Abstract.
Significant unproductive and costly waiting occurs during AGV (Automated Guided Vehicle) use, both under the CC (Container Crane) and in the blocks compared to that of a manual yard tractor. A possible solution to this problem is that, in the design of ACT (Automated Container Terminals), ALV (Automated Lifting Vehicles), which can load and unload their own containers, be considered as an alternative. In this paper, the objective is to analyze how increases in the use of ALVs rather than AGVs affects the productivity of ACTs. We derived four inferences regarding the cycle time of vehicles and verified their validity in a simulation. A simulation model of an ACT with perpendicular layout was developed and is described in this paper. From the results of the simulation analysis, we determined the savings effect by cycle time and the required number of vehicles. We demonstrated that the ALV is superior to the AGV in both productivity and efficiency principally because the ALV eliminates the waiting time in the buffer zone.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Corresponding author
Additional information
Correspondence to: Yong Seok Choi:
Rights and permissions
About this article
Cite this article
Yang, C.H., Choi, Y.S. & Ha, T.Y. Simulation-based performance evaluation of transport vehicles at automated container terminals. OR Spectrum 26, 149–170 (2004). https://doi.org/10.1007/s00291-003-0151-5
Issue Date:
DOI: https://doi.org/10.1007/s00291-003-0151-5