Pinus sylvestris
L.) at various angles to the grain. Results show that hardness is highly dependent on grain direction. The hardness value of a radial surface; i.e. when load is applied in tangential direction, is about half of the end–grain surface hardness. For angles between 0 and 90°, hardness measurements are well described by Hankinson's formula. The relation between hardness and density at each load direction has also been studied.
Pinus sylvestris
L.) unter verschiedenen Winkeln zur Faser gemessen. Die Ergebnisse zeigen, daß die Härte stark von der Faserrichtung abhängt. Die Härte in radialer Richtung, d.h. wenn die Last in tangentialer Richtung aufgebracht wird, beträgt nur etwa die Hälfte des Wertes, der an Hirnholz gemessen wird. Für Winkel zwischen 0 und 90° werden die Meßergebnisse gut durch die Hankinson-Formel wiedergegeben. Die Beziehung zwischen Härte und Dichte für jede Lastrichtung wurde ebenfalls untersucht.
Article PDF
Similar content being viewed by others
Avoid common mistakes on your manuscript.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Holmberg, H. Influence of grain angle on Brinell hardness of Scots pine (Pinus sylvestris L.). Holz als Roh- und Werkstoff 58, 91–95 (2000). https://doi.org/10.1007/s001070050392
Issue Date:
DOI: https://doi.org/10.1007/s001070050392