance of rocks and its application to in situ stress measurement. Int J Rock Mech Min Sci, 45: 952–965
Peng H, Ma X M, Jiang J J. 2011. In situ stress measurement by differential strain analysis method in WFSD-1 (in Chinese). J Geomechan, 17: 249–261
Perreau P J, Heugas O, Santarelli F J. 1989. Tests of ASR, DSCA, and core discing analyses to evaluate in situ stresses. SPE paper 17960 SPE Middle East Oil Technical Conference and Exhibition Manama, Bahrain. 325–336
Shi Y L, Cao J L. 2010. Some aspects in static stress change calculation-case study on Wenchuan earthquake. Chin J Geophys, 53: 102–110
Stein R S. 1999. The role of stress transfer in earthquake occurrence. Nature, 402: 605–609
Sun D S, Wang L J, Wang H C, et al. 2013. Analysis of the Wenchuan M s8.0 earthquake co-seismic stress and displacement change by using the finite element method. Acta Geol Sin, 87: 1120–1128
Voight B. 1968. Determination of the virgin state of stress in the vicinity of a borehole from measurements of a partial anelastic strain tensor in drill cores. Felsmechanik und Ingenieurgeologie, 6: 201–215
Wang L J, Sun D S, Lin W R, et al. 2012. Anelastic strain recovery method to determine in situ stress and application example. Chin J Geophys, 55: 1674–1681
Warpinski N R, Teufel L W. 1989. In situ stresses in low permeability, nonmarine rocks. J Pet Tech, 41: 405–414
Wolter K E, Berckhemer H. 1989. Time dependent strain recovery of cores from the KTB-Deep drill hole. Rock Mech Rock Eng, 22: 273–287
Wu H Y, Ma K F, Zoback M, et al. 2007. Stress orientations of Taiwan Chelungpu-Fault Drilling Project (TCDP) hole-A as observed from geophysical logs. Geophy Res Lett, 34: L01303, doi: 10.1029/2006GL028050
Wu M L, Zhang Y Q, Liao C T, et al. 2009. Preliminary results of in situ stress measurements along the Longmenshan Fault Zone after the Wenchuan M s8.0 eratherquare. Acta Geol Sin, 83: 746–753
Xie F R, Cui X F, Zhao J T, et al. 2004. Regional division of the recent tectonic stress field in China and adjacent areas (in Chinese). Chin J Geophys, 47: 654–662
Yamashita F, Fukuyama E, Omura K. 2004. Estimation of fault strength: Reconstruction of stress before the 1995 Kobe earthquake. Science, 306: 261–263
Yin X H. 1985. Solid Mechanics (in Chinese). Beijing: Earthquake Press. 512
Zang A, Stephansson O. 2010. Stress Field of the Earth’s Crust. London: Springer. 115–193
Zhang B, Shi Y L. 2010. A discussion on the influences of Zipingpu reservoir on the stability of faults in the neighborhood. J Graduate School Chin Acad Sci, 27: 755–762
Zhang G M. 1987. Rhythmic characteristics of high seismic activity in China mainland. Seismol Geol, 9: 27–38
Zheng Y, Ma H S, Lŭ J, et al. 2009. Source mechanism of strong aftershocks (M s⩾5.6) of the 2008/05/12 Wenchuan earthquake and the implication for seismotectonics. Sci China Ser D-Earth Sci, 52: 739–753
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Sun, D., Lin, W., Cui, J. et al. Three-dimensional in situ stress determination by anelastic strain recovery and its application at the Wenchuan Earthquake Fault Scientific Drilling Hole-1 (WFSD-1). Sci. China Earth Sci. 57, 1212–1220 (2014). https://doi.org/10.1007/s11430-013-4739-6
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11430-013-4739-6