This paper present a new method for automatic form feature recognition from boundary representation of a solid model. The proposed method is called the edge boundary classification technique. This technique uses the geometry, topology, and spatial information of a solid model for feature recognition patterns. Some aspects of edge boundary classification are discussed for recognising non-intersecting and intersecting form features.
Article PDF
Similar content being viewed by others
Use our pre-submission checklist
Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Additional information
ID="A1" Correspondence and offprint requests to: Dr N. Ismail, Department of Mechanical and Manufacturing Engineering, Faculty of Engineering, University Putra Malaysia, 4300UPM, Serdang, Malaysia. E-mail: napsiah@eng.upm.edu.my
Rights and permissions
About this article
Cite this article
Ismail, N., Abu Bakar, N. & Juri, A. Feature Recognition Patterns for Form Features Using Boundary Representation Models. Int J Adv Manuf Technol 20, 553–556 (2002). https://doi.org/10.1007/s001700200190
Issue Date:
DOI: https://doi.org/10.1007/s001700200190