Abstract
The effect of heterogeneities on miscible and immiscible flood displacements in 2D bead packs in quadrant form, 2 × 2 block heterogeneity, with either a permeability or a wettability contrast is the subject of this paper. The physical processes occurring during miscible and immiscible flow and displacement within permeability and wettability quadrant bead pack models have been studied experimentally. This geometry occurs in a number of situations relevant to hydrocarbon production: particularly faults where adjacent rocks have large permeability contrasts with rapid changes, in the laboratory with core butting, in reservoir simulation where grid blocks have different permeability and in reservoirs having near-wellbore damage problems. The model quadrants 1–4, had 1 and 4 and 2 and 3 with identical properties, either in permeability or wettability. Reported are complete unit mobility miscible displacements, then the effects of viscosity differences (mobility modifiers) and finally immiscible displacements on displacement patterns for initial linear injection. The experiments demonstrate that nodal flow occurs for both miscible and immiscible flow, but for immiscible flow there are boundary effects due to capillary pressure differences created by water saturation changes or wettability contrasts which can leave patches of isolated fluid within a quadrant. The displacement patterns for the different models and fluids change significantly with the viscosity and wettability changes, particularly for the immiscible displacements. This is due to the changing capillary pressure between the quadrant blocks as the water saturation change. These are difficult to address in numerical modelling but should be accounted for. Other effects include coupling of all physical processes governing the flow through the node and creations of microzones of trapped residual oil. Our displacement patterns can therefore be a valuable verification benchmark tool for numerical modelling and a calibration data source for those wishing to simulate the effects of capillary pressure under differing wettability conditions and for those investigating upscaling modelling procedures. However, the possible loss of physical reality when averaging must always be considered.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
References
Cardwell W.T. and Parsons R.L. (1945). Averaging permeabilities of heterogeneous oil sands. Trans. AIME 160: 34–37
Caruana, A.: Immiscible flow behaviour in the presence of heterogeneous porous media. PhD thesis, University of London (Imperial College) (1997)
Caruana A. and Dawe R.A. (1996a). Flow behaviour in the presence of wettability heterogeneities. Transport Porous Med. 25: 217–233
Caruana A. and Dawe R.A. (1996b). Effect of heterogeneities on miscible and immiscible flow processes in porous media. Trends Chem. Eng. 3: 185–203
Chevalier L.R. and Petersen J. (1999). Literature review of 2-D laboratory experiments in NAPL flow, transport and remediation. J. Soil Contam. 8(1): 149–167
Dawe R.A. and Grattoni C.A. (1998). The visualisation of the pore-scale physics of hydrocarbon recovery from reservoirs. First Break 16: 371–386
Evans R.N. and Dawe R.A. (1994). The danger of neglecting nodal crossflow in heterogeneous near-wellbore conditions. J. Petrol. Sci. Eng. 11: 113–121
King P.R. (1996). Upscaling permeability: error analysis for renormalization. Transport Porous Med. 23: 337–354
Lambeth N. and Dawe R.A. (1987). Viscous effects for miscible displacements in regular heterogeneous porous media. Chem. Eng. Res. Des. 65: 52–62
Lambeth N. and Dawe R.A. (1988). Boundary and crossflow behaviour during displacement in nodal systems, SPE Paper 16972. SPE Reservoir Eng. 3: 1137–1142
Laroche C., Vizika O. and Kalaydjian F. (1999). Network modelling as a tool to predict three-phase gas injection in heterogeneous wettability porous media. J. Petrol. Sci. Eng. 24(2–4): 155–168
Lu H. and Bao K.D. (1992). Effective conductivity in a checkerboard geometry at high conductance ratio and high concentration. Phys. Rev. B 46: 9209–9212
Muggeridge, A.H., Jackson, M.D., Agbehi, O., Al-Shuraiqi, H., Grattoni, C.A.: Quantifying bypassed oil in the vicinity of discontinuous shales during gravity dominated flow. SPE 90402, SPE Annual Technical Conference and Exhibition, Houston, Texas, 26–29 September (2004)
Renard P. and de Marsily G. (1997). Calculating equivalent permeability: a review. Adv. Water Resour. 20: 253–278
Roti ø and Dawe R.A. (1993). Modelling fluid flow in crossbedded sections. Transport Porous Med. 12: 143–159
Shaw D.C. and Dawe R.A. (1985). Perturbation theory for a displacement front passing discontinuities in capillary pressure and permeability in a porous medium. Mathematika 32: 75–89
Shaw D.C. and Dawe R.A. (1987). Averaging methods for numerical simulations of flows through heterogeneous porous media. Transport Porous Med. 2: 241–268
Stern D. (2005). Practical aspects of scaleup of simulation models. J. Petrol. Technol. 57(9): 74–82
Yeo I.W. and Zimmerman R.W. (2001). Accuracy of the renormalization method for computing effective conductivities of heterogeneous media. Transport Porous Med. 45: 129–138
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Dawe, R.A., Grattoni, C.A. Experimental displacement patterns in a 2 × 2 quadrant block with permeability and wettability heterogeneities—problems for numerical modelling. Transp Porous Med 71, 5–22 (2008). https://doi.org/10.1007/s11242-007-9108-5
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s11242-007-9108-5