Abstract
The suitability of polyethylene sheets as passive samplers of lipophilic contaminants in water bodies was tested. High-density polyethylene (HDPE) and low-density polyethylene (LDPE) sheets were contaminated with PAH. Uncontaminated and pre-contaminated sheets were deployed simultaneously and collected at intervals over 32 days. The exposed sheets and water samples were analyzed for PAH. The initial PAH concentrations in the contaminated and uncontaminated sheets differed by two to three orders of magnitude, but approached a common equilibrium concentration during exposure. The two- to four-ring PAH achieved quasi-equilibrium within the 32-day exposure period, whereas the five- and six-ring PAH did not. The estimated PE/water partition coefficients were approximately three times higher for HDPE than for LDPE, and they were similar in magnitude to the KOW values (the partition coefficients between n-octanol and water). The uptake rate constants were approximately four times higher for HDPE than LDPE, which was attributed to the four times higher specific surface area. The uptake and elimination in HDPE followed linear first-order kinetics, whereas for LDPE very slow elimination rates were observed that could not be explained. The results show that PE is a simple, effective, and inexpensive material for sampling trace organic contaminants in water.
Article PDF
Similar content being viewed by others
Explore related subjects
Discover the latest articles, news and stories from top researchers in related subjects.Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Additional information
Electronic Publication
Rights and permissions
About this article
Cite this article
Müller, J.F., Manomanii, K., Mortimer, M.R. et al. Partitioning of polycyclic aromatic hydrocarbons in the polyethylene/water system. Fresenius J Anal Chem 371, 816–822 (2001). https://doi.org/10.1007/s002160101025
Received:
Revised:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1007/s002160101025